参数资料
型号: UCC38051PE4
厂商: Texas Instruments
文件页数: 6/32页
文件大小: 0K
描述: IC PFC CTRLR TRANSITION 8DIP
标准包装: 50
模式: 间歇(跃迁)
频率 - 开关: 200kHz
电流 - 启动: 75µA
电源电压: 12 V ~ 18 V
工作温度: 0°C ~ 70°C
安装类型: 通孔
封装/外壳: 8-DIP(0.300",7.62mm)
供应商设备封装: 8-PDIP
包装: 管件
配用: 296-19036-ND - EVAL MODULE FOR UCC28051
UCC28050, UCC28051
UCC38050, UCC38051
SLUS515F?SEPTEMBER 2002 ? REVISED MARCH 2009
BLOCK DIAGRAM
2.7/2.5 V
+
OVP
VREF
INT. BIAS
VREFAND
BIAS REG
UVLO
+
0.67/0.57 V
0.23/0.15 V
+
ENABLE
VREF
GOOD
REF
8
VCC
V0_SNS
1
gm VOL.
ERROR AMP
OVP
COMP
2
2.5 V
+
x
x MULT
PWM
+
R
Q
7
DRV
S
Q
MULTIN
3
ZERO
POWER
6
GND
DETECT
TIMER
2.3 V
+
40 k W
+
1.7/1.4 V
CS
4
5
ZCD
5 pF
UDG?02008
PIN DESCRIPTIONS
VO_SNS (Pin 1): This pin senses the boost regulator output voltage through a voltage divider. Internally, this
pin is the inverting input to the transconductance amplifier (with a nominal value of 2.5 V) and also is input to
the OVP comparator. Additionally, pulling this pin below the ENABLE threshold turns off the output switching,
ensuring that the gate drive is held off while the boost output is pre-charging and also ensuring no runaway if
feedback path is open.
COMP (Pin 2): Output of the transconductance error amplifier. Loop compensation components are connected
between this pin and ground. The output current capability of this pin is 10- μ A under normal conditions, but
increases to about 1-mA when the differential input is greater than the specified values in the specifications
table. This voltage is one of the inputs to the multiplier, with a dynamic input range of 2.5 V to 3.8 V. During zero
power or overvoltage conditions, this pin goes below 2.5 V nominal. When it goes below 2.3 V, the zero power
comparator is activated which prevents the gate drive from switching.
MULTIN (Pin 3): This pin senses the instantaneous boost regulator input voltage through a voltage divider. The
voltage acts as one of the inputs to the internal multiplier. Recommended operating range is 0 V to 2.5 V at high
line.
PIN DESCRIPTIONS (continued)
CS (Pin 4): This pin senses the instantaneous switch current in the boost switch and uses it as the internal ramp
for PWM comparator. The internal circuitry filters out switching noise spikes without requiring external
components. In addition, an external R-C filter may be required to suppress the noise spikes. An internal clamp
on the multiplier output terminates the switching cycle if this pin voltage exceeds 1.7 V. Additional external
filtering may be required. CS threshold is approximately equal to:
6
www.ti.com
相关PDF资料
PDF描述
V300A8C300B2 CONVERTER MOD DC/DC 8V 300W
V300A8C300B CONVERTER MOD DC/DC 8V 300W
GEM18DTMN CONN EDGECARD 36POS R/A .156 SLD
RMM36DRXS CONN EDGECARD 72POS DIP .156 SLD
ECC20DCSH-S288 CONN EDGECARD 40POS .100 EXTEND
相关代理商/技术参数
参数描述
UCC3805D 功能描述:电流型 PWM 控制器 Low-Power BiCMOS Current-Mode PWM RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14
UCC3805DG4 功能描述:电流型 PWM 控制器 Low-Power BiCMOS Current-Mode PWM RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14
UCC3805DTR 功能描述:电流型 PWM 控制器 Low-Power BiCMOS Current-Mode PWM RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14
UCC3805DTR/81222G4 制造商:TI 制造商全称:Texas Instruments 功能描述:Low-Power BiCMOS Current-Mode PWM
UCC3805DTRG4 功能描述:电流型 PWM 控制器 Low-Power BiCMOS Current-Mode PWM RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14