- 您现在的位置：买卖IC网 > PDF目录98283 > TPS60251RTWR (TEXAS INSTRUMENTS INC) SWITCHED CAPACITOR CONVERTER, 750 kHz SWITCHING FREQ-MAX, PQCC24 PDF资料下载
参数资料
| 型号： | TPS60251RTWR |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | SWITCHED CAPACITOR CONVERTER, 750 kHz SWITCHING FREQ-MAX, PQCC24 |
| 封装： | 4 X 4 MM, GREEN, PLASTIC, QFN-24 |
| 文件页数： | 5/26页 |
| 文件大小： | 783K |
| 代理商： | TPS60251RTWR |
www.ti.com
I
AUX(100%) +
1.254
R
IS
) 1.276
10*6
8000
3.5
10*6
10
(3)
I
AUX(70%) +
1.254
R
IS
) 1.276
10*6
6000
3.5
10*6
9.333
(4)
I
AUX(40%) +
1.254
R
IS
) 1.276
10*6
4000
3.5
10*6
8
(5)
I
AUX(20%) +
1.254
R
IS
) 1.276
10*6
2000
3.5
10*6
8
(6)
SERIAL INTERFACE
Dataline
stable;
datavalid
DATA
CLK
Change
ofdata
allowed
SLVS767C – APRIL 2007 – REVISED NOVEMBER 2007
RIS also affects the current for the auxiliary application. The four current levels (20%, 40%, 70%, and 100%) are
determined by the following equations:
The serial interface is compatible with the standard and fast mode I2C specifications, allowing transfers at up to
400 kHz. The interface adds flexibility to the WLED driver solution, enabling most functions to be programmed to
new values depending on the instantaneous application requirements. Register contents remain intact as long as
VCC remains above UVLO2 (typical 1.3V) and ENA is high.
For normal data transfer, DATA is allowed to change only when CLK is low. Changes when CLK is high are
reserved for indicating the start and stop conditions. During data transfer, the data line must remain stable
whenever the clock line is high. There is one clock pulse per bit of data. Each data transfer is initiated with a start
condition and terminated with a stop condition. When addressed, the TPS60251 device generates an
acknowledge bit after the reception of each byte. The master device (microprocessor) must generate an extra
clock pulse that is associated with the acknowledge bit. The TPS60251 device must pull down the DATA line
during the acknowledge clock pulse so that the DATA line is a stable low during the high period of the
acknowledge clock pulse. Setup and hold times must be taken into account. During read operations, a master
must signal the end of data to the slave by not generating an acknowledge bit on the last byte that was clocked
out of the slave. In this case, the slave TPS60251 device must leave the data line high to enable the master to
generate the stop condition.
Figure 15. Bit Transfer on the Serial Interface
Copyright 2007, Texas Instruments Incorporated
13
Product Folder Link(s): TPS60251
相关PDF资料 |
PDF描述 |
|---|---|
| TPS60251RTWT | SWITCHED CAPACITOR CONVERTER, 750 kHz SWITCHING FREQ-MAX, PQCC24 |
| TPS60401DBVRG4 | SWITCHED CAPACITOR CONVERTER, 28 kHz SWITCHING FREQ-MAX, PDSO5 |
| TPS60402DBVRG4 | SWITCHED CAPACITOR CONVERTER, 70 kHz SWITCHING FREQ-MAX, PDSO5 |
| TPS61045DRBTG4 | 0.45 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO8 |
| TPS61045DRBR | 0.45 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS60251RTWRG4 | 功能描述:LED照明驱动器 High Eff Charge Pump RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
| TPS60251RTWT | 功能描述:LED照明驱动器 High Eff Charge Pump RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
| TPS60251RTWT | 制造商:Texas Instruments 功能描述:DC/DC Charge Pump Converter IC |
| TPS60251RTWTG4 | 功能描述:LED照明驱动器 High Eff Charge Pump RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
| TPS60252RTE | 制造商:TI 制造商全称:Texas Instruments 功能描述:HIGH EFFICIENCY CHARGE PUMP FOR 7 WLEDs WITH I2C INTERFACE |
发布紧急采购，3分钟左右您将得到回复。