- 您现在的位置：买卖IC网 > PDF目录98281 > TPS40131RHBTG4 (TEXAS INSTRUMENTS INC) SWITCHING CONTROLLER, 1200 kHz SWITCHING FREQ-MAX, PQCC32 PDF资料下载
参数资料
| 型号： | TPS40131RHBTG4 |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | SWITCHING CONTROLLER, 1200 kHz SWITCHING FREQ-MAX, PQCC32 |
| 封装： | GREEN, PLASTIC, QFN-32 |
| 文件页数： | 4/40页 |
| 文件大小： | 940K |
| 代理商： | TPS40131RHBTG4 |
第1页第2页第3页当前第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页
www.ti.com
Overvoltage Protection, Non-Latching
Output Undervoltage Protection
Programmable Input Undervoltage Lockout Protection
Power-On Reset (POR)
Fault Masking Operation
Fault Conditions and MOSFET Control
SLVS635 – FEBRUARY 2007
FUNCTIONAL DESCRIPTION (continued)
If the overcurrent condition persists, both phases have PWM cycles terminated by the overcurrent signals. This
puts a converter in a constant current mode with the output current programmed by the ILIM voltage. A counter
is incremented for each PWM cycle in which an overcurrent event is detected. The counter is reset every 32
PWM cycles. If the counter accumulates a count of 7 before being reset, the converter enters a hiccup mode.
The HDRV and LDRV signals are set low during the hiccup mode.
The SS capacitor serves as a hiccup timing capacitor controlled by U20, the fault control circuit. The soft-start
pin is periodically charged and discharged by U20. After seven hiccup cycles, the controller attempts another
soft-start cycle to restore normal operation. If the overload condition persists, the controller returns to the hiccup
mode. This condition may continue indefinitely. In such conditions the average current delivered to the load is
approximately 1/8 of the set overcurrent value.
The voltage on OVSET is compared with 0.817 V, 16% higher than VREF, in U25 to determine the output
overvoltage point. When an overvoltage is detected, the output drivers command the upper MOSFETs off and
the lower MOSFETs on. If the overvoltage condition has been cleared, the output comes up and normal
operation continues. Turning the lower MOSFET on may cause the output to reach an undervoltage condition
and enter the hiccup mode. Using a voltage divider with the same ratio, that sets the output voltage, an output
overvoltage is declared when the output rises 16% above nominal.
If the output voltage, as sensed by U19 on the FB pin becomes less than 0.588 V, the undervoltage protection
threshold (84% of VREF), the controller enters the hiccup mode.
A voltage divider that sets 1V on the UVLO pin determines when the controller starts operating. Operation
commences when the voltage on the UVLO pin exceeds 1.0 V. If the voltage on the UVLO pin falls to 0.81 V,
the controller is turned off and the HDRV and LDRV signals are set low.
The power-on reset (POR) function, U22, insures the VIN5 and BP5 voltages are within their regulation windows
before the controller is allowed to start.
If the SS pin voltage is externally limited below the 1-V threshold, the controller does not respond to most faults
and the PGOOD output is always low. Only the overcurrent function remains active. The overcurrent protection
still continues to terminate PWM cycle every time when the threshold is exceeded but the hiccup mode is not
entered.
Table 1 shows a summary of the fault conditions and the state of the MOSFETs.
Table 1. Fault Condifions
FAULT MODE
UPPER MOSFET
LOWER MOSFET
EN/SYNC = LOW
OFF
FIXED UVLO, VBP5 < 4.25 V
OFF
Programmable UVLO, < 1.0 V
OFF
Output undervoltage
OFF, Hiccup mode
Output overvoltage
OFF
ON
Output overcurrent
OFF, Hiccup mode
12
相关PDF资料 |
PDF描述 |
|---|---|
| TPS40131RHBR | SWITCHING CONTROLLER, 1200 kHz SWITCHING FREQ-MAX, PQCC32 |
| TPS40132RHBR | 40 A SWITCHING CONTROLLER, 1200 kHz SWITCHING FREQ-MAX, PQCC32 |
| TPS40197RGYR | SWITCHING CONTROLLER, 520 kHz SWITCHING FREQ-MAX, PQCC16 |
| TPS40200MDREPG4 | SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO8 |
| TPS40211DRCTG4 | SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO10 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS40132 | 制造商:TI 制造商全称:Texas Instruments 功能描述:TWO-PHASE, SYNCHRONOUS BUCK CONTROLLER WITH INTEGRATED MOSFET DRIVERS |
| TPS40132RHBR | 功能描述:DC/DC 开关控制器 2Ch Multiphase Cntrlr RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| TPS40132RHBRG4 | 功能描述:DC/DC 开关控制器 2Ch Multiphase Cntrlr RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| TPS40132RHBT | 功能描述:DC/DC 开关控制器 2Ch Multiphase Cntrlr RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| TPS40132RHBTG4 | 功能描述:DC/DC 开关控制器 2Ch Multiphase Cntrlr RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
发布紧急采购，3分钟左右您将得到回复。