参数资料
| 型号： | X4285V8I-4.5A |
| 厂商： | Intersil |
| 文件页数： | 8/22页 |
| 文件大小： | 0K |
| 描述： | IC SUPERVISOR CPU 128K EE 8TSSOP |
| 标准包装： | 100 |
| 类型： | 简单复位/加电复位 |
| 监视电压数目： | 1 |
| 复位： | 高有效 |
| 复位超时： | 最小为 100 ms |
| 电压 - 阀值： | 4.62V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 8-TSSOP |
| 包装： | 管件 |
X4283, X4285
The state of the Control Register can be read at any
time by performing a random read at address FFFFh.
Only one byte is read by each register read operation.
The X4283, X4285 resets itself after the first byte is
WD1, WD0: Watchdog Timer Bits
The bits WD1 and WD0 control the period of the
Watchdog Timer. The options are shown below.
read. The master should supply a stop condition to be
consistent with the bus protocol, but a stop is not
required to end this operation.
WD1
0
0
WD0
0
1
Watchdog Time Out Period
1.4 seconds
600 milliseconds
7
6
5
4
3
2
1
0
1
0
200 milliseconds
WPEN WD1 WD0 BP1 BP0
RWEL
WEL BP2
1
1
disabled (factory setting)
RWEL: Register Write Enable Latch (Volatile)
The RWEL bit must be set to “1” prior to a write to the
Control Register.
WEL: Write Enable Latch (Volatile)
The WEL bit controls the access to the memory and to
the Register during a write operation. This bit is a vola-
tile latch that powers up in the LOW (disabled) state.
While the WEL bit is LOW, writes to any address,
including any control registers will be ignored (no
acknowledge will be issued after the Data Byte). The
WEL bit is set by writing a “1” to the WEL bit and
zeroes to the other bits of the control register. Once
set, WEL remains set until either it is reset to 0 (by
writing a “0” to the WEL bit and zeroes to the other bits
of the control register) or until the part powers up
again. Writes to the WEL bit do not cause a nonvolatile
write cycle, so the device is ready for the next opera-
tion immediately after the stop condition.
BP2, BP1, BP0: Block Protect Bits (Nonvolatile)
The Block Protect Bits, BP2, BP1 and BP0, determine
which blocks of the array are write protected. A write to
a protected block of memory is ignored. The block pro-
tect bits will prevent write operations to one of eight
segments of the array.
Write Protect Enable
These devices have an advanced Block Lock scheme
that protects one of eight blocks of the array when
enabled. It provides hardware write protection through
the use of a WP pin and a nonvolatile Write Protect
Enable (WPEN) bit. Four of the 8 protected blocks
match the original Block Lock segments and this pro-
tection scheme is fully compatible with the current
devices using 2 bits of block lock control (assuming
the BP2 bit is set to 0).
The Write Protect (WP) pin and the Write Protect
Enable (WPEN) bit in the Control Register control the
programmable Hardware Write Protect feature. Hard-
ware Write Protection is enabled when the WP pin and
the WPEN bit are HIGH and disabled when either the
WP pin or the WPEN bit is LOW. When the chip is
Hardware Write Protected, nonvolatile writes as well as
to the block protected sections in the memory array
cannot be written. Only the sections of the memory
array that are not block protected can be written. Note
that since the WPEN bit is write protected, it cannot be
changed back to a LOW state; so write protection is
enabled as long as the WP pin is held HIGH.
Protected Addresses
(Size)
Array Lock
0
0
0
0
0
1
0
1
0
None (factory setting)
3000h - 3FFFh (4K bytes )
2000h - 3FFFh (8K bytes )
None
Upper 1/4 (Q4)
Upper 1/2 (Q3,Q4)
0
1
1 0000h - 3FFFh (16K bytes)
Full Array (All)
1
1
1
1
0
0
1
1
0
1
0
1
000h - 03Fh (64 bytes)
000h - 07Fh (128 bytes)
000h - 0FFh (256 bytes)
000h - 1FFh (512 bytes)
First Page (P1)
First 2 pgs (P2)
First 4 pgs (P4)
First 8 pgs (P8)
8
FN8121.1
May 23, 2006
相关PDF资料 |
PDF描述 |
|---|---|
| X4325V8I-4.5A | IC SUPERVISOR CPU 32K EE 8-TSSOP |
| X45620V20I-2.7 | IC VOLT MON DUAL SW EEPR 20TSSOP |
| X4645V8I-4.5A | IC SUPERVISOR CPU 64K EE 8-TSSOP |
| X4C105V20I | IC SUPERVISOR NOVRAM/EE 20-TSSOP |
| X5001V8I-4.5A | IC SUPERVISOR CPU 8-TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| X-428796A | 制造商:Volex Group 功能描述:LEAD BLACK 2.5M AUSTRALIAN 制造商:Volex Group 功能描述:LEAD, BLACK, 2.5M, AUSTRALIAN |
| X-428802A | 制造商:Volex Group 功能描述:LEAD HOT CONDITION BLACK 2M 制造商:Volex Group 功能描述:LEAD, HOT CONDITION, BLACK, 2M 制造商:Volex Group 功能描述:LEAD, HOT CONDITION, BLACK, 2M; Connector Type A:IEC Socket; Connector Type B:Wire; Voltage Rating:250V; Current Rating:10A; Cable Length - Imperial:6.56ft; Cable Length - Metric:2m; Jacket Colour:Black; SVHC:No SVHC (18-Jun-2012); ;RoHS Compliant: Yes |
| X431 | 制造商:CONNOR-WINFIELD 制造商全称:Connor-Winfield Corporation 功能描述:3.3V SURFACE MOUNT 5.0 x 7.5mm LVPECL CLOCK OSCILLATOR |
| X431-312.5M | 制造商:CONNOR-WINFIELD 制造商全称:Connor-Winfield Corporation 功能描述:3.3V SURFACE MOUNT 5.0 x 7.5mm LVPECL CLOCK OSCILLATOR |
| X432-133.33M | 制造商:CONNOR-WINFIELD 制造商全称:Connor-Winfield Corporation 功能描述:5.0x7.0mm Surface Mount LVCMOS Clock Oscillator Series |
发布紧急采购，3分钟左右您将得到回复。