- 您现在的位置：买卖IC网 > PDF目录69509 > TPS40052PWP (TEXAS INSTRUMENTS INC) SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 PDF资料下载
参数资料
| 型号： | TPS40052PWP |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封装： | GREEN, PLASTIC, HTSSOP-16 |
| 文件页数： | 3/33页 |
| 文件大小： | 753K |
| 代理商： | TPS40052PWP |
第1页第2页当前第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页
TPS40052
SLUS563C AUGUST 2003 REVISED FEBRUARY 2005
11
www.ti.com
APPLICATION INFORMATION
PROGRAMMING SOFT START
TPS40052 uses a closed-loop approach to ensure a controlled ramp on the output during start-up. Soft-start
is programmed by charging an external capacitor (CSS) via an internally generated current source. The voltage
on CSS is fed into a separate non-inverting input to the error amplifier (in addition to FB and EA_REF). The loop
is closed on the lower of the CSS voltage or the the external reference voltage EA_REF. Once the CSS voltage
rises above the external reference voltage, regulation is based on the external reference. To ensure a controlled
ramp-up of the output voltage the soft-start time should be greater than the L-CO time constant as described
in equation (9).
t
START w 2p
L
C
O
(seconds)
There is a direct correlation between tSTART and the input current required during start-up. The faster tSTART,
the higher the input current required during start-up. This relationship is describe in more detail in the section
titled, Programming the Current Limit which follows. The soft-start capacitance, CSS, is described in
equation (10).
For applications in which the VIN supply ramps up slowly, (typically between 50 ms and 100 ms) it may be
necessary to increase the soft-start time to between approximately 2 ms and 5 ms to prevent nuisance UVLO
tripping. The soft-start time should be longer than the time that the VIN supply transitions between 8 V and 9 V.
C
SS +
2.3
mA
0.7 V
t
START
(Farads)
PROGRAMMING CURRENT LIMIT
The TPS40052 uses a two-tier approach for overcurrent protection. The first tier is a pulse-by-pulse protection
scheme. Current limit is implemented on the high-side MOSFET by sensing the voltage drop across the
MOSFET when the gate is driven high. The MOSFET voltage is compared to the voltage dropped across a
resistor connected from VIN pin to the ILIM pin when driven by a constant current sink. If the voltage drop across
the MOSFET exceeds the voltage drop across the ILIM resistor, the switching pulse is immediately terminated.
The MOSFET remains off until the next switching cycle is initiated.
The second tier consists of a fault counter. The fault counter is incremented on an overcurrent pulse and
decremented on a clock cycle without an overcurrent pulse. When the counter reaches seven (7) a restart is
issued and seven soft-start cycles are initiated. Both the upper and lower MOSFETs are turned off during this
period. The counter is decremented on each soft-start cycle. When the counter is decremented to zero, the
PWM is re-enabled. If the fault has been removed the output starts up normally. If the output is still present the
counter counts seven overcurrent pulses and re-enters the second-tier fault mode. See Figure 3 for typical
overcurrent protection waveforms.
The minimum current limit setpoint (ILIM) depends on tSTART, CO, VO, and the load current at turn-on (IL).
I
LIM +
C
O
V
O
t
START
) I
L
(Amperes)
(9)
(10)
(11)
相关PDF资料 |
PDF描述 |
|---|---|
| TPS40054PWPR | SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| TPS40054PWP | SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| TPS40054PWPRG4 | SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| TPS40055PWPG4 | SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| TPS40057PWP | SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS40052PWPG4 | 功能描述:DC/DC 开关控制器 Wide Input Sync Buck Cntrlr w/DDR trking RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| TPS40052PWPR | 功能描述:DC/DC 开关控制器 Wide Input Sync Buck Cntrlr w/DDR trking RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| TPS40052PWPRG4 | 功能描述:DC/DC 开关控制器 Wide Input Sync Buck Cntrlr w/DDR trking RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| TPS40053 | 制造商:TI 制造商全称:Texas Instruments 功能描述:WIDE-INPUT SYNCHRONOUS BUCK CONTROLLER |
| TPS40053PWP | 功能描述:DC/DC 开关控制器 Wide Input Vltg Synch Buck Cntrlr RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
发布紧急采购，3分钟左右您将得到回复。