参数资料
型号: TPS62410DRCR
厂商: TEXAS INSTRUMENTS INC
元件分类: 稳压器
英文描述: 1.6 A DUAL SWITCHING CONTROLLER, 2500 kHz SWITCHING FREQ-MAX, PDSO10
封装: 3 X 3 MM, PLASTIC, MLF-10
文件页数: 7/33页
文件大小: 1235K
代理商: TPS62410DRCR
www.ti.com
Dynamic Voltage Positioning
V
OUT_NOM
+1%
PWMMode
medium/heavyload
PFMMode
lightload
Smooth
increasedload
PWMMode
medium/heavyload
PFMMode
lightload
Fastloadtransient
PWMMode
medium/heavyload
COMP_LOWthreshold –1%
Soft Start
95%
5%
t
RAMP
t
Startup
EN
V
OUT
SLVS737 – FEBRUARY 2007
DETAILED DESCRIPTION (continued)
Hereupon the device starts switching again. The Power Save Mode is exited and PWM Mode entered in case
the output current exceeds the current IOUT_PFM_leave, or if the output voltage falls below a second
comparator threshold, called skip comparator low (Skip Comp Low) threshold. This skip comparator low
threshold is set to –2% below nominal Vout, and enables a fast transition from Power Save Mode to PWM Mode
during a load step. In Power Save Mode the quiescent current is reduced typically to 19
A for one converter and
32
A for both converters active. This single skip comparator threshold method in Power Save Mode results in a
very low output voltage ripple. The ripple depends on the comparator delay and the size of the output capacitor.
Increasing output capacitor values minimizes the output ripple. The Power Save Mode can be disabled through
the MODE/DATA pin set to high. Both converters then operate in fixed PWM mode. Power Save Mode
Enable/Disable applies to both converters.
This feature reduces the voltage under/overshoots at load steps from light to heavy load and vice versa. It is
activated in Power Save Mode operation. It provides more headroom for both the voltage drop at a load step,
and the voltage increase at a load throw-off. This improves load transient behavior.
At light loads, in which the converter operate in PFM Mode, the output voltage is regulated typically 1% higher
than the nominal value. In case of a load transient from light load to heavy load, the output voltage drops until it
reaches the skip comparator low threshold set to –2% below the nominal value and enters PWM mode. During a
load throw off from heavy load to light load, the voltage overshoot is also minimized due to active regulation
turning on the N-channel switch.
Figure 25. Dynamic Voltage Positioning
The two converters have an internal soft start circuit that limits the inrush current during start-up. During soft
start, the output voltage ramp up is controlled as shown in Figure 26.
Figure 26. Soft Start
15
相关PDF资料
PDF描述
TPS62410DRCT 1.6 A DUAL SWITCHING CONTROLLER, 2500 kHz SWITCHING FREQ-MAX, PDSO10
TPS62410QDRCRQ1 DUAL SWITCHING CONTROLLER, PDSO10
TPS62560DRVT 0.6 A SWITCHING REGULATOR, 2250 kHz SWITCHING FREQ-MAX, PDSO6
TPS62561DDCR 0.6 A SWITCHING REGULATOR, 2250 kHz SWITCHING FREQ-MAX, PDSO6
TPS62560DRVR 0.6 A SWITCHING REGULATOR, 2250 kHz SWITCHING FREQ-MAX, PDSO6
相关代理商/技术参数
参数描述
TPS62410DRCRG4 功能描述:直流/直流开关调节器 2.25MHZ 2x800mA Dual St-Down Cnvrtr RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5
TPS62410DRCT 功能描述:直流/直流开关调节器 2.25MHZ 2x800mA Dual Step-Down RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5
TPS62410DRCT 制造商:Texas Instruments 功能描述:IC DUAL STPDN CONV 2X0.8A 10SON 制造商:Texas Instruments 功能描述:IC, DUAL STPDN CONV 2X0.8A 10SON 制造商:Texas Instruments 功能描述:IC, DUAL STPDN CONV 2X0.8A 10SON; Primary Input Voltage:6V; No. of Outputs:2; Output Voltage:6V; Output Current:800mA; Voltage Regulator Case Style:SON; No. of Pins:10; Operating Temperature Min:-40C; Operating Temperature Max:85C;;RoHS Compliant: Yes
TPS62410DRCTG4 功能描述:直流/直流开关转换器 2.25MHZ 2x800mA Dual St-Down Cnvrtr RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT
TPS62410Q1-EVM 功能描述:EVALUATION MODULE 制造商:texas instruments 系列:* 零件状态:在售 标准包装:1