- 您现在的位置：买卖IC网 > PDF目录69509 > TPS40190DRCRG4 (TEXAS INSTRUMENTS INC) SWITCHING CONTROLLER, 360 kHz SWITCHING FREQ-MAX, PDSO10 PDF资料下载
参数资料
| 型号： | TPS40190DRCRG4 |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | SWITCHING CONTROLLER, 360 kHz SWITCHING FREQ-MAX, PDSO10 |
| 封装： | 3 X 3 MM, GREEN, PLASTIC, SON-10 |
| 文件页数： | 2/25页 |
| 文件大小： | 615K |
| 代理商： | TPS40190DRCRG4 |
www.ti.com
VENABLE
(5 V/ div)
VCOMP
(500 mV/ div)
VOUT
(500 mV/ div)
T Time 2 ms / div
VENABLE (10 V/ div)
VLDRV (10 V/ div)
VOUT
(500 mV/ div)
VSW (10 V/ div)
T Time 20
s / div
5-V Regulator
I
G + fSW
Q
G (high) ) QG (low)
(3)
Startup Sequence and Timing
SLUS658B – JULY 2005 – REVISED AUGUST 2007
Figure 5. Startup Using ENABLE Pin
Figure 6. Shutdown Using ENABLE Pin
The TPS40190 has an on board 5-V regulator that allows the part to operate from a single voltage feed. No
separate 5-V feed to the part is required. This regulator needs to have 4.7-
F of capacitance on the BP5 pin to
guarantee stability. A ceramic capacitor is suggested for this purpose.
This regulator can also be used to supply power to nearby circuitry, eliminating the need for a separate LDO in
some cases. If this pin is used for external loads, keep in mind that this is the power supply for the internals of
the TPS40190. While efforts have been made to reduce sensitivity, any noise induced on this line has an
adverse effect on the overall performance of the internal circuitry and shows up as increased pulse jitter, or
skewed reference voltage. This regulator is turned off when the ENABLE pin is pulled low.
The amount of power available from this pin varies with the size of the power MOSFETs that the drivers must
operate. Larger MOSFETs require more gate drive current and reduces the amount of power available on this pin
for other tasks.
The total amount of current required by the gate drive and the external circuitry should not exceed 40 mA. The
current required to drive the FET gates can be found from Equation 3.
Where
I
G is the required gate drive current
f
SW is the switching frequency (300 kHz)
Q
G(high) is the gate charge requirement for the high-side FET at 5 V VGS
Q
G(low) is the gate charge requirement for the low-side FET at 5 V VGS
The TPS40190 startup sequence is as follows. After input power is applied, the 5-V onboard regulator comes up.
Once this regulator comes up, the TPS40190 goes through a period where it samples the impedance at the
COMP pin and decides the short circuit protection threshold voltage. This is accomplished by placing 400 mV on
the COMP pin for approximately 2 ms. During this time, the current is measured and compared against internal
thresholds to select the short circuit protection threshold. After this, the COMP pin is brought low for 4 ms. This
ensures that the feedback loop is preconditioned at startup and no sudden output rise occurs at the output of the
converter when the converter is allowed to start switching. After these initial 6 milliseconds, the internal soft-start
circuitry is engaged and the converter is allowed to start. See Figure 7.
10
Copyright 2005–2007, Texas Instruments Incorporated
Product Folder Link(s): TPS40190
相关PDF资料 |
PDF描述 |
|---|---|
| TPS40190DRCTG4 | SWITCHING CONTROLLER, 360 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS40192DRCRG4 | SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS40192DRCTG4 | SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS40193DRCR | SWITCHING CONTROLLER, 360 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS40195RGYR | SWITCHING CONTROLLER, 580 kHz SWITCHING FREQ-MAX, PQCC16 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS40190DRCT | 功能描述:DC/DC 开关控制器 Low Pin Count Sync Buck DC/DC Cntrlr RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| TPS40190DRCTG4 | 功能描述:DC/DC 开关控制器 Low Pin Count Sync Buck DC/DC Cntrlr RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| TPS40190EVM-001 | 功能描述:电源管理IC开发工具 Sync Buck Converter Eval Mod RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| TPS40192 | 制造商:TI 制造商全称:Texas Instruments 功能描述:4.5-V TO 18-V INPUT 10-PIN SYNCHRONOUS BUCK CONTROLLER WITH POWER GOOD |
| TPS40192_1 | 制造商:TI 制造商全称:Texas Instruments 功能描述:4.5-V TO 18-V INPUT 10-PIN SYNCHRONOUS BUCK CONTROLLER WITH POWER GOOD |
发布紧急采购，3分钟左右您将得到回复。