- 您现在的位置：买卖IC网 > PDF目录98280 > TPS2390DGKR (TEXAS INSTRUMENTS INC) 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 PDF资料下载
参数资料
| 型号： | TPS2390DGKR |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 电源管理 |
| 英文描述： | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| 封装： | GREEN, PLASTIC, MSOP-8 |
| 文件页数： | 4/20页 |
| 文件大小： | 497K |
| 代理商： | TPS2390DGKR |
TPS2390
TPS2391
SLUS471D JUNE 2002 REVISED JANUARY 2008
12
www.ti.com
APPLICATION INFORMATION
In response to a latched fault condition, the TPS2391 enters a fault retry mode, wherein it periodically retries
the load to test for continued existence of the fault. In this mode, the FLTTIME capacitor is discharged slowly
by a about a 0.4-
A constant-current sink. When the voltage at the FLTTIME pin decays below 0.5 V, the LCA
and RAMP CONTROL circuits are re-enabled, and a normal turn-on current ramp ensues. Again, during the
load charging, the OC signal causes charging of the FLTTIME capacitor until the next delay period elapses. The
sequential charging and discharging of the FLTTIME capacitor results in a typical 1% retry duty cycle. If the fault
subsides (GATE pin drives to high-level output), the timing capacitor is rapidly discharged, duty-cycle operation
stops, and the fault latch is reset.
Note that because of the timing inhibit during the initial slow ramp period, the duty cycle in practice is slightly
greater than the nominal 1% value. However, sourced current during this period peaks at only about one-eighth
the maximum limit. The duty cycle of the normal ramp and constant-current periods is approximately 1%.
The FAULT LOGIC within the TIMER BLOCK automatically manages capacitor charge and discharge rates
(DCHG signal), and the enabling of the GATE output (ON signal). For the TPS2391, the FAULT output remains
asserted continuously during retry mode; it is only released if the fault condition clears.
These hot swap controllers contain an OVERLOAD COMPARATOR which also monitors the ISENS voltage.
If sense voltage excursions above 100 mV are detected, the fault is latched, LCA disabled, and the FET gate
is rapidly pulled down, bypassing the fault timer. The timer block does apply a 4-
s deglitch filter to the OL signal
to help reduce nuisance trips. As with overcurrent faults, the TPS2390 latches the output off. For the TPS2391,
an overload fault causes charging of the timer capacitor, to initiate fault retry timing.
setting the sense resistor value
Due to the current-limiting action of the internal LCA, the maximum allowable load current for an implementation
is easily programmed by selecting the appropriate sense resistor value. The LCA acts to limit the sense voltage
VI(ISENS) to its internal reference. Once the voltage at the IRAMP pin exceeds approximately 4 V, this limit is
the clamp voltage, VREF_K. Therefore, a maximum sense resistor value can be determined from equation (1).
R
SENSE v
33 mV
IMAX
where:
R
SENSE is the resistor value, and
IMAX is the desired current limit.
(1)
相关PDF资料 |
PDF描述 |
|---|---|
| TPS2390DGKRG4 | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| TPS2391DGKRG4 | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| TPS2390DGK | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| TPS2393APWRG4 | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO14 |
| TPS2421-1DDAR | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS2390DGKRG4 | 功能描述:热插拔功率分布 Simple-48V Hot Swap Controller RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| TPS2390EVM | 功能描述:电源管理IC开发工具 Simple -48V Hot Swap Contr EVM RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| TPS2391DGK | 功能描述:热插拔功率分布 Simple-48V Hot Swap Controller RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| TPS2391DGKG4 | 功能描述:热插拔功率分布 Simple-48V Hot Swap Controller RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| TPS2391DGKR | 功能描述:热插拔功率分布 Simple-48V Hot Swap Controller RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。