- 您现在的位置：买卖IC网 > PDF目录69511 > TPS54331QDRQ1 (TEXAS INSTRUMENTS INC) 2 A SWITCHING REGULATOR, 684 kHz SWITCHING FREQ-MAX, PDSO8 PDF资料下载
参数资料
| 型号： | TPS54331QDRQ1 |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | 2 A SWITCHING REGULATOR, 684 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封装： | GREEN, PLASTIC, DSO-8 |
| 文件页数： | 6/25页 |
| 文件大小： | 735K |
| 代理商： | TPS54331QDRQ1 |
(
)
OPPMAX
max
LPP
SW
O
D
0.5
V
ESR
=
I
4
F
C
-
(
)
12
OUT
IN(MAX)
OUT
COUT(RMS)
IN(MAX)
OUT
SW
C
V
× V
V
1
I
=
×
V
× L
× F
× N
-
÷
÷
è
ggm
REF
DC
O
V
G
=
V
(
)
PO
OO
Z
V
= 1/ 2
R
C
p
(
)
Z1
Z
F
= 1/ 2
R
C
p
(
)
P1
Z
P
F
= 1/ 2
R
C
p
SLVSAB5 – NOVEMBER 2010
www.ti.com
The maximum ESR of the output capacitor can be determined from the amount of allowable output ripple as
specified in the initial design parameters. The contribution to the output ripple voltage due to ESR is the inductor
ripple current times the ESR of the output filter, so the maximum specified ESR as listed in the capacitor data
sheet is given by Equation 13
(13)
Where VOPPMAX is the desired maximum peak-to-peak output ripple. The maximum RMS ripple current in the
output capacitor is given by Equation 14.
(14)
For this design example, two 47-mF ceramic output capacitors are chosen for C8 and C9. These are TDK
C3216X5R0J476MT, rated at 6.3 V with a maximum ESR of 2 m
and a ripple current rating in excess of 3 A.
The calculated total RMS ripple current is 161 mA ( 80.6 mA each) and the maximum total ESR required is 43
m
. These output capacitors exceed the requirements by a wide margin and will result in a reliable,
high-performance design. it is important to note that the actual capacitance in circuit may be less than the
catalog value when the output is operating at the desired output of 3.3 V The selected output capacitor must be
rated for a voltage greater than the desired output voltage plus the ripple voltage. Any derating amount must
also be included. Other capacitor types work well with the TPS54331, depending on the needs of the application.
COMPENSATION COMPONENTS
The external compensation used with the TPS54331 allows for a wide range of output filter configurations. A
large range of capacitor values and types of dielectric are supported. The design example uses ceramic X5R
dielectric output capacitors, but other types are supported.
A Type II compensation scheme is recommended for the TPS54331. The compensation components are chosen
to set the desired closed loop cross over frequency and phase margin for output filter components. The type II
compensation has the following characteristics; a dc gain component, a low frequency pole, and a mid frequency
zero / pole pair.
The dc gain is determined by Equation 15:
(15)
Where:
Vggm = 800
VREF = 0.8 V
The low-frequency pole is determined by Equation 16:
(16)
The mid-frequency zero is determined by Equation 17:
(17)
And, the mid-frequency pole is given by Equation 18:
(18)
The first step is to choose the closed loop crossover frequency. In general, the closed-loop crossover frequency
should be less than 1/8 of the minimum operating frequency, but for the TPS54331it is recommended that the
maximum closed loop crossover frequency be not greater than 25 kHz. Next, the required gain and phase boost
of the crossover network needs to be calculated. By definition, the gain of the compensation network must be the
inverse of the gain of the modulator and output filter. For this design example, where the ESR zero is much
higher than the closed loop crossover frequency, the gain of the modulator and output filter can be approximated
by Equation 19:
14
Copyright 2010, Texas Instruments Incorporated
Product Folder Link(s): TPS54331-Q1
相关PDF资料 |
PDF描述 |
|---|---|
| TPS54332DDAR | SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PDSO8 |
| TPS54350PWPR | 6.5 A SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO16 |
| TPS54350PWP | 6.5 A SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO16 |
| TPS54355PWPRG4 | 6.5 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, PDSO16 |
| TPS54353PWPR | 6.5 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, PDSO16 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS54332 | 制造商:TI 制造商全称:Texas Instruments 功能描述:3.5A, 28V, 1MHz, STEP DOWN DC/DC CONVERTER WITH Eco-modea?￠ |
| TPS54332DDA | 功能描述:直流/直流开关调节器 DC/DC Converter with Eco-mode RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| TPS54332DDAR | 功能描述:直流/直流开关转换器 DC/DC Converter with Eco-mode RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| TPS54332EVM-416 | 功能描述:电源管理IC开发工具 5-15V,3A,SWIFT Buck Converter Eval Mod RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| TPS54334DDA | 功能描述:Buck Switching Regulator IC Positive Adjustable 0.8V 1 Output 3A 8-PowerSOIC (0.154", 3.90mm Width) 制造商:texas instruments 系列:- 包装:管件 零件状态:有效 功能:降压 输出配置:正 拓扑:降压 输出类型:可调式 输出数:1 电压 - 输入（最小值）:4.2V 电压 - 输入（最大值）:28V 电压 - 输出（最小值/固定）:0.8V 电压 - 输出（最大值）:24V 电流 - 输出:3A 频率 - 开关:570kHz 同步整流器:是 工作温度:-40°C ~ 150°C（TJ） 安装类型:表面贴装 封装/外壳:8-PowerSOIC（0.154"，3.90mm 宽） 供应商器件封装:8-SO PowerPad 标准包装:75 |
发布紧急采购，3分钟左右您将得到回复。