- 您现在的位置：买卖IC网 > PDF目录98167 > TB6615PG STEPPER MOTOR CONTROLLER, PDIP16 PDF资料下载
参数资料
| 型号： | TB6615PG |
| 元件分类： | 运动控制电子 |
| 英文描述： | STEPPER MOTOR CONTROLLER, PDIP16 |
| 封装： | 0.300 INCH, LEAD FREE, PLASTIC, DIP-16 |
| 文件页数： | 4/13页 |
| 文件大小： | 467K |
| 代理商： | TB6615PG |
TB6615PG
2007-08-01
12
Points to remember on handling of ICs
(1) Overcurrent Protection Circuit
Overcurrent protection circuits (referred to as current limiter circuits) do not necessarily protect ICs
under all circumstances. If the Over current protection circuits operate against the over current,
clear the over current status immediately.
Depending on the method of use and usage conditions, such as exceeding absolute maximum ratings
can cause the over current protection circuit to not operate properly or IC breakdown before
operation. In addition, depending on the method of use and usage conditions, if over current
continues to flow for a long time after operation, the IC may generate heat resulting in breakdown.
(2) Heat Radiation Design
In using an IC with large current flow such as power amp, regulator or driver, please design the
device so that heat is appropriately radiated, not to exceed the specified junction temperature (TJ)
at any time and condition. These ICs generate heat even during normal use. An inadequate IC heat
radiation design can lead to decrease in IC life, deterioration of IC characteristics or IC breakdown.
In addition, please design the device taking into consideration the effect of IC heat radiation with
peripheral components.
(3) Back-EMF
When a motor rotates in the reverse direction, stops or slows down abruptly, a current flow back to the motor’s
power supply due to the effect of back-EMF. If the current sink capability of the power supply is small, the
device’s motor power supply and output pins might be exposed to conditions beyond maximum ratings. To avoid
this problem, take the effect of back-EMF into consideration in system design.
相关PDF资料 |
PDF描述 |
|---|---|
| TB7004FL | SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PQCC56 |
| TB7102AF(TE85L,F) | SWITCHING REGULATOR, 1150 kHz SWITCHING FREQ-MAX, PDSO8 |
| TB7102AF(TE85L,F) | SWITCHING REGULATOR, 1150 kHz SWITCHING FREQ-MAX, PDSO8 |
| TB7102F(TE85L,F) | SWITCHING REGULATOR, 1150 kHz SWITCHING FREQ-MAX, PDSO8 |
| TBA229-5 | FM, AUDIO DEMODULATOR, PDIP16 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TB6615PG(O) | 制造商:Toshiba America Electronic Components 功能描述:Moter Driver,3/4 phase,Stepping,DIP16 |
| TB6615PG(O,8) | 功能描述:马达/运动/点火控制器和驱动器 3-/4-phase stepping motor Drvr 28V RoHS:否 制造商:STMicroelectronics 产品:Stepper Motor Controllers / Drivers 类型:2 Phase Stepper Motor Driver 工作电源电压:8 V to 45 V 电源电流:0.5 mA 工作温度:- 25 C to + 125 C 安装风格:SMD/SMT 封装 / 箱体:HTSSOP-28 封装:Tube |
| TB6617FNG(O,EL) | 功能描述:马达/运动/点火控制器和驱动器 50V Bridge Drvr for brushed DC motors RoHS:否 制造商:STMicroelectronics 产品:Stepper Motor Controllers / Drivers 类型:2 Phase Stepper Motor Driver 工作电源电压:8 V to 45 V 电源电流:0.5 mA 工作温度:- 25 C to + 125 C 安装风格:SMD/SMT 封装 / 箱体:HTSSOP-28 封装:Tube |
| TB662 | 制造商:Distributed By MCM 功能描述:GARBAGE DISPOSER WRENCH |
| TB6631FNG(O,EL) | 功能描述:马达/运动/点火控制器和驱动器 3-phase brushless 18V 0.002A Iout PWM RoHS:否 制造商:STMicroelectronics 产品:Stepper Motor Controllers / Drivers 类型:2 Phase Stepper Motor Driver 工作电源电压:8 V to 45 V 电源电流:0.5 mA 工作温度:- 25 C to + 125 C 安装风格:SMD/SMT 封装 / 箱体:HTSSOP-28 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。