- 您现在的位置：买卖IC网 > Datasheet目录58 > XIB-E (Digi International/Maxstream)BOARD INTERFACE ETHERNET Datasheet资料下载
参数资料
| 型号： | XIB-E |
| 厂商： | Digi International/Maxstream |
| 文件页数： | 53/64页 |
| 文件大小： | 1858K |
| 描述： | BOARD INTERFACE ETHERNET |
| 标准包装： | 1 |
| 附件类型： | 接口板 |
| 适用于相关产品： | XStream 和 Xcite 收音机 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页当前第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页
XStream"燨EM燫F燤odule?燩roduct燤anual爒5.x00燵2006.02.24]?/DIV>
MaxStream RS-232/485 Interface Board
B-01a. Power Switch
Figure燘01. Front燰iew?/DIV>
牋牘?006燤axStream,營nc.燙onfidential燼nd燩roprietary?/DIV>
53?/DIV>
B-01b. LEDs
The LED indicators visualize diagnostic status information. The
modules status is represented as follows:
erial Data Out (to host)
m) = Power/TX Indicator (Red light is on when
riefly during RF transmission)
Yellow (top LED) = S
Green (middle) = Serial Data In (from host)
Red (botto
powered, off b
B-01c. Serial Port
Standard female DB-9 (RS-232) DCE connector T
nnector
-422 connectio
his co
can be also used for RS-485 and RS
ns.
B-01d. Power Connector
7-18 VDC Power Connector (Center positive, 5.5/2.1mm) Power
B-9 Serial Port.
can also be supplied through Pin 9 of the D
B-02a. DIP Switch
Figure燘02. Back燰iew?/DIV>
ot b
ime
the module assembly is powered-on, the processor must be
disabled by populating J7 on the interface board.
B-02b. Config (Configuration) Switch
NOTE: In cases where AT Commands should n
e sent each t
The Configuration Switch provides an alternate way to enter AT
Command Mode . To enter AT Command Mode at the modules
default baud rate, hold the Configuration Switch down while
powering on the module using the Power Switch [B-01a].
Figure燘03. MaxStream燲IB
Move the Power Switch to the on (up) position to power the
Interface Board. DIP Switch [B.2a] settings are only read
during a power-up sequence.
R?RS232/485)營nterface燘oard燚IP燬witch燬ettings?/DIV>
The DIP Switch automatically configures the XStrea
e the module
ow
ms the module
e
m OEM RF
Module to operate in different modes. Each tim
assembly (interface board + the RF Module) is p ered-on,
intelligence on the XIB-R interface board progra
according to the positions of the DIP Switch. [Se figure below
for DIP Switch settings]
Refer爐o爐able爄n爐he?/DIV>
Automatic燚IP燬witch?/DIV>
Configurations爏ection燵next?/DIV>
page]爁or爉ore爄nformation?/DIV>
regarding燾onfigurations?/DIV>
triggered燽y爐he燚IP燬witch.
DIP燬witch?/DIV>
Config
B01a.?/SPAN>
Power?/DIV>
Switch?/DIV>
B01b.?/SPAN>
LEDs?/DIV>
Serial燩ort?/DIV>
wer
B01c.?/SPAN>
B0d.?/SPAN>
B02a.牋
B02b.?/DIV>
燬witch?/DIV>
Po
?/DIV>
Connector?/DIV>
相关PDF资料 |
PDF描述 |
|---|---|
| XIB-R | BOARD INTERFACE RS232/485 |
| ZMN2400HPDB | BOARD ROUTER DEV ZIGBEE 100MW |
| ZMN24HPDK-B | KIT DEV W/ZIGBEE ZMN2400HP |
| ZNI1000TC | IC TEMP SENSOR NI1000 SOT23-3 |
| 02110102-000 | SNSR TILT RATIO 60DEG 500MA FLNG |
相关代理商/技术参数 |
参数描述 |
|---|---|
| XIB-R | 功能描述:界面模块 RS-232/485 interface 24XStream 9XCite RoHS:否 制造商:4D Systems 产品:Serial Converters 通道/端口数量: 数据速率: 接口类型:USB, UART 工作电源电压:3.3 V, 5 V 最大工作温度: |
| XIB-U | 功能描述:界面模块 USB interface board 24XStream 9XCite RoHS:否 制造商:4D Systems 产品:Serial Converters 通道/端口数量: 数据速率: 接口类型:USB, UART 工作电源电压:3.3 V, 5 V 最大工作温度: |
| XIC25040 | 制造商:XIC 功能描述:25040 24HR '6 |
| XILINXPWR-079 | 功能描述:电源管理IC开发工具 Pow Mgt Eval Mod for Xilinx FPGAs RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| XILINXPWR-080 | 功能描述:电源管理IC开发工具 Pow Mgt Eval Mod for Xilinx FPGAs RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
发布紧急采购，3分钟左右您将得到回复。