参数资料
型号: XR17V252IM
厂商: Exar Corporation
文件页数: 11/69页
文件大小: 0K
描述: IC UART PCI BUS DUAL 100TQFP
产品变化通告: Leaded UART, V&I Obsolescence 11/Apr/2011
标准包装: 90
特点: *
通道数: 2,DUART
FIFO's: 64 字节
规程: RS485
电源电压: 3.3V,5V
带自动流量控制功能:
带IrDA 编码器/解码器:
带故障启动位检测功能:
带调制解调器控制功能:
安装类型: 表面贴装
封装/外壳: 100-TQFP
供应商设备封装: 100-TQFP(14x14)
包装: 托盘
XR17V252
19
REV. 1.0.2
66 MHZ PCI BUS DUAL UART WITH POWER MANAGEMENT SUPPORT
Timer Operation in Re-triggerable Mode:
In the re-triggerable mode, when the Timer is started, the Timer output will stay HIGH until it reaches half of the
terminal count N (= P clocks) and toggle LOW and stay LOW for a similar amount of time (Q clocks). The
above step will keep repeating until the Timer is stopped at which time the output will become HIGH (default
state). See Figure 7. Also, after the Timer is started, re-starting the Timer does not have any effect in re-
triggerable mode. The Timer must be programmed while it is stopped since the following operations are
blocked when the Timer is running:
Any write to TIMER MSB, LSB registers
Issue of any command other than ’Stop Timer’ and ’Reset Timer’ (’Start Timer’ is not allowed)
Routing the Timer Output to MPIO[0] Pin:
MPIO[0] pin is by default (on power up or reset, for example) an input. However, whenever the Timer output is
routed to MPIO[0] pin,
MPIO[0] will be automatically selected as an output
MPIO[0] will become HIGH (the default state of Timer output)
All MPIO control registers (MPIOLVL, MPIOSEL etc) lose control over MPIO[0] and get the control back
only when the Timer output is de-routed from MPIO[0].
Timer Interrupt
In the one-shot mode, the Timer will issue an interrupt upon timing out which is ’N’ clocks after the Timer is
started. In the re-triggerable mode, the Timer will keep issuing an interrupt every ’N’ clocks which is on every
rising edge of the Timer output. The Timer interrupt can be cleared by reading the TIMERCNTL register or
when a Timer Reset command is issued which brings the Timer back to its default settings. The TIMERCNTL
will read a value of 0x01 when the Timer interrupt is enabled and there is a pending interrupt. It reads a value
of 0x00 at all other times. Stopping the Timer does not clear the interrupt and neither does subsequent re-
starting.
FIGURE 7. TIMER OUTPUT IN ONE-SHOT AND RE-TRIGGERABLE MODES
TIMER Output in
Re-triggerable
Mode
TIMER Output in
One-Shot Mode
After 'P'
clocks
START TIMER
COMMAND ISSUED
START TIMER
COMMAND ISSUED
'N' Clocks
STOP TIMER
COMMAND ISSUED
START TIMER COMMANDS ISSUED: LESS THAN 'N'
CLOCKS BETWEEN SUCCESSIVE COMMANDS
< 'N' Clocks
After 'P'
clocks
After 'P'
clocks
After 'P'
clocks
After 'P'
clocks
After 'Q'
clocks
After 'Q'
clocks
After 'Q'
clocks
After 'Q'
clocks
< 'N' Clocks
相关PDF资料
PDF描述
XR17V254IV-F IC UART PCI BUS QUAD 144LQFP
XR17V258IV-F IC UART PCI BUS OCTAL 144LQFP
XR17V352IB113-F IC UART PCIE 256B DUAL 113FPBGA
XR17V354IB176-F IC UART PCIE 256B QUAD 176FPBGA
XR17V358IB176-F IC UART PCIE OCTAL 176FPBGA
相关代理商/技术参数
参数描述
XR17V252IM-0A-EVB 功能描述:UART 接口集成电路 Supports V252 100 ld TQFP, PCI Interface RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel
XR17V252IM-F 功能描述:UART 接口集成电路 66MHz Dual PCI UART RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel
XR17V252IMTR-F 制造商:Exar Corporation 功能描述:UART 2-CH 64Byte FIFO 3.3V 100-Pin TQFP T/R 制造商:Exar Corporation 功能描述:XR17V252IMTR-F
XR17V254 制造商:EXAR 制造商全称:EXAR 功能描述:66MHZ PCI BUS QUAD UART WITH POWER MANAGEMENT SUPPORT
XR17V254_08 制造商:EXAR 制造商全称:EXAR 功能描述:66MHZ PCI BUS QUAD UART WITH POWER MANAGEMENT SUPPORT