参数资料
型号: TDA6402A
厂商: NXP Semiconductors N.V.
英文描述: 5 V mixers/oscillators andsynthesizers for cable TV and VCR 2-band tuners(应用于TV电缆和 VCR二频带调谐的5 V 混频器/振荡器和合成器)
中文描述: 5伏混频器/电缆电视和录像机2频段调谐器(应用于电视电缆和录像机二频带调谐的5伏混频器/振荡器和合成器振荡器andsynthesizers)
文件页数: 13/40页
文件大小: 195K
代理商: TDA6402A
2000 Jan 24
20
Philips Semiconductors
Product specication
5 V mixers/oscillators and synthesizers for
cable TV and VCR 2-band tuners
TDA6402; TDA6402A;
TDA6403; TDA6403A
5. The frequency drift is defined as a change in oscillator frequency when the ambient temperature varies from
Tamb =25to50 °C or from Tamb =25to0 °C. The oscillator is free running during this measurement. The VHF drift
value can be improved by adding a 10 k
resistor between the VHFOSCOC pin and the VCC. In that case the typical
VHF drift value can be reduced to 900 kHz.
6. Switch-on drift is defined as the change in oscillator frequency between 5 s and 15 min after switch on. The oscillator
is free running during this measurement.
7. The ripple susceptibility is measured for a 500 kHz ripple at the IF output using the measurement circuit of Fig.19;
the level of the ripple signal is increased until a difference of 53.5 dB occurs between the IF carrier fixed at 100 dB
V
and the sideband components.
8. This is the level of divider interferences close to the IF frequency. For example channel C: fOSC = 179 MHz,
1
4 fOSC = 44.75 MHz. Divider interference is measured with the Philips 37185 demonstration board in accordance
with Fig.19. All ground pins are connected to a single ground plane under the IC. The VHFIN input must be left open
(i.e. not connected to any load or cable); The UHFIN1 and UHFIN2 inputs are connected to a hybrid.
The measured levels of divider interference are influenced by layout, grounding and port decoupling.
The measurement results could vary by as much as 10 dB with respect to the specification.
9. Crystal oscillator interference means the 4 MHz sidebands caused by the crystal oscillator. The rejection has to be
greater than 60 dB for an IF output signal of 100 dB
V.
10. The reference frequency rejection is the level of reference frequency sidebands related to the sound sub-carrier.
The rejection has to be greater than 50 dB for an IF output signal of 100 dB
V.
11. Channel 6 beat is the interfering product of fRFpix +fRFsnd fOSC of channel 6 at 42 MHz.
12. Channel A-5 beat is the interfering product of fRFpix, fIF and fOSC of channel A-4; fBEAT = 45.5 MHz. The possible
mechanisms are: fOSC 2 × fIF or 2 × fRFpix fOSC. For the measurement VRF =80dBV.
Fig.9 Input admittance (S11) of the VHF mixer input (40 to 400 MHz); Y0 = 20 mS.
handbook, full pagewidth
MGE722
0.2
2
1
0.5
10
5
0.2
2
1
0.5
10
5
0
+ j
– j
0.2
0.5
1
2
5
10
40 MHz
400 MHz
相关PDF资料
PDF描述
TDA7000 FM radio circuit(FM收音电路)
TDA7275A BRUSH DC MOTOR CONTROLLER, 1.5 A, PDIP8
TDA8002C IC Card Interface(IC卡接口)
TDA8003TS IIC-bus SIM Card Interface(IIC总线SIM卡接口)
TDA8005 Low-Power Smart Card Coupler(低功耗智能卡藕合器)
相关代理商/技术参数
参数描述
TDA6403 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:5 V mixers/oscillators and synthesizers for cable TV and VCR 2-band tuners
TDA6403A 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:5 V mixers/oscillators and synthesizers for cable TV and VCR 2-band tuners
TDA6404 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:5 V mixer/oscillator-PLL synthesizers for hyperband tuners
TDA6404TS 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:5 V mixer/oscillator-PLL synthesizers for hyperband tuners
TDA6405 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:5 V mixer/oscillator-PLL synthesizers for hyperband tuners