参数资料
型号: TEA5760UK/N1/S21,0
厂商: NXP SEMICONDUCTORS
元件分类: 消费家电
英文描述: SPECIALTY CONSUMER CIRCUIT, PBGA25
封装: 3 X 2.80 MM, 0.60 MM HEIGHT, WLCSP-25
文件页数: 8/37页
文件大小: 209K
代理商: TEA5760UK/N1/S21,0
TEA5760UK_1
NXP B.V. 2006. All rights reserved.
Product data sheet
Rev. 01 — 14 December 2006
15 of 36
NXP Semiconductors
TEA5760UK
Single chip FM stereo radio
7.1.4.3
RSSI threshold: LEVFLAG
The level voltage reects the eld strength received by the antenna. The level voltage is
analog-to-digital converted with 4 bits and output via the control interface. This 4-bit level
value can be compared to a threshold level set by the SSL bits (see Table 14). The level
ADC (which converts the analog value to digital) is triggered by a search or preset cycle.
During a tuning step, which can be a search or a preset it is triggered by these algorithms
and compares the level with the threshold set by the SSL bits. The LEVFLAG bit is set if
the RSSI level drops below the threshold level set by the SSL bits (see Table 14), the HW
interrupt is only generated if the corresponding mask bit is set.
7.1.4.4
Frequency ready ag: FRRFLAG
The frequency ready ag bit FRRFLAG is set to logic 1 when the automatic tuning has
nished a search or preset. The description of this bit is given in Table 9. This bit is
cleared by a read of the ag register.
7.1.4.5
Band limit: BLFLAG
The band limit bit BLFLAG is set to logic 1 when the automatic tuning has detected the
end of the tuning band. This bit is described in Table 9. This bit is cleared by a read of the
ag register.
7.2 Interrupt line
The interrupt line driver is a MOS transistor with a nominal sink current of 900
A. It is
pulled HIGH by an 18 k
resistor connected to pin VREFDIG. The interrupt line can be
connected to one other similar device with an interrupt output and an 18 k
pull-up
resistor, providing a wired-OR function. This allows any of the drivers to pull the interrupt
line LOW by sinking the current (see Section 11). When a ag is set and not masked it
generates an interrupt.
(1) When Flag is set next interrupts are blocked until Read/Write INTMSK.
(2) Read INTMSK clears Flag, INTMSK and INTX.
(3) Write INTMSK enables INTX.
Fig 6.
Interrupt line behavior
001aab489
10 ms
VCCA
flag(1)
INTX
read INTMSK(2)
write
INTMSK(3)
10 ms
<10 ms
read clears INTX
相关PDF资料
PDF描述
TEA5760UK/N1/S21,1 SPECIALTY CONSUMER CIRCUIT, PBGA25
TEA5760UK SPECIALTY CONSUMER CIRCUIT, PBGA25
TEA5766UK/N1,023 FM, AUDIO SINGLE CHIP RECEIVER, PBGA25
TEA5766UK/N1,118 FM, AUDIO SINGLE CHIP RECEIVER, PBGA25
TEA5766UK/N1/S21,0 FM, AUDIO SINGLE CHIP RECEIVER, PBGA25
相关代理商/技术参数
参数描述
TEA5761UK 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:Low voltage single-chip FM stereo radio
TEA5762 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:Self Tuned Radio STR
TEA5762H 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:Self Tuned Radio STR
TEA5762H/V1,518 功能描述:调谐器 SELF TUNED RADIO RoHS:否 制造商:NXP Semiconductors 功能: 噪声系数: 工作电源电压: 最小工作温度: 最大工作温度:
TEA5762H/V1,557 功能描述:调谐器 SELF TUNED RADIO RoHS:否 制造商:NXP Semiconductors 功能: 噪声系数: 工作电源电压: 最小工作温度: 最大工作温度: