参数资料
型号: VI-ARM-M1F
元件分类: 电源模块
英文描述: 1-OUTPUT 500 W AC-DC REG PWR SUPPLY MODULE
封装: ROHS COMPLIANT PACKAGE-7
文件页数: 7/11页
文件大小: 705K
代理商: VI-ARM-M1F
Vicor Corp. Tel: 800-735-6200, 978-470-2900 Fax: 978-475-6715
ARM, Autoranging Rectifier Module
Rev. 3.9
Page 5 of 11
Set your site on VICOR at vicorpower.com
The VI-ARM Autoranging Rectifier Module (ARM) provides
an effective solution for the AC front end of a power supply
designed with Vicor DC-DC converters. This high performance
power system building block satisfies a broad spectrum of
requirements and agency standards.
The ARM contains all of the power switching and control
circuitry necessary for autoranging rectification, inrush current
limiting, and overvoltage protection. This module also provides
converter enable and status functions for orderly power
up/down control or sequencing. To complete the AC front-end
configuration, the user needs only to add holdup capacitors and
a suitable input filter with transient protection.
Functional Description
Initial Conditions.
The switch that bypasses the inrush
limiting PTC (positive temperature coefficient) thermistor is
open when power is applied, as is the switch that engages the
strap for voltage doubling. (See Fig. 8). In addition, the
downstream DC-DC modules are disabled via the Enable (EN)
line, and Bus-OK (B OK) is high.
Power-Up Sequence.
(See Fig. 9).:
Upon application of input power, the output bus capacitors
begin to charge. The thermistor limits the charge current,
and the exponential time constant is determined by the
holdup capacitor value and the thermistor cold resistance.
The slope (dv/dt) of the capacitor voltage approaches zero
as the capacitors become charged to the peak of the AC
line voltage.
If the bus voltage is less than 200 V as the slope nears
zero, the voltage doubler is activated, and the bus voltage
climbs exponentially to twice the peak line voltage.
If the bus voltage is greater than 200 V, the doubler is
not activated.
If the bus voltage is greater than 235 V as the slope
approaches zero, the inrush limiting thermistor is
bypassed. Below 235 V, the thermistor is not bypassed.
The converters are enabled ~150 milliseconds after the
thermistor bypass switch is closed.
Bus-OK is asserted after an additional ~150 millisecond
delay to allow the converter outputs to settle within
specification.
Power-Down Sequence.
(See Fig. 9). When input power is
turned off or fails, the following sequence occurs as the bus
voltage decays:
Bus-OK is deasserted when the bus voltage falls below
205 Vdc (Typ.).
The converters are disabled when the bus voltage falls
below 200 Vdc. If power is reapplied after the converters
are disabled, the entire power-up sequence is repeated. If
a momentary power interruption occurs and power is
reestablished before the bus reaches the disable threshold,
the power-up sequence is not repeated.
APPLICATION NOTE
Microcontroller
N
L
PTC
Thermistor
+OUT
–OUT
Strap
EN
BOK
Strap
400
300
200
100
0
90–132 V
AC Line
Output
Bus
(Vdc)
Strap
PTC
Thermistor
Bypass
Converter
Enable
Bus OK
~150 ms
Power
Up
Power
Down
4.1
1.1
2.1
3.1
5.1
2.2
1.2
~150 ms
Figure 8 — Functional block diagram
Figure 9 — Timing diagram: power up/down sequence
1.1
2.1
3.1
4.1
5.1
1.2
2.2
相关PDF资料
PDF描述
VRPB-10D50SG 1-OUTPUT 50 W DC-DC REG PWR SUPPLY MODULE
V24A15C400AL 1-OUTPUT 400 W DC-DC REG PWR SUPPLY MODULE
V300C1V8C45AN3 1-OUTPUT 45 W DC-DC REG PWR SUPPLY MODULE
V24A24C400AN3 1-OUTPUT 400 W DC-DC REG PWR SUPPLY MODULE
V375C12H150AL2 1-OUTPUT 150 W DC-DC REG PWR SUPPLY MODULE
相关代理商/技术参数
参数描述
VI-ARM-M1N 制造商:VICOR 制造商全称:Vicor Corporation 功能描述:Autoranging Rectifier Modules Up to 1500 Watts
VI-ARM-M1S 制造商:VICOR 制造商全称:Vicor Corporation 功能描述:Autoranging Rectifier Modules Up to 1500 Watts
VI-ARM-M21 制造商:VICOR 制造商全称:Vicor Corporation 功能描述:Autoranging Rectifier Modules Up to 1500 Watts
VI-ARM-M22 制造商:VICOR 制造商全称:Vicor Corporation 功能描述:Autoranging Rectifier Modules Up to 1500 Watts
VI-ARM-M2N 制造商:VICOR 制造商全称:Vicor Corporation 功能描述:Autoranging Rectifier Modules Up to 1500 Watts