- 您现在的位置：买卖IC网 > Datasheet目录528 > TSOP6238TT (Vishay Semiconductors)IR RECEIVER 38KHZ 40M TSOP6238 Datasheet资料下载
参数资料
| 型号： | TSOP6238TT |
| 厂商： | Vishay Semiconductors |
| 文件页数： | 5/12页 |
| 文件大小： | 0K |
| 描述： | IR RECEIVER 38KHZ 40M TSOP6238 |
| 标准包装： | 1 |
| 检测距离： | 40m |
| B.P.F. 中心频率： | 38.0kHz |
| 电源电压： | 2.7 V ~ 5.5 V |
| 电流 - 电源： | 950µA |
| 方向： | 顶视图 |
| 安装类型： | * |
| 其它名称： | TSOP6238TTDKR |
TSOP62.., TSOP64..
www.vishay.com
SUITABLE DATA FORMAT
This series is designed to suppress spurious output pulses
due to noise or disturbance signals. The devices can
distinguish data signals from noise due to differences in
frequency, burst length, and envelope duty cycle. The data
signal should be close to the device’s band-pass center
frequency (e.g. 38 kHz) and fulfill the conditions in the table
below.
When a data signal is applied to the product in the presence
of a disturbance, the sensitivity of the receiver is
automatically reduced by the AGC to insure that no spurious
pulses are present at the receiver’s output.
Vishay Semiconductors
Some examples which are suppressed are:
16920
0
5
10
Time (ms)
15
20
? DC light (e.g. from tungsten bulbs sunlight)
? Continuous signals at any frequency
? Strongly or weakly modulated noise from fluorescent
lamps with electronic ballasts (see figure 13 or figure 14)
Fig. 13 - IR Disturbance from Fluorescent Lamp
with Low Modulation
0
5
10
15
20
16921
Time (ms)
Fig. 14 - IR Disturbance from Fluorescent Lamp
with High Modulation
TSOP62..
TSOP64..
Minimum burst length
After each burst of length
a minimum gap time is required of
For bursts greater than
a minimum gap time in the data stream is needed of
Maximum number of continuous short bursts/second
NEC code
RC5/RC6 code
Thomson 56 kHz code
Sharp code
Suppression of interference from fluorescent lamps
10 cycles/burst
10 to 70 cycles
≥ 12 cycles
70 cycles
> 4 x burst length
800
yes
yes
yes
yes
Most common disturbance
patterns are suppressed
10 cycles/burst
10 to 35 cycles
≥ 12 cycles
35 cycles
> 10 x burst length
1300
preferred
preferred
preferred
preferred
Even extreme disturbance
patterns are suppressed
Notes
? For data formats with short bursts please see the datasheet of TSOP61.., TSOP63.., TSOP65..
? Best choice of AGC for some popular IR-codes:
- TSOP6436: RC-5, RC-6, Panasonic
- TSOP6438: NEC, Sharp, r-map
- TSOP6456: r-step, Thomson RCA
? For SIRCS 15 and 20 bit, Sony 12 bit IR-codes, please see the datasheet for TSOP4S40, TSOP2S40
Rev. 1.1, 05-Feb-14
5
Document Number: 82463
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000
相关PDF资料 |
PDF描述 |
|---|---|
| TSTFT3.5I# | TOUCH PANEL 140X1.4.0 TFT |
| TSTFT5.7I# | TOUCH PANEL 132.5X104.7 TFT |
| TT8J21TR | MOSFET P-CH 20V 2.5A TSST8 |
| TT8J2TR | MOSFET 2P-CH 30V 2.5A TSST8 |
| TT8K2TR | MOSFET 2N-CH 30V 2.5A TSST8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TSOP6240TR | 功能描述:红外接收机 4.5-5.5V 40kHz Side View Taping RoHS:否 制造商:Vishay Semiconductors 载频:20 kHz to 60 kHz 传输距离:5 m 显示角:+/- 50 deg 高电平脉冲宽度: 低电平脉冲宽度: 最小高电平输出电压: 输出电流:5 mA 工作电压:2.5 V to 5.5 V 电源电流:0.9 mA 功率耗散: 最大工作温度:+ 85 C 最小工作温度:- 25 C 封装 / 箱体: 封装:Reel |
| TSOP6240TT | 功能描述:红外接收机 4.5-5.5V 40kHz Top View Taping RoHS:否 制造商:Vishay Semiconductors 载频:20 kHz to 60 kHz 传输距离:5 m 显示角:+/- 50 deg 高电平脉冲宽度: 低电平脉冲宽度: 最小高电平输出电压: 输出电流:5 mA 工作电压:2.5 V to 5.5 V 电源电流:0.9 mA 功率耗散: 最大工作温度:+ 85 C 最小工作温度:- 25 C 封装 / 箱体: 封装:Reel |
| TSOP6240TT | 制造商:Vishay Semiconductors 功能描述:IR EMITTING DIODE |
| TSOP6256TR | 功能描述:红外接收机 4.5-5.5V 56kHz RoHS:否 制造商:Vishay Semiconductors 载频:20 kHz to 60 kHz 传输距离:5 m 显示角:+/- 50 deg 高电平脉冲宽度: 低电平脉冲宽度: 最小高电平输出电压: 输出电流:5 mA 工作电压:2.5 V to 5.5 V 电源电流:0.9 mA 功率耗散: 最大工作温度:+ 85 C 最小工作温度:- 25 C 封装 / 箱体: 封装:Reel |
| TSOP6256TT | 功能描述:红外接收机 4.5-5.5V 56kHz Top View Taping RoHS:否 制造商:Vishay Semiconductors 载频:20 kHz to 60 kHz 传输距离:5 m 显示角:+/- 50 deg 高电平脉冲宽度: 低电平脉冲宽度: 最小高电平输出电压: 输出电流:5 mA 工作电压:2.5 V to 5.5 V 电源电流:0.9 mA 功率耗散: 最大工作温度:+ 85 C 最小工作温度:- 25 C 封装 / 箱体: 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。