参数资料
型号: TMP320R2812PBKQ
厂商: Texas Instruments, Inc.
元件分类: 数字信号处理
英文描述: TMS320R2811, TMS320R2812 Digital Signal Processors
中文描述: TMS320R2811,TMS320R2812数字信号处理器
文件页数: 20/147页
文件大小: 2021K
代理商: TMP320R2812PBKQ
Introduction
20
June 2004
SPRS257
Table 2
2. Signal Descriptions
(Continued)
NAME
DESCRIPTION
PU/PD
§
I/O/Z
PIN NO.
128-PIN
PBK
176-PIN
PGF
179-PIN
GHH
AND
ZHH
XINTF SIGNALS (2812 ONLY) (CONTINUED)
XREADY
B6
161
I
PU
Ready Signal. Indicates peripheral is ready to complete the
access when asserted to 1. XREADY can be configured to be
a synchronous or an asynchronous input. See the timing
diagrams for more details.
JTAG AND MISCELLANEOUS SIGNALS
X1/XCLKIN
K9
77
58
I
Oscillator Input
input to the internal oscillator. This pin is also
used to feed an external clock. The 28x can be operated with
an external clock source, provided that the proper voltage
levels be driven on the X1/XCLKIN pin. It should be noted that
the X1/XCLKIN pin is referenced to the 1.8-V (or 1.9-V) core
digital power supply (V
DD
), rather than the 3.3-V I/O supply
(V
DDIO
). A clamping diode may be used to clamp a buffered
clock signal to ensure that the logic-high level does not
exceed V
DD
(1.8 V or 1.9 V) or a 1.8-V oscillator may be used.
Oscillator Output
Output clock derived from SYSCLKOUT to be used for
external wait-state generation and as a general-purpose clock
source. XCLKOUT is either the same frequency, 1/2 the
frequency, or 1/4 the frequency of SYSCLKOUT. At reset,
XCLKOUT = SYSCLKOUT/4. The XCLKOUT signal can be
turned off by setting bit 3 (CLKOFF) of the XINTCNF2 register
to 1.
X2
M9
76
57
O
XCLKOUT
F11
119
87
O
TESTSEL
A13
134
97
I
PD
Test Pin. Reserved for TI. Must be connected to ground.
Device Reset (in) and Watchdog Reset (out).
XRS
D6
160
113
I/O
PU
Device reset. XRS causes the device to terminate execution.
The PC will point to the address contained at the location
0x3FFFC0. When XRS is brought to a high level, execution
begins at the location pointed to by the PC. This pin is driven
low by the DSP when a watchdog reset occurs. During
watchdog reset, the XRS pin will be driven low for the
watchdog reset duration of 512 XCLKIN cycles.
The output buffer of this pin is an open-drain with an internal
pullup (100
μ
A, typical). It is recommended that this pin be
driven by an open-drain device.
TEST1
M7
67
51
I/O
This pin is a “no connect (NC)” (i.e., this pin is not connected
to any circuitry internal to the device).
TEST2
N7
66
50
I/O
This pin is a “no connect (NC)” (i.e., this pin is not connected
to any circuitry internal to the device).
Typical drive strength of the output buffer for all pins is 4 mA except for TDO, XCLKOUT, XF, XINTF, EMU0, and EMU1 pins, which are 8 mA.
I = Input, O = Output, Z = High impedance
§
PU = pin has internal pullup; PD = pin has internal pulldown
A
相关PDF资料
PDF描述
TMP320R2812PBKS TMS320R2811, TMS320R2812 Digital Signal Processors
TMP320R2812PGFA TMS320R2811, TMS320R2812 Digital Signal Processors
TMP320R2812PGFQ TMS320R2811, TMS320R2812 Digital Signal Processors
TMP320R2812PGFS TMS320R2811, TMS320R2812 Digital Signal Processors
TMP320R2812ZHHA TMS320R2811, TMS320R2812 Digital Signal Processors
相关代理商/技术参数
参数描述
TMP34092PQL-64 制造商:Texas Instruments 功能描述:
TMP35FS 制造商:Analog Devices 功能描述:Temp Sensor Analog(Voltage) Serial (2-Wire) 8-Pin SOIC N 制造商:Rochester Electronics LLC 功能描述:3V TEMPERATURE SENSOR - Bulk
TMP35FS-REEL 制造商:Analog Devices 功能描述:Temp Sensor Analog Serial (2-Wire) 8-Pin SOIC N T/R 制造商:Rochester Electronics LLC 功能描述:3V TEMPERATURE SENSOR TAPE & REEL - Tape and Reel
TMP35FSZ 制造商:Analog Devices 功能描述:Temperature Sensor IC
TMP35FSZ-REEL 制造商:Analog Devices 功能描述:TEMP SENSOR ANLG SERL 8SOIC N - Tape and Reel