- 您现在的位置：买卖IC网 > PDF目录200646 > UPD78P0308YGF-3BA-A 8-BIT, OTPROM, 5 MHz, MICROCONTROLLER, PQFP100 PDF资料下载
参数资料
| 型号： | UPD78P0308YGF-3BA-A |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 8-BIT, OTPROM, 5 MHz, MICROCONTROLLER, PQFP100 |
| 封装： | 14 X 20 MM, LEAD FREE, PLASTIC, QFP-100 |
| 文件页数： | 50/64页 |
| 文件大小： | 2786K |
| 代理商： | UPD78P0308YGF-3BA-A |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页当前第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页
52
CHAPTER 3
PIN FUNCTION (
PD780308 SUBSERIES)
User’s Manual U11377EJ3V0UD
3.2.9 P110 to P117 (Port 11)
These are 8-bit I/O ports. Besides serving as I/O ports, they function as serial interface data I/O and clock I/O.
The following operating modes can be specified in 1-bit units.
(1) Port mode
These ports function as 8-bit I/O ports. They can be specified as input or output ports in 1-bit units with port
mode register 11 (PM11). When they are used as input ports, internal pull-up resistors can be used by defining
pull-up resistor option register H (PUOH).
When the falling edge is detected on a specified bit of this port, test input flag (KRIF) can be set to 1.
(2) Control mode
These ports function as serial interface data I/O and clock I/O.
(a) SI3, SO3
Serial interface serial data I/O pins.
(b) SCK3
Serial interface serial clock I/O pin.
(c) RxD, TxD
Asynchronous serial interface serial data I/O pins.
Caution When this port is used as a serial interface, the I/O and output latches must be set according
to the function used. For the setting, refer to Table 17-2 Serial Interface Channel 2 Operating
Mode Settings, and Figure 18-3 Serial Operating Mode Register 3 Format.
3.2.10 COM0 to COM3
These are LCD controller/driver common signal output pins. They output common signals under either of the
following conditions:
– when the static mode is selected (COM0 to COM3 outputs)
– when 2-time-division (COM0, COM1 outputs) or 3-time-division (COM0 to COM2 outputs) operation is performed
in 1/2 bias mode
– when 3-time-division (COM0 to COM2 outputs) or 4-time-division (COM0 to COM3 outputs) operation is
performed in 1/3 bias mode
3.2.11
VLC0 to VLC2
These are LCD-driving voltage pins. The mask ROM versions can have split resistors by mask option so that LCD
driving voltage can be supplied inside the VLC0 to VLC2 pins according to the required bias without connecting external
split resistors.
3.2.12
BIAS
This is a LCD driving power supply pin. This pin should be connected to the VLC0 pin to realize user-desired LCD
drive voltages to change resistance division ratios, or should be connected to external resistors together with the VLC0
to VLC2 pins and VSS1 pin to fine-adjust the LCD-driving power voltage.
相关PDF资料 |
PDF描述 |
|---|---|
| UPD78053GK-XXX-BE9 | 8-BIT, MROM, MICROCONTROLLER, PQFP80 |
| UPD78214G36 | 8-BIT, MROM, 12 MHz, MICROCONTROLLER, PQIP64 |
| UPD784224YGK-XXX-9EU-A | 16-BIT, MROM, 12.5 MHz, MICROCONTROLLER, PQFP80 |
| UPD784224YGK-XXX-9EU | 16-BIT, MROM, 12.5 MHz, MICROCONTROLLER, PQFP80 |
| UPD789022GB-XXX-8ES-A | 8-BIT, MROM, 5 MHz, MICROCONTROLLER, PQFP44 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| UPD78P054GC-3B9 | 制造商:Renesas Electronics Corporation 功能描述: |
| UPD78P054GC-3B9-A | 制造商:Renesas Electronics Corporation 功能描述: |
| UPD78P058GC-8BT-A-TDP | 制造商:Renesas Electronics Corporation 功能描述: |
| UPD78P058YGC-8BT | 制造商:Renesas Electronics Corporation 功能描述: |
| UPD78P078GC-8EU-A | 制造商:Renesas Electronics 功能描述:78K0 5MHz |
发布紧急采购，3分钟左右您将得到回复。