参数资料
| 型号： | XR16V798IQ-F |
| 厂商： | Exar Corporation |
| 文件页数： | 7/56页 |
| 文件大小： | 0K |
| 描述： | IC UART FIFO 64B OCTAL 100QFP |
| 标准包装： | 66 |
| 特点： | * |
| 通道数： | 8 |
| FIFO's： | 64 字节 |
| 规程： | RS485 |
| 电源电压： | 2.25 V ~ 3.6 V |
| 带自动流量控制功能： | 是 |
| 带IrDA 编码器/解码器： | 是 |
| 带故障启动位检测功能： | 是 |
| 带调制解调器控制功能： | 是 |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 100-BQFP |
| 供应商设备封装： | 100-QFP（14x20） |
| 包装： | 托盘 |
| 其它名称： | 1016-1647 XR16V798IQ-F-ND |
第1页第2页第3页第4页第5页第6页当前第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页
XR16V798
15
REV. 1.0.1
HIGH PERFORMANCE 2.25V TO 3.6V OCTAL UART WITH FRACTIONAL BAUD RATE
2.10
Auto RTS/DTR Hardware Flow Control Operation
Automatic RTS/DTR flow control is used to prevent data overrun to the local receiver FIFO. The RTS#/DTR#
output pin is used to request remote unit to suspend/resume data transmission. The flow control features are
individually selected to fit specific application requirement (see Figure 9):
Select RTS (and CTS) or DTR (and DSR) through MCR bit-2.
Enable auto RTS/DTR flow control using EFR bit-6.
The auto RTS or auto DTR function must be started by asserting the RTS# or DTR# output pin (MCR bit-1 or
bit-0 to a logic 1, respectively) after it is enabled.
If using programmable RX FIFO trigger levels, hysteresis levels can be selected via FCTR bits 3-0.
With the Auto RTS function enabled, the RTS# output pin will not be de-asserted (HIGH) when the receive
FIFO reaches the programmed trigger level, but will be de-asserted when the FIFO reaches the next trigger
level for Trigger Tables A-C (See Table 14). The RTS# output pin will be asserted (LOW) again after the FIFO
is unloaded to the next trigger level below the programmed trigger level.
For Trigger Table D (or programmable trigger levels), the RTS# output pin is de-asserted when the the RX
FIFO level reaches the RX trigger level plus the hysteresis level and is asserted when the RX FIFO level falls
below the RX trigger level minus the hysteresis level.
However, even under these conditions, the 798 will continue to accept data until the receive FIFO is full if the
remote UART transmitter continues to send data.
If used, enable RTS/DTR interrupt through IER bit-6 (after setting EFR bit-4). The UART issues an interrupt
when the RTS#/DTR# pin makes a transition: ISR bit-5 will be set to 1.
2.10.1
Auto CTS/DSR Flow Control
Automatic CTS/DSR flow control is used to prevent data overrun to the remote receiver FIFO. The CTS/DSR
pin is monitored to suspend/restart local transmitter. The flow control features are individually selected to fit
specific application requirement (see Figure 9):
Select CTS (and RTS) or DSR (and DTR) through MCR bit-2.
Enable auto CTS/DSR flow control using EFR bit-7.
With the Auto CTS or Auto DTR function enabled, the UART will suspend transmission as soon as the stop bit
of the character in the Transmit Shift Register has been shifted out. Transmission is resumed after the CTS#/
DTR# input is re-asserted (LOW), indicating more data may be sent.
If used, enable CTS/DSR interrupt through IER bit-7 (after setting EFR bit-4). The UART issues an interrupt
when the CTS#/DSR# pin makes a transition: ISR bit-5 will be set to a logic 1, and UART will suspend TX
transmissions as soon as the stop bit of the character in process is shifted out. Transmission is resumed
after the CTS#/DSR# input returns LOW, indicating more data may be sent.
相关PDF资料 |
PDF描述 |
|---|---|
| XR17C152IM-F | IC UART PCI BUS DUAL 100TQFP |
| XR17C154IV | IC UART PCI BUS QUAD 144LQFP |
| XR17C158IV-F | IC UART PCI BUS OCTAL 144LQFP |
| XR17D152CM-F | IC UART PCI BUS DUAL 100TQFP |
| XR17D154CV-F | IC UART PCI BUS QUAD 144LQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| XR16V798IQTR-F | 制造商:Exar Corporation 功能描述:UART 8-CH 64Byte FIFO 2.5V/3.3V 100-Pin PQFP T/R |
| XR-1790 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Audio Schematic |
| XR17C152 | 制造商:EXAR 制造商全称:EXAR 功能描述:5V PCI BUS DUAL UART |
| XR17C152CM | 制造商:EXAR 制造商全称:EXAR 功能描述:5V PCI BUS DUAL UART |
| XR17C152CM-0A-EVB | 功能描述:UART 接口集成电路 Supports C152 100 ld TQFP, PCI Interface RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。