- 您现在的位置：买卖IC网 > PDF目录1251 > UM232R (FTDI, Future Technology Devices International Ltd)MOD USB UART DEV FT232R PDF资料下载
参数资料
| 型号： | UM232R |
| 厂商： | FTDI, Future Technology Devices International Ltd |
| 文件页数： | 18/28页 |
| 文件大小： | 0K |
| 描述： | MOD USB UART DEV FT232R |
| 产品培训模块： | USB Introduction USB-UART Interface Solutions |
| 产品目录绘图： | UM232R |
| 标准包装： | 5 |
| 主要目的： | 接口，USB 2.0 至 UART（RS232）电桥 |
| 嵌入式： | 否 |
| 已用 IC / 零件： | FT232R |
| 主要属性： | 全速，300 ~ 3 MB 速率，安全识别号 |
| 次要属性： | 6 ~ 48MHz 时钟发生器输出，免版税驱动器 |
| 已供物品： | 板 |
| 产品目录页面： | 633 (CN2011-ZH PDF) |
| 相关产品： | 768-1008-6-ND - IC USB FS SERIAL UART 32-QFN 768-1007-6-ND - IC USB FS SERIAL UART 28-SSOP 768-1008-1-ND - IC USB FS SERIAL UART 32-QFN 768-1007-1-ND - IC USB FS SERIAL UART 28-SSOP 768-1008-2-ND - IC USB FS SERIAL UART 32-QFN 768-1007-2-ND - IC USB FS SERIAL UART 28-SSOP |
| 其它名称： | 768-1019 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页当前第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
Document Reference No.: FT_000051
UM232R USB - Serial UART Development Module
Datasheet Version 1.1
Clearance No.: FTDI# 125
7.2 Self Powered Configuration
Vcc = 3.3V – 5V
UM232R ? FTDI 2008
Vcc = 4.0V – 5V
TXD
1
1
2
3
24
GND
J1
TXD
RXD
RTS# 3
RTS#
21
VCC
CTS#
RXD
5
20
RST#
MCU
GND
7
17
16
PU1
PU2
CTS#
10
2
1
15
VCC
12
J2
14
13
USB
Figure 7.2 Self-Powered Configuration
Figure 7.2 illustrates the UM232R in a typical USB self powered configuration. In this case the link on
jumper J2 is removed, and an external supply is connected to the module VCC pins. Figure 7.2 illustrates a
self powered design which has a 4.0V – 5V supply.
A USB Self Powered device gets its power from its own power supply and does not draw current from the
USB bus. The basic rules for USB Self powered devices are as follows:
i) A Self Powered device should not force current down the USB bus when the USB Host or Hub
Controller us powered down.
ii) A Self Powered Device can use as much current as it likes during normal operation and USB suspend
as it has its own power supply.
iii) A Self Powered Device can be used with any USB Host and both Bus and Self Powered USB Hub. In
this case the power descriptor in the internal EEPROM should be programmed to a value of zero (self
powered).
In order to meet requirement (i) the USB Power is used to control the RESET# Pin of the FT232R device.
When the USB Host or Hub is powered up the internal 1.5kΩ resistor on USBDP is pulled up to 3.3V, thus
identifying the devices as a full speed device to USB. When the USB Host or Hub Power is off, RESET# will
go low and the device will be held in reset. As RESET# is low, the internal 1.5kΩ resistor will not be pulled
up to 3.3V, so no current will be forced down USBDP via the 1.5kΩ pull -up resistor when the host or hub is
powered down.
To do this pin 14 (USB) is connected to PU2 and PU1 is connected to RST#. Failure to do this may cause
some USB host or hub controllers to power up erratically.
Note: When the FT232R is in reset, the UART interface pins all go tri-state. These pins have internal 200kΩ
pull-up resistors to VCCIO, so they will gently pull high unless driven by some external logic.
? Copyright 2005-2011 Future Technology Devices International Ltd
17
相关PDF资料 |
PDF描述 |
|---|---|
| UM245R | MOD USB PARALLEL FIFO DEV FT245R |
| UMTS 2 | FUSE 2A 250V TLAG IEC SMD |
| UPG1-4-61-303-01 | MAGNETIC CIRC BRKR SP 30A TOG SW |
| UPL111-1-60-503 | MAGNETIC CIRCUIT PROTECTOR 50A |
| UPL2000-D1/B | BNC PLUG CRIMP STR 7538CBL 50/PK |
相关代理商/技术参数 |
参数描述 |
|---|---|
| UM233 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Analog IC |
| UM233M | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Analog IC |
| UM234 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Analog IC |
| UM2341 | 制造商:Coto Technology 功能描述:Reed Switch 制造商:Coto Technology 功能描述:SWITCH, REED, SPST, 500mA, 175VDC, Contact Configuration:SPST, Switching Voltage |
| UM234M | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Analog IC |
发布紧急采购，3分钟左右您将得到回复。