- 您现在的位置：买卖IC网 > PDF目录1883 > XC9235A33DER-G (Torex Semiconductor Ltd)IC REG BUCK SYNC 3.3V 0.6A USP-6 PDF资料下载
参数资料
| 型号： | XC9235A33DER-G |
| 厂商： | Torex Semiconductor Ltd |
| 文件页数： | 18/34页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC 3.3V 0.6A USP-6 |
| 标准包装： | 3,000 |
| 类型： | 降压（降压） |
| 输出类型： | 固定 |
| 输出数： | 1 |
| 输出电压： | 3.3V |
| 输入电压： | 2 V ~ 6 V |
| 频率 - 开关： | 3MHz |
| 电流 - 输出： | 600mA |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 6-UFDFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | USP-6C |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页当前第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页
XC9235/XC9236/XC9237 Series
■ NOTE ON USE
1. For temporary, transitional voltage drop or voltage rising phenomenon, the IC is liable to malfunction should the ratings be
exceeded.
2. The XC9235/XC9236/XC9237 series is designed for use with ceramic output capacitors. If, however, the potential
difference is too large between the input voltage and the output voltage, a ceramic capacitor may fail to absorb the resulting
high switching energy and oscillation could occur on the output.
If the input-output potential difference is large, connect an
electrolytic capacitor in parallel to compensate for insufficient capacitance.
3. Spike noise and ripple voltage arise in a switching regulator as with a DC/DC converter. These are greatly influenced by
external component selection, such as the coil inductance, capacitance values, and board layout of external components.
Once the design has been completed, verification with actual components should be done.
4. Depending on the input-output voltage differential, or load current, some pulses may be skipped, and the ripple voltage may
increase.
5. When the difference between V IN and V OUT is large in PWM control, very narrow pulses will be outputted, and there is the
possibility that some cycles may be skipped completely.
6. When the difference between V IN and V OUT is small, and the load current is heavy, very wide pulses will be outputted and
there is the possibility that some cycles may be skipped completely.
7. With the IC, the peak current of the coil is controlled by the current limit circuit. Since the peak current increases when
dropout voltage or load current is high, current limit starts operation, and this can lead to instability. When peak current
becomes high, please adjust the coil inductance value and fully check the circuit operation. In addition, please calculate
the peak current according to the following formula:
Ipk = (V IN - V OUT ) x OnDuty / (2 x L x f OSC ) + I OUT
L: Coil Inductance Value
f OSC : Oscillation Frequency
8. When the peak current which exceeds limit current flows within the specified time, the built-in Pch MOS driver transistor
turns off. During the time until it detects limit current and before the built-in transistor can be turned off, the current for limit
current flows; therefore, care must be taken when selecting the rating for the external components such as a coil.
9. When V IN is less than 2.4V, limit current may not be reached because voltage falls caused by ON resistance.
10. Care must be taken when laying out the PC Board, in order to prevent misoperation of the current limit mode. Depending
on the state of the PC Board, latch time may become longer and latch operation may not work. In order to avoid the effect of
noise, the board should be laid out so that input capacitors are placed as close to the IC as possible.
11. Use of the IC at voltages below the recommended voltage range may lead to instability.
12. This IC should be used within the stated absolute maximum ratings in order to prevent damage to the device.
13. When the IC is used in high temperature, output voltage may increase up to input voltage level at no load because of the
leak current of the driver transistor.
14. The current limit is set to 1350mA (MAX.) at typical. However, the current of 1350mA or more may flow. In case that the
current limit functions while the V OUT pin is shorted to the GND pin, when Pch MOS driver transistor is ON, the potential
difference for input voltage will occur at both ends of a coil.
For this, the time rate of coil current becomes large. By
contrast, when Nch MOS driver transistor is ON, there is almost no potential difference at both ends of the coil since the
V OUT pin is shorted to the GND pin. Consequently, the time rate of coil current becomes quite small. According to the
repetition of this operation, and the delay time of the circuit, coil current will be converged on a certain current value,
exceeding the amount of current, which is supposed to be limited originally. Even in this case, however, after the over
current state continues for several ms, the circuit will be latched. A coil should be used within the stated absolute
maximum rating in order to prevent damage to the device.
① Current flows into Pch MOS driver transistor to reach the current limit (I LIM ).
② The current of I LIM or more flows since the delay time of the circuit occurs during from the detection of the current limit to
OFF of Pch MOS driver transistor.
③ Because of no potential difference at both ends of the coil, the time rate of coil current becomes quite small.
④ Lx oscillates very narrow pulses by the current limit for several ms.
⑤ The circuit is latched, stopping its operation.
18/34
相关PDF资料 |
PDF描述 |
|---|---|
| XC9243B08DDR-G | IC REG BUCK SYNC ADJ 2A USP-10B |
| XC9303B093KR-G | IC REG CTRLR BST PWM 8-MSOP |
| XC9503B093AR-G | IC REG BUCK ADJ 1A DL 10MSOP |
| XC9519A12AZR-G | IC REG BOOST INV ADJ 2A DL 24QFN |
| XRP29302ETB-L | IC REG LDO ADJ 3A TO263-5 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| XC9235A33DMR-G | 功能描述:IC REG BUCK SYNC 3.3V SOT25-5 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:500 系列:- 类型:切换式电容器（充电泵），反相 输出类型:固定 输出数:1 输出电压:-3V 输入电压:2.3 V ~ 5.5 V PWM 型:Burst Mode? 频率 - 开关:900kHz 电流 - 输出:100mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 细型，TSOT-23-6 包装:带卷 (TR) 供应商设备封装:TSOT-23-6 其它名称:LTC1983ES6-3#TRMTR |
| XC9235B08C4R-G | 制造商:TOREX 制造商全称:Torex Semiconductor 功能描述:600mA Driver Tr. Built-In, Synchronous Step-Down DC/DC Converters |
| XC9235B08CER | 制造商:TOREX 制造商全称:Torex Semiconductor 功能描述:600mA Driver Tr. Built-In, Synchronous Step-Down DC/DC Converters |
| XC9235B08CER-G | 制造商:TOREX 制造商全称:Torex Semiconductor 功能描述:600mA Driver Tr. Built-In, Synchronous Step-Down DC/DC Converters |
| XC9235B08CMR | 制造商:TOREX 制造商全称:Torex Semiconductor 功能描述:600mA Driver Tr. Built-In, Synchronous Step-Down DC/DC Converters |
发布紧急采购，3分钟左右您将得到回复。