- 您现在的位置：买卖IC网 > PDF目录98262 > TLV5636IDGKG4 (TEXAS INSTRUMENTS INC) SERIAL INPUT LOADING, 3.5 us SETTLING TIME, 12-BIT DAC, PDSO8 PDF资料下载
参数资料
| 型号： | TLV5636IDGKG4 |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | DAC |
| 英文描述： | SERIAL INPUT LOADING, 3.5 us SETTLING TIME, 12-BIT DAC, PDSO8 |
| 封装： | GREEN, PLASTIC, MSOP-8 |
| 文件页数： | 6/23页 |
| 文件大小： | 521K |
| 代理商： | TLV5636IDGKG4 |
www.ti.com
LINEARITY, OFFSET, AND GAIN ERROR USING SINGLE END SUPPLIES
DAC Code
Output
Voltage
0 V
Negative
Offset
POWER-SUPPLY BYPASSING AND GROUND MANAGEMENT
0.1
F
Analog Ground Plane
1
2
3
4
8
7
6
5
TLV5636
SLAS223C – JUNE 1999 – REVISED APRIL 2004
When an amplifier is operated from a single supply, the voltage offset can still be either positive or negative. With
a positive offset, the output voltage changes on the first code change. With a negative offset, the output voltage
may not change with the first code, depending on the magnitude of the offset voltage.
The output amplifier attempts to drive the output to a negative voltage. However, because the most negative
supply rail is ground, the output cannot drive below ground and clamps the output at 0 V.
The output voltage then remains at zero until the input code value produces a sufficient positive output voltage to
overcome the negative offset voltage, resulting in the transfer function shown in Figure 15.
Figure 15. Effect of Negative Offset (Single Supply)
This offset error, not the linearity error, produces this breakpoint. The transfer function would have followed the
dotted line if the output buffer could drive below the ground rail.
For a DAC, linearity is measured between zero-input code (all inputs 0) and full-scale code (all inputs 1) after
offset and full scale are adjusted out or accounted for in some way. However, single supply operation does not
allow for adjustment when the offset is negative due to the breakpoint in the transfer function. So the linearity is
measured between full-scale code and the lowest code that produces a positive output voltage.
Printed-circuit boards that use separate analog and digital ground planes offer the best system performance.
Wire-wrap boards do not perform well and should not be used. The two ground planes should be connected
together at the low-impedance power-supply source. The best ground connection may be achieved by
connecting the DAC AGND terminal to the system analog ground plane, making sure that analog ground currents
are well managed and there are negligible voltage drops across the ground plane.
A 0.1-F ceramic-capacitor bypass should be connected between VDD and AGND and mounted with short leads
as close as possible to the device. Use of ferrite beads may further isolate the system analog supply from the
digital power supply.
Figure 16 shows the ground plane layout and bypassing technique.
Figure 16. Power-Supply Bypassing
14
相关PDF资料 |
PDF描述 |
|---|---|
| TLV5637CDRG4 | DUAL, SERIAL INPUT LOADING, 2.8 us SETTLING TIME, 10-BIT DAC, PDSO8 |
| TLV5637CDR | SERIAL INPUT LOADING, 2.8 us SETTLING TIME, 10-BIT DAC, PDSO8 |
| TLV5637IDRG4 | SERIAL INPUT LOADING, 2.8 us SETTLING TIME, 10-BIT DAC, PDSO8 |
| TLV5637ID | SERIAL INPUT LOADING, 2.8 us SETTLING TIME, 10-BIT DAC, PDSO8 |
| TLV5637CDG4 | SERIAL INPUT LOADING, 2.8 us SETTLING TIME, 10-BIT DAC, PDSO8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TLV5636IDGKR | 功能描述:数模转换器- DAC 12-Bit 1 us DAC Serial Out RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| TLV5636IDGKRG4 | 功能描述:数模转换器- DAC 12-Bit 1 us DAC Serial Out RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| TLV5636IDR | 功能描述:数模转换器- DAC 12-Bit 1 us DAC Serial Out RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| TLV5636IDRG4 | 功能描述:数模转换器- DAC 12-Bit 1 us DAC Serial Out RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| TLV5637 | 制造商:TI 制造商全称:Texas Instruments 功能描述:2.7 V TO 5.5 V LOW POWER DUAL 10-BIT DIGITAL-TO-ANALOG CONVERTER WITH INTERNAL REFERENCE AND POWER DOWN |
发布紧急采购，3分钟左右您将得到回复。