- 您现在的位置：买卖IC网 > PDF目录18758 > SX1212IWLTRT (Semtech)IC TXRX 300MHZ-510MHZ 32-TQFN PDF资料下载
参数资料
| 型号： | SX1212IWLTRT |
| 厂商： | Semtech |
| 文件页数： | 39/77页 |
| 文件大小： | 0K |
| 描述： | IC TXRX 300MHZ-510MHZ 32-TQFN |
| 标准包装： | 1 |
| 频率： | 300MHz ~ 510MHz |
| 数据传输率 - 最大： | 150kbps |
| 调制或协议： | FSK，OOK |
| 应用： | AMR，ISM，家庭自动化，程序控制 |
| 功率 - 输出： | 12.5dBm |
| 灵敏度： | -110dBm |
| 电源电压： | 2.1 V ~ 3.6 V |
| 电流 - 接收： | 3mA |
| 电流 - 传输： | 25mA |
| 数据接口： | PCB，表面贴装 |
| 天线连接器： | PCB，表面贴装 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 32-TQFN |
| 包装： | 标准包装 |
| 产品目录页面： | 584 (CN2011-ZH PDF) |
| 其它名称： | SX1212IWLDKR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页当前第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页
SX1212
ADVANCED COMMUNICATIONS & SENSING
5.2.2.3. Interrupt Sources and Flags
All interrupt sources and flags are configured in the IRQParam section of the configuration register, with the
exception of Fifo_threshold :
/Fifoempty: /Fifoempty interrupt source is low when byte 0, i.e. whole FIFO, is empty. Otherwise it is high.
Write_byte: Write_byte interrupt source goes high for 1 bit period each time a new byte is transferred from the
SR to the FIFO (i.e. each time a new byte is received)
Fifofull: Fifofull interrupt source is high when the last FIFO byte, i.e. the whole FIFO, is full. Otherwise it is low.
Fifo_overrun_clr: Fifo_overrun_clr flag is set when a new byte is written by the user (in Tx or Standby modes)
or the SR (in Rx mode) while the FIFO is already full. In this case, data is lost and the flag should be cleared by
writing a 1. The bit can also be used anytime to clear FIFO and relaunch a new Rx or Tx process
Tx_done: Tx_done interrupt source goes high when FIFO is empty and the SR’s last bit has been send to the
modulator (i.e. the last bit of the packet has been sent). One bit period delay is required after the rising edge of
Tx_done to ensure correct RF transmission of the last bit. In practice this may not require special care in the uC
software due to IRQ processing time.
Fifo_threshold: Fifo_threshold interrupt source’s behavior can be programmed via MCParam_Fifo_thresh (B
value). This behavior is illustrated in Figure 32.
IRQ source
1
0
B
B+1
# of bytes in FIFO
Figure 32: FIFO Threshold IRQ Source Behavior
5.2.2.4. FIFO Clearing
Table 16 below summarizes the status of the FIFO when switching between different modes
Table 16: Status of FIFO when Switching Between Different Modes of the Chip
From
Stby
Stby
Rx
Rx
Tx
Tx
Any
To
Tx
Rx
Tx
Stby
Rx
Stby
Sleep
FIFO Status
Cleared
Not cleared
Cleared
Cleared
Not cleared
Cleared
Not cleared
Cleared
Comments
In Buffered mode, FIFO cannot be written in Stby before Tx
In Packet mode, FIFO can be written in Stby before Tx
In Packet & Buffered modes FIFO can be read in Stby after Rx
5.2.3. Sync Word Recognition
Rev 2 – June 18th, 2009
Page 39 of 77
www.semtech.com
相关PDF资料 |
PDF描述 |
|---|---|
| DP-241-6-28 | XFRMR PWR 115/230V 28VCT 1.1A |
| DP-241-6-20 | XFRMR PWR 115/230V 20VCT 1.5A |
| CSX750FJC49.152M-UT | OSCILLATOR 49.1520 MHZ SMD |
| SX1211I084TRT | IC SNGL-CHIP TXRX 32-TQFN |
| 12-900-LPI | XFRMR PWR 115/230V 12.6VCT 900MA |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SX1213 | 制造商:SEMTECH 制造商全称:Semtech Corporation 功能描述:Ultra-Low Power Integrated UHF Receiver |
| SX1213IWLTRT | 制造商:Semtech Corporation 功能描述: 制造商:Semtech Corporation 功能描述:SX1213 Series 510 MHz 200 Kbps Ultra-Low Power Integrated UHF Receiver - TQFN-32 |
| SX1223 | 制造商:SEMTECH 制造商全称:Semtech Corporation 功能描述:425 - 475 MHz / 850 - 950 MHz Integrated UHF Transmitter |
| SX1223I073 | 制造商:Semtech Corporation 功能描述:SX Series 425 to 950 MHz 153.6 kbps SMT Integrated UHF Transmitter - TQFN-24 制造商:SEMTECH 功能描述:SX Series 425 to 950 MHz 153.6 kbps SMT Integrated UHF Transmitter - TQFN-24 |
| SX1223I073TRT | 功能描述:IC TX UHF 433/868/916 MHZ 24TQFN RoHS:是 类别:RF/IF 和 RFID >> RF 发射器 系列:- 标准包装:4,000 系列:- 频率:310MHz ~ 440MHz 应用:- 调制或协议:UHF，ASK 数据传输率 - 最大:20 kBaud 功率 - 输出:1dBm ~ 5dBm 电流 - 传输:10mA 数据接口:PCB，表面贴装 天线连接器:PCB，表面贴装 存储容量:- 特点:- 电源电压:2.2 V ~ 4 V 工作温度:-40°C ~ 85°C 封装/外壳:16-LSSOP（0.154"，3.90mm 宽） 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。