- 您现在的位置：买卖IC网 > PDF目录373745 > TSS463-AAR (ATMEL CORP) VAN Data Link Controller with Serial Interface PDF资料下载
参数资料
| 型号： | TSS463-AAR |
| 厂商： | ATMEL CORP |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | VAN Data Link Controller with Serial Interface |
| 中文描述： | 1 CHANNEL(S), 1M bps, SERIAL COMM CONTROLLER, PDSO16 |
| 封装： | SOP-16 |
| 文件页数： | 31/60页 |
| 文件大小： | 816K |
| 代理商： | TSS463-AAR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页当前第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页
31
TSS463-AA
4205B–AUTO–12/04
IDLE: Idle Command
(See Section “Idle and Activate Commands”, page 52). If the user sets the Idle bit, the
circuit will enter idle mode. In idle mode the oscillator will operate, but the TSS463AA
will not transmit or receive anything on the bus, and the TxD output will be in three state.
One
: Idle active
Zero
: Idle inactive
ACTI: Activate Command
(See Section “Idle and Activate Commands”, page 52). The Activate command will put
the circuit in the active mode, i.e it will transmit and receive normally on the bus. When
the circuit is in activate mode the TxD three-state output is enabled.
One
: Activate active
Zero
: Activate inactive
REAR: Re-Arbitrate Command
This command will, after the current attempt, reset the retry counter and re-arbitrate the
messages to be transmitted in order to find the highest priority message to transmit.
One:
Re-arbitrate active
Zero:
Re-arbitrate inactive
MSDC: Manual System
Diagnosis Clock
Rather than using the SDC divider described in Section “Message Data (string pointed
by: Message Pointer Register + 1)”, page 44, the user can use the manual SDC com-
mand to generate a SDC pulse for the diagnosis system.
This MSDC pulse should be high at least 2 timeslot clocks.
Line Status Register (0x04)
Read only register
Default value after reset: 0bx01xxx00.
This register reports the operation mode of the TSS463AA in the Sleep an Idle bits
(Command Register located at address 0
×
03) as well as the diagnosis system
status bits Sa to Sc discussed in the section “Diagnosis System” on page 22.
SPG: Sleeping
IDG: Idling
Default mode at reset
Sa, Sb and Sc: Diagnosis
System Status Bits
Sa and Sb
Diagnosis System Status Bits
7
6
5
4
3
2
1
0
X
SPG
IDG
Sc
Sb
Sa
TXG
RXG
Sb
Sa
Communication Indication
0
0
Nominal mode, differential communication
0
1
Degraded over DATA, fault on DATA
1
0
Degraded over DATA, fault on DATA
1
1
Major error, fault on DATA and DATA
相关PDF资料 |
PDF描述 |
|---|---|
| TSS463A-TERZ | VAN Data Link Controller with Serial Interface |
| TSS463C | VAN Data Link Controller with Serial Interface |
| TSS4B02G | Single Phase 4.0 Amps. Glass Passivated Super Fast Bridge Rectifiers |
| TSS4B03G | Single Phase 4.0 Amps. Glass Passivated Super Fast Bridge Rectifiers |
| TSS4B01G | Single Phase 4.0 Amps. Glass Passivated Super Fast Bridge Rectifiers |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TSS463A-TERZ | 功能描述:网络控制器与处理器 IC ASICS RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流（最大值）:595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray |
| TSS463B | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:Serial VAN Data Link Controller |
| TSS463B_03 | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:Serial VAN Data Link Controller |
| TSS463B_04 | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:VAN Data Link Controller with Serial Interface |
| TSS463B-TERA | 制造商:Temic 功能描述:LAN Node Controller, 16 Pin, SOP |
发布紧急采购，3分钟左右您将得到回复。