参数资料
型号: TMS320F28069PFPS
厂商: Texas Instruments
文件页数: 89/174页
文件大小: 0K
描述: IC MCU 32BIT 256KB FLASH 80HTQFP
产品培训模块: ControlSUITE
Piccolo F2806x
TPS75005 Single IC Power for C2000 MCU
标准包装: 1,000
系列: TMS320F2806x, Piccolo™, C2000™
核心处理器: C28x
芯体尺寸: 32-位
速度: 80MHz
连通性: CAN,I²C,McBSP,SCI,SPI,UART/USART
外围设备: 欠压检测/复位,DMA,POR,PWM,WDT
输入/输出数: 40
程序存储器容量: 256KB(128K x 16)
程序存储器类型: 闪存
RAM 容量: 50K x 16
电压 - 电源 (Vcc/Vdd): 1.71 V ~ 1.995 V
数据转换器: A/D 12x12b
振荡器型: 内部
工作温度: -40°C ~ 125°C
封装/外壳: 80-TQFP 裸露焊盘
包装: 托盘
SPRS698D – NOVEMBER 2010 – REVISED DECEMBER 2012
2.4
Signal Descriptions
Table 2-5 describes the signals. With the exception of the JTAG pins, the GPIO function is the default at
reset, unless otherwise mentioned. The peripheral signals that are listed under them are alternate
functions. Some peripheral functions may not be available in all devices. See Table 2-1 for details. Inputs
are not 5-V tolerant. All GPIO pins are I/O/Z and have an internal pullup, which can be selectively enabled
or disabled on a per-pin basis. This feature only applies to the GPIO pins. The pullups on the PWM pins
are not enabled at reset. The pullups on other GPIO pins are enabled upon reset. The AIO pins do not
have an internal pullup.
NOTE: When the on-chip VREG is used, the GPIO19, GPIO34, GPIO35, GPIO36, GPIO37, and GPIO38
pins could glitch during power up. If this is unacceptable in an application, 1.8 V could be supplied
externally. There is no power-sequencing requirement when using an external 1.8-V supply. However, if
the 3.3-V transistors in the level-shifting output buffers of the I/O pins are powered prior to the 1.9-V
transistors, it is possible for the output buffers to turn on, causing a glitch to occur on the pin during power
up. To avoid this behavior, power the VDD pins prior to or simultaneously with the VDDIO pins, ensuring that
the VDD pins have reached 0.7 V before the VDDIO pins reach 0.7 V.
Table 2-5. Terminal Functions(1)
PIN NO.
PIN NAME
I/O/Z
DESCRIPTION
PZ
PN
PZP
PFP
JTAG
JTAG test reset with internal pulldown. TRST, when driven high, gives the scan system
control of the operations of the device. If this signal is not connected or driven low, the
device operates in its functional mode, and the test reset signals are ignored.
NOTE: TRST is an active-high test pin and must be maintained low at all times during
TRST
12
10
I
normal device operation. An external pull-down resistor is required on this pin. The
value of this resistor should be based on drive strength of the debugger pods
applicable to the design. A 2.2-k
resistor generally offers adequate protection. Since
this is application-specific, it is recommended that each target board be validated for
proper operation of the debugger and the application. (
↓)
TCK
See GPIO38
I
See GPIO38. JTAG test clock with internal pullup. (
↑)
See GPIO36. JTAG test-mode select (TMS) with internal pullup. This serial control
TMS
See GPIO36
I
input is clocked into the TAP controller on the rising edge of TCK. (
↑)
See GPIO35. JTAG test data input (TDI) with internal pullup. TDI is clocked into the
TDI
See GPIO35
I
selected register (instruction or data) on a rising edge of TCK. (
↑)
See GPIO37. JTAG scan out, test data output (TDO). The contents of the selected
TDO
See GPIO37
O/Z
register (instruction or data) are shifted out of TDO on the falling edge of TCK.
(8-mA drive)
FLASH
VDD3VFL
46
37
3.3-V Flash Core Power Pin. This pin should be connected to 3.3 V at all times.
TEST2
45
36
I/O
Test Pin. Reserved for TI. Must be left unconnected.
(1)
I = Input, O = Output, Z = High Impedance, OD = Open Drain,
↑ = Pullup, ↓ = Pulldown
Copyright 2010–2012, Texas Instruments Incorporated
Device Overview
21
相关PDF资料
PDF描述
2220PC684MAT1A CAP CER 0.68UF 250V 20% X7R 2220
2220PC105MAT9A CAP CER 1UF 250V X7R 20% 2220
LTC1393CS IC MULTIPLEXER DUAL 4X1 16SOIC
2220PC105MAT1A CAP CER 1UF 250V X7R 20% 2220
LT6555CUF#TRPBF IC VIDEO MULTIPLEXER 2X1 24QFN
相关代理商/技术参数
参数描述
TMS320F28069PNA 制造商:Texas Instruments 功能描述:
TMS320F28069PNT 功能描述:32位微控制器 - MCU PICCOLO MCU RoHS:否 制造商:Texas Instruments 核心:C28x 处理器系列:TMS320F28x 数据总线宽度:32 bit 最大时钟频率:90 MHz 程序存储器大小:64 KB 数据 RAM 大小:26 KB 片上 ADC:Yes 工作电源电压:2.97 V to 3.63 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:LQFP-80 安装风格:SMD/SMT
TMS320F28069PZA 功能描述:32位微控制器 - MCU Piccolo MCU RoHS:否 制造商:Texas Instruments 核心:C28x 处理器系列:TMS320F28x 数据总线宽度:32 bit 最大时钟频率:90 MHz 程序存储器大小:64 KB 数据 RAM 大小:26 KB 片上 ADC:Yes 工作电源电压:2.97 V to 3.63 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:LQFP-80 安装风格:SMD/SMT
TMS320F28069PZPQ 功能描述:IC MCU 32BIT 256KB FLSH 100HTQFP RoHS:是 类别:集成电路 (IC) >> 嵌入式 - 微控制器, 系列:TMS320F2806x, Piccolo™, C2000™ 产品培训模块:Asynchronous Stimulus 标准包装:90 系列:dsPIC™ 30F 核心处理器:dsPIC 芯体尺寸:16-位 速度:20 MIPS 连通性:CAN,I²C,SPI,UART/USART 外围设备:AC'97,欠压检测/复位,I²S,LVD,POR,PWM,WDT 输入/输出数:52 程序存储器容量:144KB(48K x 24) 程序存储器类型:闪存 EEPROM 大小:4K x 8 RAM 容量:8K x 8 电压 - 电源 (Vcc/Vdd):2.5 V ~ 5.5 V 数据转换器:A/D 16x12b 振荡器型:内部 工作温度:-40°C ~ 125°C 封装/外壳:64-TQFP 包装:托盘 配用:XLT64PT4-ND - SOCKET TRAN ICE 64MQFP/TQFPAC164313-ND - MODULE SKT FOR PM3 64PF 其它名称:DSPIC30F601220EPF
TMS320F28069PZPS 功能描述:32位微控制器 - MCU PICCOLO MCU RoHS:否 制造商:Texas Instruments 核心:C28x 处理器系列:TMS320F28x 数据总线宽度:32 bit 最大时钟频率:90 MHz 程序存储器大小:64 KB 数据 RAM 大小:26 KB 片上 ADC:Yes 工作电源电压:2.97 V to 3.63 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:LQFP-80 安装风格:SMD/SMT