- 您现在的位置：买卖IC网 > PDF目录98287 > TS2007EKIJT (STMICROELECTRONICS) 3 W, 1 CHANNEL, AUDIO AMPLIFIER, PBGA9 PDF资料下载
参数资料
| 型号： | TS2007EKIJT |
| 厂商： | STMICROELECTRONICS |
| 元件分类： | 音频／视频放大 |
| 英文描述： | 3 W, 1 CHANNEL, AUDIO AMPLIFIER, PBGA9 |
| 封装： | ROHS COMPLIANT, BGA-9 |
| 文件页数： | 16/28页 |
| 文件大小： | 451K |
| 代理商： | TS2007EKIJT |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页当前第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
TS2007FC
Application information
23/28
4.10
Output filter considerations
The TS2007 is designed to operate without an output filter. However, due to very sharp
transients on the TS2007 output, EMI radiated emissions may cause some standard
compliance issues.
These EMI standard compliance issues can appear if the distance between the TS2007
outputs and loudspeaker terminal are long (typically more than 50 mm, or 100 mm in both
directions). As the PCB layout and internal equipment device are different for each
configuration, it is difficult to provide a one-size-fits-all solution.
However, to decrease the probability of EMI issues, there are several simple rules to follow.
●
Reduce, as much as possible, the distance between the TS2007 output pins and the
speaker terminals.
●
Use a ground plane for shielding sensitive wires.
●
Place, as close as possible to the TS2007 and in series with each output, a ferrite bead
with a rated current of minimum 2.5 A and impedance greater than 50
Ω at frequencies
above 30 MHz.
●
Allow extra footprint to place, if necessary, a capacitor to short perturbations to ground
(Figure 45).
Figure 45.
Ferrite chip bead placement
In the case where the distance between the TS2007 output and the speaker terminals is too
long, it is possible to have low frequency EMI issues due to the fact that the typical operating
PWM frequency is 280 kHz and fall and rise time of the output signal is less than or equal to
5 ns. In this configuration, it is necessary to use the output filter represented in Figure 46 on
page 24, that consists of L1, C1, L2 and C2 as close as possible to the TS2007 outputs.
When an output filter is used and there exists a possibility to disconnect a load, it is
recommended to use an RC network that consists of C3 and R as shown in Figure 46 on
page 24. In this case, when the output filter is connected without any load, the filter acts like
a short circuit for input frequencies above 10 kHz. The RC network corrects frequency
response of the output filter and compensates this limitation.
to speaker
about 100pF
gnd
Ferrite chip bead
From TS2007 output
相关PDF资料 |
PDF描述 |
|---|---|
| TS2007IQT | 2.3 W, 1 CHANNEL, AUDIO AMPLIFIER, DSO8 |
| TS2012EIJT | 2.5 W, 2 CHANNEL, AUDIO AMPLIFIER, PBGA16 |
| TS2012IQT | 2.8 W, 2 CHANNEL, AUDIO AMPLIFIER, PQCC20 |
| TS34119CDC3 | 2 CHANNEL, AUDIO AMPLIFIER, PDIP8 |
| TS34119CSRL | 2 CHANNEL, AUDIO AMPLIFIER, PDSO8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TS2007FC | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:3 W filter-free class D audio power amplifier with 6 or 12 dB fixed gain select |
| TS2007IQT | 功能描述:音频放大器 3W filter free ClassD audio Pwr amp RoHS:否 制造商:STMicroelectronics 产品:General Purpose Audio Amplifiers 输出类型:Digital 输出功率: THD + 噪声: 工作电源电压:3.3 V 电源电流: 最大功率耗散: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:TQFP-64 封装:Reel |
| TS200A | 制造商:Black Box Corporation 功能描述:VERI NET VOIP |
| TS200A-W1 | 制造商:Black Box Corporation 功能描述:1 YEAR WARRANTY FOR TS200A |
| TS200A-W3 | 制造商:Black Box Corporation 功能描述:3 YEAR WARRANTY FOR TS200A |
发布紧急采购，3分钟左右您将得到回复。