- 您现在的位置：买卖IC网 > PDF目录98283 > TPS61045DRBR (TEXAS INSTRUMENTS INC) 0.45 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO8 PDF资料下载
参数资料
| 型号： | TPS61045DRBR |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | 0.45 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封装： | 3 X 3 MM, GREEN, PLASTIC, SON-8 |
| 文件页数： | 4/21页 |
| 文件大小： | 582K |
| 代理商： | TPS61045DRBR |
V
O +
1.233 V
1 )
R1
R2
C
FF [
1
2
p
fs
20
R1
1
D
O
P
O
P
O
s(ILOAD)
O
F
IN
I
L
V
I
ESR
C
f
V
÷
÷
=
-
+
÷
÷
+
-
÷
è
IN
P
V
I
= 375 m A +
x 100 ns
L
SLVS440B – JANUARY 2003 – REVISED MARCH 2009
www.ti.com
To reduce the overall operating quiescent current in battery powered applications a high impedance voltage
divider must be used with a typical value for R2 of
≤ 200 k and a maximum value for R1 of 2.2 M.
Some applications may not need the digital interface to program the output voltage. In this case the output DO
can be left open as shown in Figure 18 and the output voltage is calculated as for any standard boost converter:
In such a configuration a high impedance voltage divider must also be used to minimize ground current and a
typical value for R2 of
≤ 200 k and a maximum value for R1 of 2.2 M are recommended.
A feed-forward capacitor (C(FF)), across the upper feedback resistor (R1), is required to provide sufficient
overdrive for the error comparator. Without a feed-forward capacitor or a too small feed-forward capacitor value,
the device shows double pulses or a pulse burst instead of single pulses at the switch node (SW). This can
cause higher output voltage ripple. If a higher output voltage ripple is acceptable, the feedforward capacitor can
be left out too.
The lower the switching frequency of the converter, the larger the feed-forward capacitor value needs to be. A
good starting point is the use of a 10 pF feed-forward capacitor. As a first estimation, the required value for the
feed-forward capacitor can be calculated at the operation point:
with:
R1 = upper resistor of voltage divider
fS = switching frequency of the converter at the nominal load current. (For the calculation of the switching
frequency see previous section)
For C(FF) choose a value which comes closest to the calculation result.
The larger the feed-forward capacitor, the worse the line regulation of the device. Therefore, the feed-forward
capacitor must be selected as small as possible if good line regulation is of concern.
OUTPUT CAPACITOR SELECTION
For better output voltage filtering a low ESR output capacitor is recommended. Ceramic capacitors have low
ESR values but depending on the application, tantalum capacitors can also be used. See Table 4 and the
TYPICAL APPLICATIONS for the selection of the output capacitor.
Assuming the converter does not show double pulses or pulse bursts on the switch node (SW) the output voltage
ripple is calculated as:
with:
IP = peak current as described in the previous section peak current control
L = selected inductor value
IO(LOAD)= Nominal load current
fS(ILoad) = switching frequency at the nominal load current as calculated previously.
VF = rectifier diode forward voltage (typically 0.3 V)
CO = selected output capacitor
ESR = output capacitor ESR value
12
Copyright 2003–2009, Texas Instruments Incorporated
Product Folder Link(s): TPS61045
相关PDF资料 |
PDF描述 |
|---|---|
| TPS61080DRCR | 1 A SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS61081DRCTG4 | 1.3 A SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS61080DRCTG4 | 0.5 A SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS61093DSK | 1.5 A SWITCHING REGULATOR, 1400 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS61122PWRG4 | 1.6 A BATTERY CHARGE CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDSO16 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS61045DRBRG4 | 功能描述:LED显示驱动器 28-V 85% Eff Boost Converter RoHS:否 制造商:Micrel 数位数量:5 片段数量: 安装风格:SMD/SMT 封装 / 箱体:PLCC-44 工作电源电压:4.75 V to 11 V 最大电源电流:10 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装:Tube |
| TPS61045DRBT | 功能描述:LED显示驱动器 28-V 85% Eff Boost Converter RoHS:否 制造商:Micrel 数位数量:5 片段数量: 安装风格:SMD/SMT 封装 / 箱体:PLCC-44 工作电源电压:4.75 V to 11 V 最大电源电流:10 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装:Tube |
| TPS61045DRBTG4 | 功能描述:LED照明驱动器 28-V 85% Eff Boost Converter RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
| TPS61045EVM-231 | 功能描述:电源管理IC开发工具 TPS61045-231 Eval Mod RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| TPS61046EVM-682 | 功能描述:TPS61046 - DC/DC, Step Up 2, Non-Isolated Outputs Evaluation Board 制造商:texas instruments 系列:- 零件状态:有效 主要用途:DC/DC，步升 输出和类型:2，非隔离 功率 - 输出:- 电压 - 输出:12V，5 V ~ 28 V 电流 - 输出:100mA，20mA 电压 - 输入:1.8 V ~ 5.5 V 稳压器拓扑:升压 频率 - 开关:1MHz 板类型:完全填充 所含物品:板 使用的 IC/零件:TPS61046 标准包装:1 |
发布紧急采购，3分钟左右您将得到回复。