参数资料
型号: TPA3101D2PHP
厂商: TEXAS INSTRUMENTS INC
元件分类: 音频/视频放大
英文描述: 10 W, 2 CHANNEL, AUDIO AMPLIFIER, PQFP48
封装: 7 X 7 MM, GREEN, PLASTIC, HTQFP-48
文件页数: 10/41页
文件大小: 1073K
代理商: TPA3101D2PHP
0V
-12V
+12V
Current
OUTP
OUTN
Differential
Voltage
Across
Load
0V
-12V
+12V
Current
OUTP
OUTN
Differential
Voltage
Across
Load
Output=0V
Output>0V
SLOS473C – DECEMBER 2005 – REVISED SEPTEMBER 2007
www.ti.com
Figure 26. The TPA3101D2 Output Voltage and Current Waveforms Into an Inductive Load
Efficiency: LC Filter Required With the Traditional Class-D Modulation Scheme
The main reason that the traditional class-D amplifier needs an output filter is that the switching waveform results
in maximum current flow. This causes more loss in the load, which causes lower efficiency. The ripple current is
large for the traditional modulation scheme, because the ripple current is proportional to voltage multiplied by the
time at that voltage. The differential voltage swing is 2 x VCC, and the time at each voltage is half the period for
the traditional modulation scheme. An ideal LC filter is needed to store the ripple current from each half cycle for
the next half cycle, while any resistance causes power dissipation. The speaker is both resistive and reactive,
whereas an LC filter is almost purely reactive.
The TPA3101D2 modulation scheme has little loss in the load without a filter because the pulses are short and
the change in voltage is VCC instead of 2 x VCC. As the output power increases, the pulses widen, making the
ripple current larger. Ripple current could be filtered with an LC filter for increased efficiency, but for most
applications the filter is not needed.
An LC filter with a cutoff frequency less than the class-D switching frequency allows the switching current to flow
through the filter instead of the load. The filter has less resistance but higher impedance at the switching
frequency than the speaker, which results in less power dissipation, therefore increasing efficiency.
When to Use an Output Filter for EMI Suppression
Design the TPA3101D2 without the filter if the traces from amplifier to speaker are short (< 10 cm). Powered
speakers, where the speaker is in the same enclosure as the amplifier, is a typical application for class-D without
a filter.
18
Copyright 2005–2007, Texas Instruments Incorporated
Product Folder Link(s): TPA3101D2
相关PDF资料
PDF描述
TPA3101D2PHPG4 10 W, 2 CHANNEL, AUDIO AMPLIFIER, PQFP48
TPA3101D2PHPRG4 10 W, 2 CHANNEL, AUDIO AMPLIFIER, PQFP48
TPA3106D1VFPG4 40 W, 1 CHANNEL, AUDIO AMPLIFIER, PQFP32
TPA3106D1VFPRG4 40 W, 1 CHANNEL, AUDIO AMPLIFIER, PQFP32
TPA3106D1VFPR 40 W, 1 CHANNEL, AUDIO AMPLIFIER, PQFP32
相关代理商/技术参数
参数描述
TPA3101D2PHP 制造商:Texas Instruments 功能描述:IC AMP AUDIO PWR 10W STER 48TQFP 制造商:Texas Instruments 功能描述:IC, AMP AUDIO PWR 10W STER 48TQFP
TPA3101D2PHPG4 功能描述:音频放大器 10-W Stereo Class-D Aud Power Amplifier RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel
TPA3101D2PHPR 功能描述:音频放大器 10-W Stereo Class-D Aud Power Amplifier RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel
TPA3101D2PHPRG4 功能描述:音频放大器 10-W Stereo Class-D Aud Power Amplifier RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel
TPA3101D2RGZR 功能描述:音频放大器 10-W Stereo Class-D Aud Power Amplifier RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel