- 您现在的位置：买卖IC网 > PDF目录20011 > TPS23757PWR (Texas Instruments)IC POE INTERFACE SWITCH 20TSSOP PDF资料下载
参数资料
| 型号： | TPS23757PWR |
| 厂商： | Texas Instruments |
| 文件页数： | 22/39页 |
| 文件大小： | 0K |
| 描述： | IC POE INTERFACE SWITCH 20TSSOP |
| 标准包装： | 2,000 |
| 类型： | 以太网供电开关（PoE） |
| 应用： | 远程外设（工业控制，相机，数据访问） |
| 内部开关： | 是 |
| 电流限制： | 465mA |
| 电源电压： | 0 V ~ 57 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 20-TSSOP |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页当前第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页
TPS23757
SLVS948D – JULY 2009 – REVISED NOVEMBER 2013
www.ti.com
Adapter ORing
Many PoE-capable devices are designed to operate from either a wall adapter or PoE power. A local power
solution adds cost and complexity, but allows a product to be used if PoE is not available in a particular
installation. While most applications only require that the PD operate when both sources are present, the
TPS23757 supports forced operation from either of the power sources. Figure 23 illustrates three options for
diode ORing external power into a PD. Only one option would be used in any particular design. Option 1 applies
power to the TPS23757 PoE input, option 2 applies power between the TPS23757 PoE section and the dc/dc
converter, and option 3 applies power to the output side of the converter. Each of these options has advantages
and disadvantages. Many of the basic ORing configurations and discussion contained in application note
Advanced Adapter ORing Solutions using the TPS23753 (literature number SLVA306 ), apply to the TPS23757.
Optional for PoE Priority
Low Voltage
DEN
CLS
Power
Output
Circuit
V SS
RTN
Adapter
Option 1
Adapter
Option 2
Adapter
Option 3
Figure 23. ORing Configurations
The IEEE standards require that the Ethernet cable be isolated from ground and all other system potentials. The
adapter must meet a minimum 1500 Vac dielectric withstand test between the output and all other connections
for ORing options 1 and 2. The adapter only needs this isolation for option 3 if it is not provided by the converter.
Adapter ORing diodes are shown for all the options to protect against a reverse voltage adapter, a short on the
adapter input pins, and damage to a low-voltage adapter. ORing is sometimes accomplished with a MOSFET in
option 3.
PPD ORing Features
The TPS23757 provides several additional features for the ORing based on the multifunction PPD pin. These
include APb signaling of an option 1 adapter, use of a 24 V adapter (reduced output power) for option 1, and use
of PoE as a power backup in conjunction with option 2. See the Advanced ORing Techniques section.
Using DEN to disable PoE
The DEN pin may be used to turn the PoE hotswap switch OFF by pulling it to V SS while in the operational state,
or to prevent detection when in the idle state. A low on DEN forces the hotswap MOSFET OFF during normal
operation. Additional information is available in Advanced Adapter ORing Solutions using the TPS23753
(literature number SLVA306 ).
ORing Challenges
Preference of one power source presents a number of challenges. Combinations of adapter output voltage
(nominal and tolerance), power insertion point, and which source is preferred determine solution complexity.
Several factors adding to the complexity are the natural high-voltage selection of diode ORing (the simplest
method of combining sources), the current limit implicit in the PSE, and PD inrush and protection circuits
(necessary for operation and reliability). Creating simple and seamless solutions is difficult if not impossible for
many of the combinations. However the TPS23757 offers several built-in features that simplify some
combinations.
22
Submit Documentation Feedback
Copyright ? 2009–2013, Texas Instruments Incorporated
相关PDF资料 |
PDF描述 |
|---|---|
| GRM188F51H473ZA01D | CAP CER 0.047UF 50V Y5V 0603 |
| 5748481-6 | CONN D-SUB RCPT R/A 26POS GOLD |
| T95R337M016HSAL | CAP TANT 330UF 16V 20% 2824 |
| ESC49DRTI | CONN EDGECARD 98POS DIP .100 SLD |
| RBA10DTMH | CONN EDGECARD 20POS R/A .125 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS2375D | 功能描述:热插拔功率分布 IEEE 802.3af PoE Pwr Device Cntrler RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| TPS2375D | 制造商:Texas Instruments 功能描述:POWER OVER ETHERNET ((NW)) |
| TPS2375DG4 | 功能描述:热插拔功率分布 IEEE 802.3af PoE Pwr Device Cntrler RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| TPS2375DR | 功能描述:热插拔功率分布 IEEE 802.3af PoE Pwr Device Cntrler RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| TPS2375DRG4 | 功能描述:热插拔功率分布 IEEE 802.3af PoE Pwr Device Cntrler RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。