- 您现在的位置：买卖IC网 > PDF目录69519 > TPS62402DRCTG4 (TEXAS INSTRUMENTS INC) 0.6 A DUAL SWITCHING CONTROLLER, 2500 kHz SWITCHING FREQ-MAX, PDSO10 PDF资料下载
参数资料
| 型号： | TPS62402DRCTG4 |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | 0.6 A DUAL SWITCHING CONTROLLER, 2500 kHz SWITCHING FREQ-MAX, PDSO10 |
| 封装： | 3 X 3 MM, GREEN, PLASTIC, SON-10 |
| 文件页数： | 11/43页 |
| 文件大小： | 1155K |
| 代理商： | TPS62402DRCTG4 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页当前第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页
www.ti.com
SLVS681E – JUNE 2006 – REVISED APRIL 2010
With decreasing load current, the device automatically switches into pulse skipping operation in which the power
stage operates intermittently based on load demand. By running cycles periodically the switching losses are
minimized and the device runs with a minimum quiescent current, maintaining high efficiency.
Under-Voltage Lockout
The under-voltage lockout circuit prevents the device from malfunctioning at low input voltages, and from
excessive discharge of the battery, and disables the converters. The under-voltage lockout threshold is typically
1.5V; maximum of 2.35V. In case the default register values are overwritten by the Interface, the new values in
the registers REG_DEF_1_High, REG_DEF_1_Low and REG_DEF_2 remain valid as long the supply voltage
does not fall below the under-voltage lockout threshold, independent of whether the converters are disabled.
MODE SELECTION
The MODE/DATA pin allows mode selection between forced PWM Mode and Power Save Mode for both
converters. Furthermore, this pin is a multipurpose pin and provides (besides Mode selection) a one-pin interface
to receive serial data from a host to set the output voltage. This is described in the EasyScale Interface
section.
Connecting this pin to GND enables the automatic PWM and power save mode operation. The converters
operates in fixed-frequency PWM mode at moderate-to-heavy loads, and in the PFM mode during light loads,
maintaining high efficiency over a wide load current range.
Pulling the MODE/DATA pin high forces both converters to operate constantly in the PWM mode, even at light
load currents. The advantage is that the converters operate with a fixed frequency, allowing simple filtering of the
switching frequency for noise-sensitive applications. In this mode, the efficiency is lower compared to the power
save mode during light loads. For additional flexibility, it is possible to switch from power save mode to forced
PWM mode during operation. This allows efficient power management by adjusting the operation of the converter
to the specific system requirements.
In case the operation mode is changed from forced PWM mode (MODE/DATA = high) to Power Save Mode
Enable (MODE/DATA = 0), the Power Save Mode is enabled after a delay time of ttimeout , which is max. 520ms.
The forced PWM Mode operation is enabled immediately with Pin MODE/DATA set to 1.
ENABLE
The device has a separate EN pin for each converter to start up each converter independently. If EN1 and EN2
are set to high, the corresponding converter starts up with soft start as previously described.
Pulling EN1 and EN2 pin low forces the device into shutdown, with a shutdown quiescent current of typically
1.2mA. In this mode, the P and N-Channel MOSFETs are turned-off and the entire internal control circuitry is
switched-off. For proper operation the EN1 and EN2 pins must be terminated and must not be left floating.
DEF_1 PIN FUNCTION
The DEF_1 pin is dedicated to converter 1 and makes the output voltage selection very flexible to support
dynamic voltage management.
Depending on the device version, this pin works either as:
1. Analog input for adjustable output voltage setting (TPS62400):
–
Connecting an external resistor network to this pin adjusts the default output voltage to any value starting
from 0.6V to VIN
2. Digital input for fixed default output voltage selection (TPS62401):
–
In case this pin is tied to low level, the output voltage is set according to the value in register
REG_DEF_1_Low. The default voltage will be 1.575V. If tied to high level, the output voltage is set
according to the value in register REG_DEF_1_High. The default value in this case is 1.1V. Depending
on the level of Pin DEF_1, it selects between the two registers REG_DEF_1_Low and REG_DEF_1_High
for output voltage setting. Each register content (and therefore output voltage) can be changed
individually via the EasyScale interface. This makes the device very flexible in terms of output voltage
setting; see Table 4.
Copyright 2006–2010, Texas Instruments Incorporated
19
相关PDF资料 |
PDF描述 |
|---|---|
| TPS62403DRC | 0.6 A DUAL SWITCHING CONTROLLER, 2500 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS62410DRCR | 1.6 A DUAL SWITCHING CONTROLLER, 2500 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS62410DRCT | 1.6 A DUAL SWITCHING CONTROLLER, 2500 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS62410QDRCRQ1 | DUAL SWITCHING CONTROLLER, PDSO10 |
| TPS62560DRVT | 0.6 A SWITCHING REGULATOR, 2250 kHz SWITCHING FREQ-MAX, PDSO6 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS62402QDRCRQ1 | 功能描述:Buck Switching Regulator IC Positive Programmable (Fixed) 1.2V, 1.8V (3.3V) 2 Output 400mA, 600mA 10-VFDFN Exposed Pad 制造商:texas instruments 系列:汽车级，AEC-Q100 包装:剪切带（CT） 零件状态:有效 功能:降压 输出配置:正 拓扑:降压 输出类型:可编程（固定） 输出数:2 电压 - 输入（最小值）:2.5V 电压 - 输入（最大值）:6V 电压 - 输出（最小值/固定）:1.2V，1.8V（3.3V） 电压 - 输出（最大值）:- 电流 - 输出:400mA，600mA 频率 - 开关:2.3MHz 同步整流器:是 工作温度:-40°C ~ 125°C （TJ） 安装类型:表面贴装 封装/外壳:10-VFDFN 裸露焊盘 供应商器件封装:10-VSON（3x3） 标准包装:1 |
| TPS62403DRCR | 功能描述:直流/直流开关调节器 Dl Channel Step-Down Converter RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| TPS62403DRCRG4 | 功能描述:直流/直流开关调节器 Dl Channel Step-Down Converter RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| TPS62403DRCT | 功能描述:直流/直流开关调节器 Dl Channel Step-Down Converter RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| TPS62403DRCTG4 | 功能描述:直流/直流开关调节器 Dl Channel Step-Down Converter RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
发布紧急采购，3分钟左右您将得到回复。