参数资料
型号: TMS3637P
厂商: TEXAS INSTRUMENTS INC
元件分类: 摇控器
英文描述: INFRARED, TRANSMITTER/RECEIVER IC, PDIP8
封装: PLASTIC, DIP-8
文件页数: 14/54页
文件大小: 384K
代理商: TMS3637P
5–4
5.4
Internal Oscillator Operation for Transmit and Receive Modes Sampling
Frequency
The internal oscillator of the transmitter or receiver can be externally sampled at OSCC and OSCR. The
waveform at OSCC is triangular and the waveform at OSCR is square. The amplitude of these waveforms
depends on the capacitor and resistor values used.
5.5
External Oscillator Operation for Transmit and Receive Modes
Instead of using the internal oscillator (with an external resistor and capacitor) in the transmit or receive
modes, it is possible to externally drive the device by applying a logic level clock to OSCC. When an
externally driven oscillator is used, OSCR must be held to GND. To avoid entering the test/program modes,
ensure that the external clock applied to OSCC does not exceed VCC (for more information see
Section 5.12).
5.6
Internal Amplifier/Comparator, Description and Gain Setting
The TMS3637 has an internal amplifier that is designed to amplify received signals up to logic levels. In
addition, a comparator is cascaded with the amplifier to provide wave shaping of received signals. The
comparator also inverts the signal. The minimum received signal strength must be at least 3 mV
peak-to-peak (see Figure 5–3 for a schematic of the amplifier/comparator section). The amplifier is enabled
only when the TMS3637 is configured as an analog receiver. When the amplifier is not configured as an
analog receiver, it is disabled and bypassed to reduce power consumption in any of the three logic receiver
modes. A capacitor connected between CEX to GND determines the gain of the amplifier stage. When no
capacitor is connected from CEX to GND, the amplifier assumes unity gain and the comparator still functions
to shape the received signal. When the internal amplifier is used, it is usually run at the maximum gain of
200. The maximum gain is set by resistances internal to the device as shown in the equation 2. However,
to achieve this maximum gain, a low impedance from CEX to GND must exist. Equation 2 defines the
capacitance necessary at CEX for maximum gain at different oscillator frequencies (fosc):
CEX > 1 / (6.28
× fosc × R1)
(2)
where:
CEX = capacitance required for maximum gain
R1 = 178
(set internally)
With a low impedance between GND and CEX, note that the maximum gain is derived from the noninverting
operational amplifier gain equation, (see Figure 5–3):
Gv = 1 + R2/R1 = 200
(3)
where:
R1 = 178
(set internally)
R2 = 35.5 k
(set internally)
If a capacitor is used at CEX, but maximum gain is not desired, equation 4 can determine the gain for any
value of CEX:
Gv
+
1
) 4p2fosc2CT2(R1 ) R2)2
1
) 4p2f
2
osc CT
2R12
(4)
where:
fosc = oscillator frequency of transmitter (it is the transmitted frequency that is being amplified)
CT = CEX + 0.15 nF (there is an internal capacitance of 0.15 nF at CEX)
R1 = 178
(set internally)
R2 = 35.5 k
(set internally)
相关PDF资料
PDF描述
TMS3637DR INFRARED, TRANSMITTER/RECEIVER IC, PDSO8
TMS3637D INFRARED, TRANSMITTER/RECEIVER IC, PDSO8
TMS57014ADWBLE DUAL, SERIAL INPUT LOADING, 18-BIT DAC, PDSO28
TMX320C6474ZUN SPECIALTY CONSUMER CIRCUIT, PBGA561
TN5D01A 5 A SWITCHING REGULATOR, 180 kHz SWITCHING FREQ-MAX, ZFM5
相关代理商/技术参数
参数描述
TMS3705A1DRG4 功能描述:RFID应答器 Transponder base station IC RoHS:否 制造商:Murata 存储容量:512 bit 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体: 封装:Reel
TMS3705ADR 制造商:Rochester Electronics LLC 功能描述:- Bulk
TMS3705BDRG4 功能描述:RFID应答器 LF Reader IC RoHS:否 制造商:Murata 存储容量:512 bit 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体: 封装:Reel
TMS3705DDRQ1 功能描述:IC RFID BASE STATION LF 16SOIC 制造商:texas instruments 系列:- 包装:剪切带(CT) 零件状态:在售 类型:RFID 阅读器 频率:134.2kHz 标准:- 接口:- 电压 - 电源:5V 工作温度:-40°C ~ 85°C 封装/外壳:16-SOIC(0.154",3.90mm 宽) 供应商器件封装:16-SOIC 标准包装:1
TMS3705DR 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Texas Instruments 功能描述: