- 您现在的位置：买卖IC网 > PDF目录68613 > TPS40060PWPG4 (TEXAS INSTRUMENTS INC) SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 PDF资料下载
参数资料
| 型号： | TPS40060PWPG4 |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封装： | GREEN, PLASTIC, HTSOOP-16 |
| 文件页数： | 3/33页 |
| 文件大小： | 750K |
| 代理商： | TPS40060PWPG4 |
第1页第2页当前第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页
www.ti.com
PROGRAMMING CURRENT LIMIT
I
LIM +
C
O
V
O
t
SS
) IL (A)
(6)
R
ILIM +
I
OC
R
DS(on)[max]
I
SINK
)
V
OS
I
SINK
(W)
(7)
BP5, BPN10 AND BPN10 INTERNAL VOLTAGE REGULATOR
SLUS543E – DECEMBER 2002 – REVISED JUNE 2006
APPLICATION INFORMATION (continued)
This device uses a two-tier approach for overcurrent protection. The first tier is a pulse-by-pulse protection
scheme. Current limit is implemented on the high-side MOSFET by sensing the voltage drop across the
MOSFET when the gate is driven low. The MOSFET voltage is compared to the voltage dropped across a
resistor connected from VIN pin to the ILIM pin when driven by a constant current sink. If the voltage drop
across the MOSFET exceeds the voltage drop across the ILIM resistor, the switching pulse is immediately
terminated. The MOSFET remains off until the next switching cycle is initiated.
The second tier consists of a fault counter. The fault counter is incremented on an overcurrent pulse and
decremented on a clock cycle without an overcurrent pulse. When the counter reaches seven (7) a restart is
issued and seven soft-start cycles are initiated. Both the upper and lower MOSFETs are turned off during this
period. The counter is decremented on each soft-start cycle. When the counter is decremented to zero, the
PWM is re-enabled. If the fault has been removed the output starts up normally. If the output is still present the
counter counts seven overcurrent pulses and re-enters the second-tier fault mode. See Figure 6 for typical
overcurrent protection waveforms.
The minimum current limit setpoint (ILIM) depends on tSTART, CO, VO, and the load current at turn-on (IL).
The current limit programming resistor (RILIM) is calculated using Equation 7. Care must be taken in choosing the
values used fro VOS and ISINK in the equation. In order to ensure the output current at the overcurrent level, the
minimum value of ISINK and the maximum value of VOS must be used.
where:
I
SINK is the current into the ILIM pin and is nominally 8.3 A, minimum
I
OC is the overcurrent setpoint which is the DC output current plus one-half of the peak inductor current
V
OS is the overcurrent comparator offset and is 50 mV maximum
Start-up characteristics of the BP5, BP10 and BPN10 regulators are shown in Figure 6. Slight variations in the
BP5 occurs dependent upon the switching frequency. Variation in the BPN10 and BP10 regulation
characteristics is also based on the load presented by switching the external MOSFETs.
11
相关PDF资料 |
PDF描述 |
|---|---|
| TPS51727RHARG4 | DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PQCC40 |
| TPS54312QPWPRQ1 | 7.5 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO20 |
| TPS54316QPWPRQ1 | 7.5 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO20 |
| TPS54315QPWPRQ1 | 7.5 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO20 |
| TPS54313QPWPRQ1 | 7.5 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO20 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS40060PWPR | 功能描述:DC/DC 开关控制器 Wide Input Freq Synch Buck Cntrlr RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| TPS40060PWPRG4 | 功能描述:DC/DC 开关控制器 Wide Input Freq Synch Buck Cntrlr RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| TPS40061 | 制造商:TI 制造商全称:Texas Instruments 功能描述:WIDE-INPUT SYNCHRONOUS BUCK CONTROLLER |
| TPS40061PWP | 功能描述:DC/DC 开关控制器 Wide Input Sync Buck Cntrlr source/sink RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| TPS40061PWP | 制造商:Texas Instruments 功能描述:IC 制造商:Texas Instruments 功能描述:IC, SYNC BUCK DC/DC CONTROLLER, 16-HTSSOP |
发布紧急采购，3分钟左右您将得到回复。