- 您现在的位置：买卖IC网 > PDF目录22107 > TOP269EG (Power Integrations)IC OFFLINE SW PWM OCP OVP 7ESIP PDF资料下载
参数资料
| 型号： | TOP269EG |
| 厂商： | Power Integrations |
| 文件页数： | 7/40页 |
| 文件大小： | 0K |
| 描述： | IC OFFLINE SW PWM OCP OVP 7ESIP |
| 特色产品： | TopSwitch?-JX Integrated Switcher Ics |
| 标准包装： | 48 |
| 输出隔离： | 隔离 |
| 频率范围： | 66 ~ 132kHz |
| 输出电压： | 725V |
| 功率（瓦特）： | 120W |
| 工作温度： | -40°C ~ 150°C |
| 封装/外壳： | 7-SIP，6 引线，裸露焊盘，成形引线 |
| 供应商设备封装： | eSIP-7C |
| 包装： | 管件 |
| 其它名称： | 596-1278-5 |
第1页第2页第3页第4页第5页第6页当前第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页
TOP264-271
V UV
V LINE
0V
S15
S14
S13 S12
S0
S15 S14
S13
S12
S0
S15
S14
S13
S12
S0
S15
S15
5.8 V
V C
0V
V DRAIN
0V
V OUT
0V
4.8 V
1
2
3
2
4
Note: S0 through S15 are the output states of the auto-restart counter
PI-4531-121206
Figure 8.
Typical Waveforms for (1) Power Up (2) Normal Operation (3) Auto-Restart (4) Power Down.
UV prevents auto-restart attempts after the output goes out of
regulation. This eliminates power down glitches caused by slow
discharge of the large input storage capacitor present in
applications such as standby supplies. A single resistor
connected from the VOLTAGE-MONITOR pin to the rectified DC
high-voltage bus sets UV threshold during power up. Once the
power supply is successfully turned on, the UV threshold is
lowered to 44% of the initial UV threshold to allow extended
input voltage operating range (UV low threshold). If the UV low
threshold is reached during operation without the power supply
losing regulation, the device will turn off and stay off until UV
(high threshold) has been reached again. If the power supply
loses regulation before reaching the UV low threshold, the
device will enter auto-restart. At the end of each auto-restart
cycle (S15), the UV comparator is enabled. If the UV high
threshold is not exceeded, the MOSFET will be disabled during
the next cycle (see Figure 8). The UV feature can be disabled
independent of the OV feature.
Line Overvoltage Shutdown (OV)
The same resistor used for UV also sets an overvoltage
threshold, which, once exceeded, will force TOP264-271 to
stop switching instantaneously (after completion of the current
switching cycle). If this condition lasts for at least 100 m s, the
TOP264-271 output will be forced into off state. When the line
voltage is back to normal with a small amount of hysteresis
provided on the OV threshold to prevent noise triggering, the
state machine sets to S13 and forces TOP264-271 to go
through the entire auto-restart sequence before attempting to
switch again. The ratio of OV and UV thresholds is preset at
4.5, as can be seen in Figure 9. When the MOSFET is off, the
rectified DC high-voltage surge capability is increased to the
voltage rating of the MOSFET (725 V), due to the absence of the
reflected voltage and leakage spikes on the drain. The OV
feature can be disabled independent of the UV feature.
www.powerint.com
In order to reduce the no-load input power of TOP264-271
designs, the V pin operates at very low currents. This requires
careful layout considerations when designing the PCB to avoid
noise coupling. Traces and components connected to the V pin
should not be adjacent to any traces carrying switching currents.
These include the drain, clamp network, bias winding return or
power traces from other converters. If the line sensing features
are used, then the sense resistors must be placed within 10 mm
of the V pin to minimize the V pin node area. The DC bus
should then be routed to the line sense resistors. Note that
external capacitance must not be connected to the V pin as this
may cause misoperation of the V pin related functions.
Hysteretic or Latching Output Overvoltage Protection (OVP)
The detection of the hysteretic or latching output overvoltage
protection (OVP) is through the trigger of the line overvoltage
threshold. The V pin voltage will drop by 0.5 V, and the
controller measures the external attached impedance immediately
after this voltage drops. If I V exceeds I OV(LS) (336 m A typical)
longer than 100 m s, TOP264-271 will latch into a permanent off
state for the latching OVP. It only can be reset if I X exceeds I X(TH)
= -27 m A (typ) or V C goes below the power-up-reset threshold
(V C(RESET) ) and then back to normal. If I V does not exceed I OV(LS) or
exceeds no longer than 100 m s, TOP264-271 will initiate the line
overvoltage and the hysteretic OVP. Their behavior will be
identical to the line overvoltage shutdown (OV) that has been
described in detail in the previous section. During a fault
condition resulting from loss of feedback, output voltage will
rapidly rise above the nominal voltage. The increase in output
voltage will also result in an increase in the voltage at the output
of the bias winding. A voltage at the output of the bias winding
that exceeds of the sum of the voltage rating of the Zener diode
connected from the bias winding output to the V pin and V pin
voltage, will cause a current in excess of I V to be injected into
the V pin, which will trigger the OVP feature.
7
Rev. E 08/12
相关PDF资料 |
PDF描述 |
|---|---|
| RMA32DTMI | CONN EDGECARD 64POS R/A .125 SLD |
| 8-530666-2 | CONN LOW PRO 28POS .156 SOLDER |
| RSA32DTBI | CONN EDGECARD 64POS R/A .125 SLD |
| VI-232-EV-F1 | CONVERTER MOD DC/DC 15V 150W |
| R-78HB24-0.3 | CONV DC/DC 0.3A 24V OUT SIP VERT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TOP269EG/VG | 制造商:POWERINT 制造商全称:Power Integrations, Inc. 功能描述:Integrated Off-Line Switcher with EcoSmart Technology for Highly Efficient Power Supplies |
| TOP269EG-TL | 制造商:POWERINT 制造商全称:Power Integrations, Inc. 功能描述:Integrated Off-Line Switcher with EcoSmart Technology for Highly Efficient Power Supplies |
| TOP269KG | 功能描述:交流/直流开关转换器 Int Off-Line Switchr EcoSmart,55W/81W RoHS:否 制造商:STMicroelectronics 输出电压:800 V 输入/电源电压（最大值）:23.5 V 输入/电源电压（最小值）:11.5 V 开关频率:115 kHz 电源电流:1.6 mA 工作温度范围:- 40 C to + 150 C 安装风格:SMD/SMT 封装 / 箱体:SSO-10 封装:Reel |
| TOP269KG-TL | 功能描述:交流/直流开关转换器 Int Off-Line Switchr EcoSmart,55W/81W RoHS:否 制造商:STMicroelectronics 输出电压:800 V 输入/电源电压（最大值）:23.5 V 输入/电源电压（最小值）:11.5 V 开关频率:115 kHz 电源电流:1.6 mA 工作温度范围:- 40 C to + 150 C 安装风格:SMD/SMT 封装 / 箱体:SSO-10 封装:Reel |
| TOP269VG | 功能描述:交流/直流开关转换器 Int Off-Line Switchr 120W/162W RoHS:否 制造商:STMicroelectronics 输出电压:800 V 输入/电源电压（最大值）:23.5 V 输入/电源电压（最小值）:11.5 V 开关频率:115 kHz 电源电流:1.6 mA 工作温度范围:- 40 C to + 150 C 安装风格:SMD/SMT 封装 / 箱体:SSO-10 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。