参数资料
型号: TPS5410MDREP
厂商: TEXAS INSTRUMENTS INC
元件分类: 稳压器
英文描述: 4.6 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, PDSO8
封装: GREEN, PLASTIC, SOIC-8
文件页数: 5/25页
文件大小: 759K
代理商: TPS5410MDREP
f
CO +
f
LC
2
85 V
OUT
C
OUT +
1
3357
L
OUT
f
CO
V
OUT
ESR
MAX +
1
2p
C
OUT
f
CO
VPP(MAX)=
()
ESR
xV
V
MAX
OUT
IN(MAX)
OUT
x
-
NC
IN(MAX)
OUT
SW
xV
xL
xF
x0.8
1
x
ICOUT(RMS) =
12
[
]
VOUT
IN(MAX)
OUT
xV
-V
VIN(MAX)
OUT
SW
xL
-F
x0.8xNC
()
www.ti.com ......................................................................................................................................................................................... SLVS910 – SEPTEMBER 2009
(7)
and the desired output capacitor value for the output filter to:
(8)
For a desired crossover of 10 kHz and a 68-
μH inductor, the calculated value for the output capacitor is 36.5 μF.
The capacitor type should be chosen so that the ESR zero is above the loop crossover. The maximum ESR is:
(9)
The maximum ESR of the output capacitor also determines the amount of output ripple as specified in the initial
design parameters. The output ripple voltage is the inductor ripple current times the ESR of the output filter.
Check that the maximum specified ESR as listed in the capacitor data sheet results in an acceptable output
ripple voltage:
(10)
Where:
ΔVPP is the desired peak-to-peak output ripple.
NC is the number of parallel output capacitors.
FSW is the switching frequency.
The minimum ESR of the output capacitor should also be considered. For a good phase margin, if the ESR is
zero when the ESR is at its minimum, it should not be above the internal compensation poles at 24 kHz and
54 kHz.
The selected output capacitor must also be rated for a voltage greater than the desired output voltage plus one
half the ripple voltage. Any derating amount must also be included. The maximum RMS ripple current in the
output capacitor is given by Equation 11:
(11)
Where:
NC is the number of output capacitors in parallel.
FSW is the switching frequency.
For this design example, a single 47-
μF output capacitor is chosen for C3. This value is close to the calculated
value of 36.5
μF and yields an actual closed loop cross over frequency of 10.05 kHz. The calculated RMS ripple
current is 84.9 mA and the maximum ESR required is 339 m
. A capacitor that meets these requirements is a
AVX TPSE476M020R0150, rated at 20 V with a maximum ESR of 150 m
and a ripple current rating of 1.369 A.
This capacitor results in a peak-to-peak output ripple of 44 mV using equation 10. An additional small 0.1-
μF
ceramic bypass capacitor may also used, but is not included in this design.
Other capacitor types can be used with the TPS5410, depending on the needs of the application.
Output Voltage Setpoint
The output voltage of the TPS5410 is set by a resistor divider (R1 and R2) from the output to the VSENSE pin.
Calculate the R2 resistor value for the output voltage of 12 V using Equation 12:
Copyright 2009, Texas Instruments Incorporated
13
Product Folder Link(s): TPS5410-EP
相关PDF资料
PDF描述
TPS54429ERSAT 0.01 A SWITCHING REGULATOR, PQCC16
TPS60201DGSRG4 SWITCHED CAPACITOR REGULATOR, 400 kHz SWITCHING FREQ-MAX, PDSO10
TPS62000 "Adjustable
TPS65166RHAR SPECIALTY ANALOG CIRCUIT, PQCC40
TPS65270RGET DUAL SWITCHING CONTROLLER, 1400 kHz SWITCHING FREQ-MAX, PQCC24
相关代理商/技术参数
参数描述
TPS5410-Q1 制造商:TI 制造商全称:Texas Instruments 功能描述:1-A, WIDE INPUT RANGE, STEP-DOWN SWIFTa?¢ CONVERTER
TPS5410QDRQ1 功能描述:直流/直流开关调节器 AC 5.5-36V,1A,500kHz RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5
TPS54110 制造商:TI 制造商全称:Texas Instruments 功能描述:SWIFT Converter Product Portfolio
TPS54110EVM-044 功能描述:电源管理IC开发工具 3-6Vin DC/DC Conv RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V
TPS54110EVM-044 制造商:Texas Instruments 功能描述:EVAL BOARD, TPS54110 ADJ 1.5A STEP-DOWN