- 您现在的位置：买卖IC网 > PDF目录21938 > US5881LUA-AAA-000-BU (Melexis Technologies NV)IC HALL EFFECT SW MP TO-92UA PDF资料下载
参数资料
| 型号： | US5881LUA-AAA-000-BU |
| 厂商： | Melexis Technologies NV |
| 文件页数： | 14/46页 |
| 文件大小： | 498K |
| 描述： | IC HALL EFFECT SW MP TO-92UA |
| 产品目录绘图： | UA-92 Series Side |
| 标准包装： | 1,000 |
| 传感范围： | 30mT 跳闸，9.5mT 释放 |
| 类型： | 单极开关 |
| 电源电压： | 3.5 V ~ 24 V |
| 电流 - 电源： | 5mA |
| 电流 - 输出（最大）： | 50mA |
| 输出类型： | 数字式，开漏极 |
| 工作温度： | -40°C ~ 150°C |
| 封装/外壳： | TO-226-3，TO-92-3 短体 |
| 供应商设备封装： | TO-92UA |
| 包装： | 散装 |
| 产品目录页面： | 2792 (CN2011-ZH PDF) |
| 其它名称： | US5881LUA US5881LUA-ND |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页当前第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页
A magnet in a closed high permeability magnetic circuit (an iron bar connecting the north to the south pole)
will operate at or near the Br value. A magnet with no pole pieces will operate with a flux density down the
demagnetization curve from the Br value, how far down is dependant on the aspect ratio or the ratio of the
length to the diameter. Short wide magnets will generate lower flux than tall skinny magnets of the same vol-
ume.
The concept of the load line and the operating point on the demagnetization curve will influence many magnet-
ic parameters. These include the flux density available to actuate a sensor and the reversible temperature coeffi-
cient.
Temperature Effects
Graphical representations are often used to determine the operating point on the demagnetization curve.
Temperature effects on permanent magnets are dependent on the type of material considered. Manufacturers will
specify various figures of merit to describe the temperature performance of magnet materials. Among these are
the Reversible losses that are represented by Tc. The term refers to the losses in the Br and the Hc. A calcula-
tion can show that for every incremental change in temperature the magnet will lose a proportion of its strength.
This loss will be recovered completely so long as the temperature does not exceed the Tmax or maximum prac-
tical operating temperature in air. The Tmax value is dependent on the magnets operating point on the demag-
netization curve. A magnet operating closer to Br can have a higher Tmax. Irreversible losses are described as
losses that can only be recovered by re-magnetizing the sample to saturation with an electromagnetic field. These
losses occur when the operating point falls below the "knee" on the demagnetization curve. This can occur due
to temperature and inefficient magnetic circuit design. An important feature of magnet materials is the Curie tem -
perature, TCurie,. This is a temperature at which the metallurgical properties of the sample are adversely effect
ed. In most applications the ambient temperature can never approach the Curie temperature without completely
destroying the electronic components first.
Losses Over Time
Time has minimal effect on the strength of permanent magnets. Long term studies in the industry have shown
that at 100,000 hours the losses for Rare Earth Samarium Cobalt magnets were essentially zero and for Alnico
5 were less than 3%. In the case of Rare Earth Neodymium materials the losses are compounded by internal cor-
rosion.
Corrosion & Coatings
It is often necessary to provide coatings to these materials to minimize the corrosion that results from the Iron
content. We lay-people refer to this stuff as rust. The options for coatings include epoxies, zinc and nickel. The
best of these is nickel however it is slightly magnetic and marginally reduces the available field. Coatings can
also be useful with Rare Earth Samarium to minimize "spalling" or the fracture of tiny slivers from the corners
of this brittle, hard material.
In many sensor applications these characteristics are of little significance but as with all engineering tasks it is
up to the design engineer to know what can safely be ignored and what must be consider for the projects suc-
cess.
Many texts are available to aid in a complete understanding of magnets. The Magnetic Material Producers
Association is a trade group that establishes and maintains standards for basic grades and classes of materials.
Their reference booklets are an excellent source for detailed technical data on the various generic classes of mate
rials. Certain manufacturers also provide excellent databooks with helpful applications and design sections.
These include Arnold Engineering Company, Magnet Sales & Manufacturing, Magnetfabrik Schramberg,
Hitachi Metals; Magnetic Materials Division and Widia Magnettechnik.
相关PDF资料 |
PDF描述 |
|---|---|
| F1827SD600 | MODULE SCR/DIODE 25A 240VAC |
| US2881EUA-AAA-000-BU | IC LATCH CMOS H-SEN TO-92UA |
| US4881LUA-AAA-000-BU | IC LATCH CMOS H-S TO-92UA |
| DOC052V-010.0M | OSC OCVCXO 10.0 MHZ 3.3V SMT |
| AH337-PL-B | IC HALL SWITCH 1PH 25MA SIP-3L |
相关代理商/技术参数 |
参数描述 |
|---|---|
| US5A | 制造商:JINANJINGHENG 制造商全称:Jinan Jingheng (Group) Co.,Ltd 功能描述:Surface Mount ultra FAST Rectifier |
| US5A10AS17120 | 制造商:NEC 制造商全称:NEC 功能描述:4-BIT SINGLE-CHIP MICROCONTROLLER |
| US5A10AS17K | 制造商:NEC 制造商全称:NEC 功能描述:4-BIT SINGLE-CHIP MICROCONTROLLER |
| US5A10IE17K | 制造商:NEC 制造商全称:NEC 功能描述:4-BIT SINGLE-CHIP MICROCONTROLLER |
| US5A13AS17120 | 制造商:NEC 制造商全称:NEC 功能描述:4-BIT SINGLE-CHIP MICROCONTROLLER |
发布紧急采购，3分钟左右您将得到回复。