- 您现在的位置：买卖IC网 > PDF目录20011 > TPS23757PWR (Texas Instruments)IC POE INTERFACE SWITCH 20TSSOP PDF资料下载
参数资料
| 型号： | TPS23757PWR |
| 厂商： | Texas Instruments |
| 文件页数： | 29/39页 |
| 文件大小： | 0K |
| 描述： | IC POE INTERFACE SWITCH 20TSSOP |
| 标准包装： | 2,000 |
| 类型： | 以太网供电开关（PoE） |
| 应用： | 远程外设（工业控制，相机，数据访问） |
| 内部开关： | 是 |
| 电流限制： | 465mA |
| 电源电压： | 0 V ~ 57 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 20-TSSOP |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页当前第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页
TPS23757
www.ti.com
SLVS948D – JULY 2009 – REVISED NOVEMBER 2013
5 - 0.4
(a)
I APb =
V OUT - V APb (low)
R APb
= = 0.46 mA
10000
3. The optocoupler CTR will be needed to determine R APb . A device with a minimum CTR of 300% at 5 mA
LED bias current is selected. CTR will also vary with temperature and LED bias current. The strong variation
of CTR with diode current makes this a problem that requires some iteration using the CTR versus I DIODE
curve on the optocoupler data sheet.
(a) Using the (normalized) curves, a current of 0.4 mA to 0.5 mA is required to support the output current at
the minimum CTR at 25°C.
(a) Pick an I DIODE . For example one around the desired load current.
(b) Use the optocoupler datasheet curve to determine the effective CTR at this operating current. It is
usually necessary to apply the normalized curve value to the minimum specified CTR. It might be
necessary to ratio or offset the curve readings to obtain a value that is relative to the current that the
CTR is specified at.
(c) If I DIODE × CTR I_DIODE is substantially different from I RAPb_OUT , choose another I DIODE and repeat.
(b) This manufacturer’s curves also indicate a –20% variation of CTR with temperature. The approximate
forward voltage of the optocoupler diode is 1.1 V from the data sheet.
I APb @ I MIN ′ = 0.5 mA ′
100 100
100 - D CTR TEMP 100 - 20
= 0.625 mA
I APb
(c) V FLED ? 1.1 V
V C - V APb - V FLED 12 - 1 - 1.1
R APb = = = 15.48 k W
0.625 mA
(d) Select a 15.4 k ? resistor. Even though the minimum CTR and temperature variation were considered,
the designer might choose a smaller resistor for a little more margin.
Advanced ORing Techniques
See Advanced Adapter ORing Solutions using the TSP23753 , TI literature number SLVA306A for ORing
applications that also work with the TPS23757. The material in sections Adapter ORing and Protection, D1 are
important to consider as well. The following applications are supported with the introduction of PPD.
Option 2 ORing with PoE acting as a hot backup is eased by connecting PPD to V DD per Figure 29 . This PPD
connection enables the class regulator even when APD is high. The R-Zener network (1.8 k ? – 24 V) is the
simplest circuit that will satisfy MPS requirements, keeping the PSE online. This network may be switched out
when APD is not powered with an optocoupler. This works best with a 48-V adapter and the APD-programmed
threshold as high as possible. An example of an adapter priority application with smooth switchover between a
48 V adapter and PoE is shown on the right side of Figure 29 . D APD is used to reduce the effective APD
hysteresis, allowing the PSE to power the load before V VDD1 - V RTN falls too low and causes a hotswap foldback.
C VDD
10nF
D VDD
D VDD
PPD
DEN
For 48V
Adapter
PPD
DEN
D A
CLS
V SS
C IN
CLS
V SS
C IN
D A
Adapter
R APD1
APD
Figure 29. Option 2 PoE Backup ORing
APD
Adapter
Copyright ? 2009–2013, Texas Instruments Incorporated
Submit Documentation Feedback
29
相关PDF资料 |
PDF描述 |
|---|---|
| GRM188F51H473ZA01D | CAP CER 0.047UF 50V Y5V 0603 |
| 5748481-6 | CONN D-SUB RCPT R/A 26POS GOLD |
| T95R337M016HSAL | CAP TANT 330UF 16V 20% 2824 |
| ESC49DRTI | CONN EDGECARD 98POS DIP .100 SLD |
| RBA10DTMH | CONN EDGECARD 20POS R/A .125 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS2375D | 功能描述:热插拔功率分布 IEEE 802.3af PoE Pwr Device Cntrler RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| TPS2375D | 制造商:Texas Instruments 功能描述:POWER OVER ETHERNET ((NW)) |
| TPS2375DG4 | 功能描述:热插拔功率分布 IEEE 802.3af PoE Pwr Device Cntrler RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| TPS2375DR | 功能描述:热插拔功率分布 IEEE 802.3af PoE Pwr Device Cntrler RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| TPS2375DRG4 | 功能描述:热插拔功率分布 IEEE 802.3af PoE Pwr Device Cntrler RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。