- 您现在的位置：买卖IC网 > PDF目录85414 > TDA6403M-T (NXP SEMICONDUCTORS) 2-BAND, VIDEO TUNER, PDSO28 PDF资料下载
参数资料
| 型号： | TDA6403M-T |
| 厂商： | NXP SEMICONDUCTORS |
| 元件分类： | 调谐器 |
| 英文描述： | 2-BAND, VIDEO TUNER, PDSO28 |
| 封装： | PLASTIC, SOT-341, SSOP-28 |
| 文件页数： | 13/44页 |
| 文件大小： | 241K |
| 代理商： | TDA6403M-T |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页当前第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页
2000 Jan 24
20
Philips Semiconductors
Product specication
5 V mixers/oscillators and synthesizers for
cable TV and VCR 2-band tuners
TDA6402; TDA6402A;
TDA6403; TDA6403A
5. The frequency drift is defined as a change in oscillator frequency when the ambient temperature varies from
Tamb =25to50 °C or from Tamb =25to0 °C. The oscillator is free running during this measurement. The VHF drift
value can be improved by adding a 10 k
resistor between the VHFOSCOC pin and the VCC. In that case the typical
VHF drift value can be reduced to 900 kHz.
6. Switch-on drift is defined as the change in oscillator frequency between 5 s and 15 min after switch on. The oscillator
is free running during this measurement.
7. The ripple susceptibility is measured for a 500 kHz ripple at the IF output using the measurement circuit of Fig.19;
the level of the ripple signal is increased until a difference of 53.5 dB occurs between the IF carrier fixed at 100 dB
V
and the sideband components.
8. This is the level of divider interferences close to the IF frequency. For example channel C: fOSC = 179 MHz,
1
4 fOSC = 44.75 MHz. Divider interference is measured with the Philips 37185 demonstration board in accordance
with Fig.19. All ground pins are connected to a single ground plane under the IC. The VHFIN input must be left open
(i.e. not connected to any load or cable); The UHFIN1 and UHFIN2 inputs are connected to a hybrid.
The measured levels of divider interference are influenced by layout, grounding and port decoupling.
The measurement results could vary by as much as 10 dB with respect to the specification.
9. Crystal oscillator interference means the 4 MHz sidebands caused by the crystal oscillator. The rejection has to be
greater than 60 dB for an IF output signal of 100 dB
V.
10. The reference frequency rejection is the level of reference frequency sidebands related to the sound sub-carrier.
The rejection has to be greater than 50 dB for an IF output signal of 100 dB
V.
11. Channel 6 beat is the interfering product of fRFpix +fRFsnd fOSC of channel 6 at 42 MHz.
12. Channel A-5 beat is the interfering product of fRFpix, fIF and fOSC of channel A-4; fBEAT = 45.5 MHz. The possible
mechanisms are: fOSC 2 × fIF or 2 × fRFpix fOSC. For the measurement VRF =80dBV.
Fig.9 Input admittance (S11) of the VHF mixer input (40 to 400 MHz); Y0 = 20 mS.
handbook, full pagewidth
MGE722
0.2
2
1
0.5
10
5
0.2
2
1
0.5
10
5
∞
0
+ j
– j
0.2
0.5
1
2
5
10
40 MHz
400 MHz
相关PDF资料 |
PDF描述 |
|---|---|
| TDA1562Q/N2/S10 | 70 W, 1 CHANNEL, AUDIO AMPLIFIER, PZIP17 |
| TDA1562Q/N2 | 70 W, 1 CHANNEL, AUDIO AMPLIFIER, PZIP17 |
| TDA8373/N3 | SPECIALTY CONSUMER CIRCUIT, PDIP56 |
| TDA8373C/N3 | SPECIALTY CONSUMER CIRCUIT, PDIP56 |
| TDA8373CN | SPECIALTY CONSUMER CIRCUIT, PDIP56 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TDA6404 | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:5 V mixer/oscillator-PLL synthesizers for hyperband tuners |
| TDA6404TS | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:5 V mixer/oscillator-PLL synthesizers for hyperband tuners |
| TDA6405 | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:5 V mixer/oscillator-PLL synthesizers for hyperband tuners |
| TDA6405A | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:5 V mixer/oscillator-PLL synthesizers for hyperband tuners |
| TDA6405ATS | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:5 V mixer/oscillator-PLL synthesizers for hyperband tuners |
发布紧急采购，3分钟左右您将得到回复。