参数资料
型号: TRM-418-LT
厂商: Linx Technologies Inc
文件页数: 25/44页
文件大小: 0K
描述: TRANSCEIVER RF 418MHZ LT SERIES
特色产品: LT Series Long-Range RF Transceiver Modules
标准包装: 34
系列: LT
频率: 418MHz
数据传输率 - 最大: 10kbps
调制或协议: AM,OOK
应用: 双向传呼,ISM,机器人,遥测
功率 - 输出: 10dBm
灵敏度: -112dBm
电源电压: 2.1 V ~ 3.6 V
电流 - 接收: 6.1mA
电流 - 传输: 12mA
数据接口: PCB,表面贴装
天线连接器: PCB,表面贴装
工作温度: -40°C ~ 85°C
封装/外壳: 表面安装
包装: 管件
A 750-ohm resistor is used on the LADJ line of the transceiver to reduce
the output power of the transmitter to meet North American certification
requirements. This value may need to be adjusted depending on antenna
efficiency and the power allowed in the country of operation.
Board Layout Guidelines
If you are at all familiar with RF devices, you may be concerned about
specialized board layout requirements. Fortunately, because of the care
taken by Linx in designing the modules, integrating them is straightforward.
Despite this ease of application, it is still necessary to maintain respect for
the RF stage and exercise appropriate care in layout and application in
order to maximize performance and ensure reliable operation. The antenna
can also be influenced by layout choices. Please review this data guide
in its entirety prior to beginning your design. By adhering to good layout
principles and observing some basic design rules, you will be on the path
to RF success.
Figure 25 shows the suggested PCB
footprint for the module. The actual
pad dimensions are shown in the
Pad Layout section of this manual. A
ground plane (as large as possible)
should be placed on a lower layer of
your PC board opposite the module.
This ground plane can also be critical
to the performance of your antenna,
which will be discussed later. There
should not be any ground or traces
GROUND PLANE
ON LOWER LAYER
Figure 25: Suggested PCB Layout
under the module on the same layer
as the module, just bare PCB.
During prototyping, the module should be soldered to a properly laid-out
circuit board. The use of prototyping or “perf” boards will result in horrible
performance and is strongly discouraged.
No conductive items should be placed within 0.15" of the module’s top or
sides.
Do not route PCB traces directly under the module. The underside of the
module has numerous traces and vias that could short or couple to traces
on the product’s circuit board.
– 21 –
相关PDF资料
PDF描述
TRM-900-NT RF TXRX 915MHZ NT SERIES
TRX08GVP2540 TXRX OPT SCFF 8.5GB/S 850NM
TS-320240BRNO TCH PANEL 140X104 RESISTIVE MONO
TS-TFT3.5Z TOUCH PANEL 140X1.4.0 TFT
TS3-75B3 SENSOR THERMAL MOXIE NTC 75C
相关代理商/技术参数
参数描述
TRM-433-DP1203 功能描述:射频模块 433 MHz Wireless Module DP1203 RoHS:否 制造商:Linx Technologies 产品:Transceiver Modules 频带:902 MHz to 928 MHz 输出功率:- 15.5 dBm to + 12.5 dBm 接口类型:UART 工作电源电压:- 0.3 VDC to + 5.5 VDC 传输供电电流:38.1 mA 接收供电电流:22.7 mA 天线连接器类型:U.FL 最大工作温度:+ 85 C 尺寸:1.15 mm x 0.63 mm x 0.131 mm
TRM-433-DP1205 功能描述:射频模块 433 MHz Wireless Module DP1205 RoHS:否 制造商:Linx Technologies 产品:Transceiver Modules 频带:902 MHz to 928 MHz 输出功率:- 15.5 dBm to + 12.5 dBm 接口类型:UART 工作电源电压:- 0.3 VDC to + 5.5 VDC 传输供电电流:38.1 mA 接收供电电流:22.7 mA 天线连接器类型:U.FL 最大工作温度:+ 85 C 尺寸:1.15 mm x 0.63 mm x 0.131 mm
TRM-433-LT 功能描述:射频模块 RF Transceiver 433MHz (NEW) RoHS:否 制造商:Linx Technologies 产品:Transceiver Modules 频带:902 MHz to 928 MHz 输出功率:- 15.5 dBm to + 12.5 dBm 接口类型:UART 工作电源电压:- 0.3 VDC to + 5.5 VDC 传输供电电流:38.1 mA 接收供电电流:22.7 mA 天线连接器类型:U.FL 最大工作温度:+ 85 C 尺寸:1.15 mm x 0.63 mm x 0.131 mm
TRM5 制造商:Ferraz Shawmut 功能描述:Fuse Midget 5A 250V Slow Blow 2-Pin Cartridge Holder
TRM-5 制造商:Richco 功能描述:Rivet,Push,HS Black,1K/Bag 制造商:Richco 功能描述:RIVET BLACK .155-.180" HOLD