- 您现在的位置：买卖IC网 > PDF目录150839 > TPS5633PWP (TEXAS INSTRUMENTS INC) 2 A SWITCHING CONTROLLER, 200 kHz SWITCHING FREQ-MAX, PDSO28 PDF资料下载
参数资料
| 型号： | TPS5633PWP |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | 2 A SWITCHING CONTROLLER, 200 kHz SWITCHING FREQ-MAX, PDSO28 |
| 封装： | GREEN, PLASTIC, HTSSOP-28 |
| 文件页数： | 24/28页 |
| 文件大小： | 568K |
| 代理商： | TPS5633PWP |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页当前第24页第25页第26页第27页第28页
TPS5615, TPS5618, TPS5625, TPS5633
SYNCHRONOUS-BUCK HYSTERETIC REGULATOR CONTROLLER
SLVS177B SEPTEMBER 1998 REVISED JULY 2000
5
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
detailed description (continued)
current sensing
Current sensing is achieved by sampling and holding the voltage across the high-side power FET while the
high-side FET is on. The sampling network consists of an internal 60-
Ω switch and an external ceramic hold
capacitor. Recommended value of the hold capacitor is between 0.033
μF and 0.1 μF. The actual value should
give a time constant (60
Ω × CH) greater than the FET on time. Internal logic controls the turn-on and turn-off
of the sample/hold switch such that the switch does not turn on until the Vphase voltage transitions high, and
the switch turns off when the input to the high-side driver goes low. Thus sampling will occur only when the high
side FET is conducting current. The voltage on the IOUT pin equals 2 times the sensed high-side voltage. In
applications where a higher accuracy in current-sensing is required, a sense resistor can be placed in series
with the high-side FET and the voltage across the sense resistor can be sampled by the current sensing circuit.
See Figures 2 and 3.
overcurrent protection
The overcurrent protection (OCP) circuit monitors the current through the high-side FET. The overcurrent
threshold is adjustable with an external resistor divider between IOUT and ANAGND, with the divider voltage
connected to OCP. If the voltage on OCP (VS) exceeds 100 mV, then a fault latch is set and the output drivers
are turned off. The latch will remain set until VCC goes below the undervoltage lockout value. A 3-μs deglitch
timer is included for noise immunity. The OCP circuit is also designed to protect the high-side power FET against
a short-to-ground fault on the terminal common to both power FETs (Vphase).
R1
+
R2
V
S
–0.05
0.05
Figure 2. OCP Using FET ON-Resistance
Figure 3. Precision OCP Using External Resistor
R1
+
R2
V
S
–0.05
0.05
R2
2 * VS
OCP
TPS56xx
R1
IOUT
IOUTLO
HISENSE
LOSENSE
HIGHDR
VCC
VP
CH
VS
R2
2 * VS
OCP
TPS56xx
R1
IOUT
IOUTLO
HISENSE
LOSENSE
HIGHDR
VCC
VP
CH
VS
RS
inhibit
INHIBIT is a TTL-compatible digital input used to enable the controller. When INHIBIT is low, the output drivers
are low and the slowstart capacitor is discharged. When INHIBIT goes high, the short across the slowstart
capacitor is released and normal converter operation begins. When the system-logic supply is connected to
INHIBIT, it also controls power sequencing by locking out controller operation until the system-logic supply
exceeds the input threshold voltage of the inhibit circuit. Thus the 12-V supply and the system-logic supply
(either 5 V or 3.3 V) must be above UVLO thresholds before the controller is allowed to start up. The INHIBIT
comparator start threshold is 2.1 V and the hysteresis is 100 mV.
相关PDF资料 |
PDF描述 |
|---|---|
| TC74A0-3.3VAT | SPECIALTY ANALOG CIRCUIT, PSFM5 |
| TC74A7-3.3VAT | SPECIALTY ANALOG CIRCUIT, PSFM5 |
| TS3431CIZ-AP | 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 1.24 V, PBCY3 |
| TX10005JASLPLDH | 1-OUTPUT 1000 W AC-DC PWR FACTOR CORR MODULE |
| TB6526AF | STEPPER MOTOR CONTROLLER, 0.12 A, PDSO24 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS5633PWPG4 | 功能描述:DC/DC 开关控制器 High Crnt Synch Buck Cntrlr RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| TPS5633PWPR | 功能描述:DC/DC 开关控制器 High Crnt Synch Buck Cntrlr RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| TPS5633PWPRG4 | 功能描述:DC/DC 开关控制器 High Crnt Synch Buck Cntrlr RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| TPS563900DAPR | 功能描述:Buck Switching Regulator IC Positive Adjustable (Programmable) 0.68V 2 Output 3.5A 32-TSSOP (0.240", 6.10mm Width) Exposed Pad 制造商:texas instruments 系列:- 包装:剪切带（CT） 零件状态:有效 功能:降压 输出配置:正 拓扑:降压 输出类型:可调节（可编程） 输出数:2 电压 - 输入（最小值）:4.5V 电压 - 输入（最大值）:18V 电压 - 输出（最小值/固定）:0.68V 电压 - 输出（最大值）:1.95V 电流 - 输出:3.5A 频率 - 开关:200kHz ~ 1.6MHz 同步整流器:是 工作温度:-40°C ~ 85°C（TA） 安装类型:表面贴装 封装/外壳:32-TSSOP（0.240"，6.10mm 宽）裸焊盘 供应商器件封装:32-HTSSOP 标准包装:1 |
| TPS564201DDCR | 功能描述:IC REG BUCK ADJ 4A SYNC 6SOT 制造商:texas instruments 系列:D-CAP2?? 包装:剪切带（CT） 零件状态:在售 功能:降压 输出配置:正 拓扑:降压 输出类型:可调式 输出数:1 电压 - 输入（最小值）:4.5V 电压 - 输入（最大值）:17V 电压 - 输出（最小值/固定）:0.76V 电压 - 输出（最大值）:7V 电流 - 输出:4A 频率 - 开关:560kHz 同步整流器:是 工作温度:-40°C ~ 125°C （TJ） 安装类型:表面贴装 封装/外壳:SOT-23-6 细型，TSOT-23-6 供应商器件封装:SOT-23-6 标准包装:1 |
发布紧急采购，3分钟左右您将得到回复。