- 您现在的位置：买卖IC网 > PDF目录98280 > TPS2390DGKR (TEXAS INSTRUMENTS INC) 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 PDF资料下载
参数资料
| 型号： | TPS2390DGKR |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 电源管理 |
| 英文描述： | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| 封装： | GREEN, PLASTIC, MSOP-8 |
| 文件页数： | 5/20页 |
| 文件大小： | 497K |
| 代理商： | TPS2390DGKR |
TPS2390
TPS2391
SLUS471D JUNE 2002 REVISED JANUARY 2008
13
www.ti.com
APPLICATION INFORMATION
When setting the sense resistor value, it is important to consider two factors, the minimum current that may be
imposed by the TPS2390 or TPS2391, and the maximum load under normal operation of the module. For the
first factor, the specification minimum clamp value is used, as seen in equation (1). This method accounts for
the tolerance in the sourced current limit below the typical level expected (40 mV/RSENSE). (The clamp
measurement includes LCA input offset voltage; therefore, this offset does not have to be factored into the
current limit again.) Second, if the load current varies over a range of values under normal operating conditions,
then the maximum load level must be allowed for by the value of RSENSE. One example of this is when the load
is a switching converter, or brick, which draws higher input current, for a given power output, when the
distribution bus is at the low end of its operating range, with decreasing draw at higher supply voltages. To avoid
current-limit operation under normal loading, some margin should be designed in between this maximum
anticipated load and the minimum current limit level, or IMAX > ILOAD(max), for equation (1).
For example, using a 20-m
sense resistor for a nominal 1-A load application provides a minimum of 650 mA
of overhead for load variance/margin. Typical bulk capacitor charging current during turn-on is 2 A
(40 mV/20 m
).
setting the inrush slew rate
The TPS2390 and TPS2391 devices enable user-programming of the maximum current slew rate during load
start-up events. A capacitor tied to the IRAMP pin (C2 in the typical application diagram) controls the di/dt rate.
Once the sense resistor value has been established, a value for ramp capacitor CIRAMP, in microfarads, can be
determined from equation (2).
C
IRAMP +
11
100
R
SENSE
di
dt MAX
where:
R
SENSE is in ohms, and
(di/dt)
MAX is the desired maximum slew rate, in amps/second.
For example, if the desired slew rate for the typical application shown is 1500 mA/ms, the calculated value for
CIRAMP is about 3700 pF. Selecting the next larger standard value of 3900 pF (as shown in the diagram) provides
some margin for capacitor and sense resistor tolerances.
As described earlier in this section, the TPS2390 and TPS2391 initiate ramp capacitor charging, and
consequently, load current di/dt at a reduced rate. This reduced rate applies until the voltage on the IRAMP pin
is about 0.5 V. The maximum di/dt rate, as set by equation (2), is effective once the device has switched to the
10-
A charging source.
(2)
相关PDF资料 |
PDF描述 |
|---|---|
| TPS2390DGKRG4 | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| TPS2391DGKRG4 | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| TPS2390DGK | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| TPS2393APWRG4 | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO14 |
| TPS2421-1DDAR | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS2390DGKRG4 | 功能描述:热插拔功率分布 Simple-48V Hot Swap Controller RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| TPS2390EVM | 功能描述:电源管理IC开发工具 Simple -48V Hot Swap Contr EVM RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| TPS2391DGK | 功能描述:热插拔功率分布 Simple-48V Hot Swap Controller RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| TPS2391DGKG4 | 功能描述:热插拔功率分布 Simple-48V Hot Swap Controller RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| TPS2391DGKR | 功能描述:热插拔功率分布 Simple-48V Hot Swap Controller RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。