- 您现在的位置：买卖IC网 > PDF目录15401 > UCC2891PW (Texas Instruments)IC PWM CNTRLR CLAMP P-CH 16TSSOP PDF资料下载
参数资料
| 型号： | UCC2891PW |
| 厂商： | Texas Instruments |
| 文件页数： | 21/41页 |
| 文件大小： | 0K |
| 描述： | IC PWM CNTRLR CLAMP P-CH 16TSSOP |
| 产品培训模块： | 120V High-Side/Low-Side MOSFET Driver (UCC27200) |
| 标准包装： | 90 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 1MHz |
| 占空比： | 73% |
| 电源电压： | 8.5 V ~ 16 V |
| 降压： | 无 |
| 升压： | 无 |
| 回扫： | 是 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 是 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 16-TSSOP（0.173"，4.40mm 宽） |
| 包装： | 管件 |
| 其它名称： | 296-17240 296-17240-5 296-17240-ND |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页当前第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页
UCC2891, UCC2892
UCC2893, UCC2894
SLUS542F ? OCTOBER 2003 ? REVISED JULY 2009
APPLICATION INFORMATION: SETUP GUIDE
Step 5. Input Voltage Monitoring
The input voltage monitoring functions is governed by the following two expressions of the voltage at the
LINEUV terminal (pin 15):
V LINEUV + V ON
R IN2
R IN1 ) R IN2
at turn on, and
(19)
V LINEUV +
V OFF * V VON
R IN1
) I HYST
R IN2 at turn off.
(20)
Since V ON and V OFF are given by the power supply specification, V LINEUV equals the 1.27-V threshold of the
line monitor and I HYST is already defined as:
I HYST +
V REF
2
1
R DEL
0.05
(21)
the two unknown, R IN1 and R IN2 are fully determined. Solving the equations results the following two
expressions for the input voltage divider:
R IN1 +
V ON * V OFF
I HYST
(22)
R IN2 + R IN1
1.27 V
V ON * 1.27 V
(23)
Similar methods can be used to define the divider components of the overvoltage protection input of the
UCC2892 and UCC2894 controllers.
Step 6. Current Sense and Slope Compensation
The UCC2891 family offers onboard, user programmable slope compensation. The programming of the right
amount of slope compensation is accomplished by the appropriate selection of two external resistors, R F and
R SLOPE .
First, the current sense filter resistor value (R F ) must be calculated based on the desired filtering of the current
sense signal. The filter consists of two components, C F and R F . The C F filter capacitor is connected between
the CS pin (pin 7) and the GND terminal (pin 6). While the value of C F can be freely selected as the first step
of the filter design, it should be minimized to avoid filtering the slope compensation current exiting the CS pin.
The recommended range for the filter capacitance is between 50 pF and 270 pF. The value of the filter resistor
can be calculated from the filter capacitance and the desired filter corner frequency f F .
R F +
2 p
1
f F
C F
(24)
After R F is defined R SLOPE can be calculated. The amount of slope compensation is defined by the stability
requirements of the inner peak current loop of the control algorithm and is measured by the number m. When
the slope of the applied compensation ramp equals the down slope of the output inductor current waveform
reflected across the primary side current sense resistor dV L dt , m equals 1. The minimum value of m is 0.5
to prevent current loop instability. Best current mode performance can be achieved around m =1. The further
increase of m moves the control closer to voltage mode control operation.
www.ti.com
21
相关PDF资料 |
PDF描述 |
|---|---|
| 3094-394KS | INDUCTOR RF CHIP 390UH 10% SMD |
| VI-J1K-EY-F4 | CONVERTER MOD DC/DC 40V 50W |
| UCC2894D | IC REG CTRLR FLYBK ISO CM 16SOIC |
| VI-J1K-EY-F3 | CONVERTER MOD DC/DC 40V 50W |
| 3094-334KS | INDUCTOR RF CHIP 330UH 10% SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| UCC2891PWG4 | 功能描述:电流型 PWM 控制器 Current Mode Active Clamp RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| UCC2891PWR | 功能描述:电流型 PWM 控制器 Current Mode Active Clamp RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| UCC2891PWRG4 | 功能描述:电流型 PWM 控制器 Current Mode Active Clamp RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| UCC2892D | 功能描述:电流型 PWM 控制器 UCC289x Current Mode Active Clamp RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| UCC2892DG4 | 功能描述:电流型 PWM 控制器 UCC289x Current Mode Active Clamp RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
发布紧急采购，3分钟左右您将得到回复。