- 您现在的位置：买卖IC网 > PDF目录300042 > TS80C52X2-VIBB (TEMIC SEMICONDUCTORS) 8-BIT, MROM, 40 MHz, MICROCONTROLLER, PQFP44 PDF资料下载
参数资料
| 型号： | TS80C52X2-VIBB |
| 厂商： | TEMIC SEMICONDUCTORS |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 8-BIT, MROM, 40 MHz, MICROCONTROLLER, PQFP44 |
| 封装： | PLASTIC, LCC-44 |
| 文件页数： | 31/56页 |
| 文件大小： | 689K |
| 代理商： | TS80C52X2-VIBB |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页当前第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页
37
Rev. C - Aug. 31, 1999
TS80C52X2
The encryption array cannot be directly verified. Verification of the encryption array is done by observing that the
code array is well encrypted.
Figure 12. Programming and Verification Signal’s Waveform
8.4 EPROM Erasure (Windowed Packages Only)
Erasing the EPROM erases the code array, the encryption array and the lock bits returning the parts to full
functionality.
Erasure leaves all the EPROM cells in a 1’s state (FF).
8.4.1 Erasure Characteristics
The recommended erasure procedure is exposure to ultraviolet light (at 2537 ) to an integrated dose at least 15
W-sec/cm2. Exposing the EPROM to an ultraviolet lamp of 12,000
W/cm2 rating for 30 minutes, at a distance
of about 25 mm, should be sufficient. An exposure of 1 hour is recommended with most of standard erasers.
Erasure of the EPROM begins to occur when the chip is exposed to light with wavelength shorter than approximately
4,000 . Since sunlight and fluorescent lighting have wavelengths in this range, exposure to these light sources
over an extended time (about 1 week in sunlight, or 3 years in room-level fluorescent lighting) could cause
inadvertent erasure. If an application subjects the device to this type of exposure, it is suggested that an opaque
label be placed over the window.
Control signals
Data In
ALE/PROG
A0-A12
Programming Cycle
100
s
D0-D7
EA/VPP
Data Out
Read/Verify Cycle
12.75V
5V
0V
相关PDF资料 |
PDF描述 |
|---|---|
| TS914AIYDT | QUAD OP-AMP, 7000 uV OFFSET-MAX, 0.8 MHz BAND WIDTH, PDSO14 |
| TS914IYDT | QUAD OP-AMP, 12000 uV OFFSET-MAX, 0.8 MHz BAND WIDTH, PDSO14 |
| TS914IYD | QUAD OP-AMP, 12000 uV OFFSET-MAX, 0.8 MHz BAND WIDTH, PDSO14 |
| TS914AIYD | QUAD OP-AMP, 7000 uV OFFSET-MAX, 0.8 MHz BAND WIDTH, PDSO14 |
| TS922AIYD | DUAL OP-AMP, 1800 uV OFFSET-MAX, 4 MHz BAND WIDTH, PDSO8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TS80C52X2-VIBD | 制造商:TEMIC 制造商全称:TEMIC Semiconductors 功能描述:8-bit CMOS Microcontroller 0-60 MHz |
| TS80C52X2-VIBR | 制造商:TEMIC 制造商全称:TEMIC Semiconductors 功能描述:8-bit CMOS Microcontroller 0-60 MHz |
| TS80C52X2-VICB | 制造商:TEMIC 制造商全称:TEMIC Semiconductors 功能描述:8-bit CMOS Microcontroller 0-60 MHz |
| TS80C52X2-VICD | 制造商:TEMIC 制造商全称:TEMIC Semiconductors 功能描述:8-bit CMOS Microcontroller 0-60 MHz |
| TS80C52X2-VICR | 制造商:TEMIC 制造商全称:TEMIC Semiconductors 功能描述:8-bit CMOS Microcontroller 0-60 MHz |
发布紧急采购，3分钟左右您将得到回复。