- 您现在的位置：买卖IC网 > PDF目录98284 > TPS62111RSATG4 (TEXAS INSTRUMENTS INC) 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16 PDF资料下载
参数资料
| 型号： | TPS62111RSATG4 |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16 |
| 封装： | GREEN, PLASTIC, QFN-16 |
| 文件页数： | 6/28页 |
| 文件大小： | 842K |
| 代理商： | TPS62111RSATG4 |
第1页第2页第3页第4页第5页当前第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
ENABLE
UNDERVOLTAGE LOCKOUT
SYNCHRONIZATION
POWER-GOOD COMPARATOR
LOW-BATTERY DETECTOR (Standard Version)
SLVS585A – JULY 2005 – REVISED FEBRUARY 2009 .................................................................................................................................................... www.ti.com
DETAILED DESCRIPTION (continued)
Logic low on EN forces the TPS6211x into shutdown. In shutdown, the power switch, drivers, voltage reference,
oscillator, and all other functions are turned off. The supply current is reduced to less than 2 A in the shutdown
mode. When the device is in thermal shutdown, the band gap is forced to be switched on even if the device is set
into shutdown by pulling EN to GND.
If an output voltage is present when the device is disabled, which could be due to an external voltage source or a
super capacitor, the reverse leakage current is specified under electrical characteristics. Pulling the enable pin
high starts up the TPS6211x with the soft start. If the EN pin is connected to any voltage other than VI or GND,
an increased leakage current of typically 10 A and up to 20 A can occur.
The undervoltage lockout circuit prevents the device from misoperation at low-input voltages. It prevents the
converter from turning on the switch or rectifier MOSFET under undefined conditions. The minimum input voltage
to start up the TPS6211x is 3.4 V (worst case). The device shuts down at 2.8 V minimum.
If no clock signal is applied, the converter operates with a typical switching frequency of 1 MHz. It is possible to
synchronize the converter to an external clock within a frequency range from 0.8 MHz to 1.4 MHz. The device
automatically detects the rising edge of the first clock and synchronizes immediately to the external clock. If the
clock signal is stopped, the converter automatically switches back to the internal clock and continues operation.
The switchover is initiated if no rising edge on the SYNC pin is detected for a duration of four clock cycles.
Therefore, the maximum delay time can be 6.25 s if the internal clock has its minimum frequency of 800 kHz.
If the device is synchronized to an external clock, the power-save mode is disabled, and the devices stay in
forced PWM mode.
Connecting the SYNC pin to the GND pin enables the power-save mode. The converter operates in the PWM
mode at moderate-to-heavy loads, and in the PFM mode during light loads, which maintains high efficiency over
a wide load-current range.
The power-good (PG) comparator has an open-drain output capable of sinking 1 mA (typical). The PG is only
active when the device is enabled (EN = high). When the device is disabled (EN = low), the PG pin is pulled to
GND.
The PG output is only valid after a 250-s delay when the device is enabled and the supply voltage is greater
than the undervoltage lockout V(UVLO). PG is low during the first 250 s after shutdown and in shutdown.
The PG pin becomes active-high when the output voltage exceeds 98.4% (typical) of its nominal value. Leave
the PG pin unconnected when not used.
The low-battery output (LBO) is an open-drain type which goes low when the voltage at the low-battery input
(LBI) falls below the trip point of 1.256 V ±1.5%. The voltage at which the low-battery warning is issued can be
adjusted with a resistive divider as shown in Figure 19. The sum of resistors (R1 + R2) as well as the sum of (R5
+ R6) is recommended to be in the 100-k
to 1-M range for high efficiency at low output current. An external
pullup resistor can be connected to OUT, or any other voltage rail in the voltage range of 0 V to 16 V. During
start-up, the LBO output signal is invalid for the first 500 s. LBO is high-impedance when the device is disabled.
If the low-battery comparator function is not used, connect LBI to ground. The low-battery detector is disabled
when the device is disabled.
The logic level of the LBO pin is not defined for the first 500 s after EN is pulled high.
When the LBI is used to supervise the battery voltage and shut down the TPS62113 at low-input voltages, the
battery voltage rises when the current drops to zero. The implemented hysteresis on the LBI pin may not be
sufficient for all types of batteries. Figure 19 shows how an additional external hysteresis can be implemented.
14
Copyright 2005–2009, Texas Instruments Incorporated
相关PDF资料 |
PDF描述 |
|---|---|
| TPS62111RSAR | 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16 |
| TPS62112RSATG4 | 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16 |
| TPS62110RSARG4 | 2.4 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PQCC16 |
| TPS62225DDCT | 0.4 A SWITCHING REGULATOR, 1850 kHz SWITCHING FREQ-MAX, PDSO5 |
| TPS62225DDCR | 0.4 A SWITCHING REGULATOR, 1850 kHz SWITCHING FREQ-MAX, PDSO5 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS62112MRSAREP | 功能描述:直流/直流开关调节器 Mil Enh 17V 1.5A Synch Step-Down Conv RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| TPS62112RSAR | 功能描述:直流/直流开关调节器 1.5A 17V Sync Step-Down Converter RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| TPS62112RSARG4 | 功能描述:直流/直流开关调节器 1.5A 17V Sync Step-Down Converter RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| TPS62112RSAT | 功能描述:直流/直流开关调节器 1.5A 17V Sync Step-Down Converter RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| TPS62112RSAT | 制造商:Texas Instruments 功能描述:IC STEP-DWN CONV 5V 1.5A 16-VQFN 制造商:Texas Instruments 功能描述:IC, STEP-DWN CONV 5V 1.5A 16-VQFN 制造商:Texas Instruments 功能描述:IC, STEP-DWN CONV 5V 1.5A 16-VQFN; Primary Input Voltage:17V; No. of Outputs:1; Output Voltage:16V; Output Current:1.5A; Voltage Regulator Case Style:QFN; No. of Pins:16; Operating Temperature Min:-40C; Operating Temperature ;RoHS Compliant: Yes |
发布紧急采购，3分钟左右您将得到回复。