- 您现在的位置：买卖IC网 > PDF目录13090 > X4285V8I (Intersil)IC SUPERV 128K EE RST HI 8TSSOP PDF资料下载
参数资料
| 型号： | X4285V8I |
| 厂商： | Intersil |
| 文件页数： | 15/22页 |
| 文件大小： | 0K |
| 描述： | IC SUPERV 128K EE RST HI 8TSSOP |
| 标准包装： | 200 |
| 类型： | 简单复位/加电复位 |
| 监视电压数目： | 1 |
| 复位： | 高有效 |
| 复位超时： | 最小为 100 ms |
| 电压 - 阀值： | 4.38V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 8-TSSOP |
| 包装： | 管件 |
X4283, X4285
Figure 15. X4283, X4285 Addressing
Device Identifier
Device Select
1
0
1
0
0
S1
S0
R/W
Slave Address Byte
High Order Word Address
0
0
A13
(X7)
A12
(X6)
A11
(X5)
A10
(X4)
A9
(X3)
A8
(X2)
Word Address Byte 0–128K
Low Order Word Address
A7
(X1)
A6
(X0)
A5
(Y5)
A4
(Y4)
A3
(Y3)
A2
(Y2)
A1
(Y1)
A0
(Y0)
Word Address Byte 0 for all Options
D7
D6
D5
D4
D3
D2
D1
D0
Data Byte for all Options
Operational Notes
The device powers-up in the following state:
– The device is in the low power standby state.
– The WEL bit is set to ‘0’. In this state it is not possi-
ble to write to the device.
– SDA pin is the input mode.
– RESET/RESET Signal is active for t PURST .
– Communication to the device is inhibited while
RESET/RESET is active and any in-progress
communication is terminated.
– Block Lock bits can protect sections of the memory
array from write operations.
SYMBOL TABLE
Data Protection
The following circuitry has been included to prevent
inadvertent writes:
– The WEL bit must be set to allow write operations.
– The proper clock count and bit sequence is required
prior to the stop bit in order to start a nonvolatile
write cycle.
– A three step sequence is required before writing into
the Control Register to change Watchdog Timer or
Block Lock settings.
– The WP pin, when held HIGH, and WPEN bit at logic
HIGH will prevent all writes to the Control Register.
15
WAVEFORM
INPUTS
Must be
steady
May change
from LOW
to HIGH
May change
from HIGH
to LOW
Don’t Care:
Changes
Allowed
N/A
OUTPUTS
Will be
steady
Will change
from LOW
to HIGH
Will change
from HIGH
to LOW
Changing:
State Not
Known
Center Line
is High
Impedance
FN8121.1
May 23, 2006
相关PDF资料 |
PDF描述 |
|---|---|
| 80ZLJ1200M18X40 | CAP ALUM 1200UF 80V 20% RADIAL |
| 1812-822J | INDUCTOR UNSHIELDED 8.2UH SMD |
| ASM22DRTI-S13 | CONN EDGECARD 44POS .156 EXTEND |
| MIC5236-3.3YMM | IC REG LDO 3.3V .15A 8-MSOP |
| X4285V8-2.7 | IC SUPERV 128K EE RST HI 8TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| X4285V8I-2.7 | 功能描述:IC SUPERV 128K EE RST HI 8TSSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 监控器 系列:- 标准包装:1 系列:- 类型:简单复位/加电复位 监视电压数目:1 输出:开路漏极或开路集电极 复位:低有效 复位超时:标准传输延迟为 60 µs 电压 - 阀值:3V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SC-74A，SOT-753 供应商设备封装:SOT-23-5 包装:Digi-Reel® 其它名称:LM8364BALMF30DKR |
| X4285V8I-2.7A | 功能描述:IC SUPERVISOR CPU 128K EE 8TSSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 监控器 系列:- 标准包装:100 系列:- 类型:简单复位/加电复位 监视电压数目:1 输出:- 复位:低有效 复位超时:最小为 100 ms 电压 - 阀值:4.38V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:8-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:8-TSSOP 包装:管件 |
| X4285V8I-4.5A | 功能描述:IC SUPERVISOR CPU 128K EE 8TSSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 监控器 系列:- 标准包装:100 系列:- 类型:简单复位/加电复位 监视电压数目:1 输出:- 复位:低有效 复位超时:最小为 100 ms 电压 - 阀值:4.38V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:8-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:8-TSSOP 包装:管件 |
| X-428796A | 制造商:Volex Group 功能描述:LEAD BLACK 2.5M AUSTRALIAN 制造商:Volex Group 功能描述:LEAD, BLACK, 2.5M, AUSTRALIAN |
| X-428802A | 制造商:Volex Group 功能描述:LEAD HOT CONDITION BLACK 2M 制造商:Volex Group 功能描述:LEAD, HOT CONDITION, BLACK, 2M 制造商:Volex Group 功能描述:LEAD, HOT CONDITION, BLACK, 2M; Connector Type A:IEC Socket; Connector Type B:Wire; Voltage Rating:250V; Current Rating:10A; Cable Length - Imperial:6.56ft; Cable Length - Metric:2m; Jacket Colour:Black; SVHC:No SVHC (18-Jun-2012); ;RoHS Compliant: Yes |
发布紧急采购，3分钟左右您将得到回复。