- 您现在的位置：买卖IC网 > PDF目录16531 > XR19L210IL40-0A-EB (Exar Corporation)EVAL BOARD FOR XR19L202 40QFN PDF资料下载
参数资料
| 型号： | XR19L210IL40-0A-EB |
| 厂商： | Exar Corporation |
| 文件页数： | 7/43页 |
| 文件大小： | 0K |
| 描述： | EVAL BOARD FOR XR19L202 40QFN |
| 标准包装： | 1 |
| 系列： | * |
第1页第2页第3页第4页第5页第6页当前第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页
XR19L210
15
REV. 1.0.2
SINGLE CHANNEL INTEGRATED UART AND RS-232 TRANSCEIVER
The L210 stops its crystal oscillator to conserve power in this mode. The user can check the XTAL2 pin for no
clock output as an indication that the device has entered the partial sleep mode.
The UART portion in the L210 resumes normal operation or active mode by any of the following:
■ a receive data start bit transition on the RXD input (LOW to HIGH)
■ a data byte is loaded to the transmitter, THR or FIFO
■ a change of logic state on any of the modem or general purpose serial inputs: i.e., any of the MSR bits 0-
3 shows a ’1’
The UART portion in the L210 will return to the sleep mode automatically after all interrupting conditions have
been serviced and cleared. If the UART portion of the L210 is awakened by the modem inputs, a read to the
MSR is required to reset the modem inputs. In any case, the sleep mode will not be entered while an interrupt
is pending. The UART portion of the L210 will stay in the sleep mode of operation until it is disabled by setting
IER bit-4 to a logic 0.
2.17.1.2
UART active, charge pump of RS-232 transceiver shut down
If the ACP pin is HIGH and the UART portion of the L210 is not in sleep mode, then the charge pump will
automatically shut down to conserve power if the following conditions are true:
■ no activity on the TXD output signal
■ modem input signals (RX, CTS) are LOW
■ modem inputs have been idle for approximately 30 seconds
When these conditions are satisfied, the L210 shuts down the charge pump and tri-states the RS-232 drivers
to conserve power. In this mode, the RS-232 receivers are fully active and the internal registers of the L210
can be accessed. The time for the charge pump to resume normal operation after exiting the sleep mode is
typically 45
s. It will wake up by any of the following:
■ a receive data start bit transition on the RXD input (LOW to HIGH)
■ a data byte is loaded to the transmitter, THR or FIFO
■ a LOW to HIGH transition on the CTS input
Because the receivers are fully active when the charge pump is turned off, any data received will be transferred
to/from the UART without any issues.
2.17.2
Full Sleep Mode
In full sleep mode, the UART will be in sleep mode and the charge pump of the RS-232 transceiver will be shut
down. The L210 enters the full sleep mode if the following conditions are satisfied:
■ the UART portion of the L210 is already in sleep mode (no output on XTAL2)
■ the ACP (Autosleep for Charge Pump) pin is HIGH
When these conditions are satisfied, both the UART and the RS-232 transceiver will be in the sleep mode. In
this mode, the RS-232 receivers are fully active and the internal registers of the L210 can be accessed. The
L210 exits the full sleep mode if either the ACP pin becomes LOW or the internal oscillator starts up. The time
for the charge pump to resume normal operation after exiting the full sleep mode is typically 45
s.
相关PDF资料 |
PDF描述 |
|---|---|
| VI-JTT-EZ-S | CONVERTER MOD DC/DC 6.5V 25W |
| 6374109-7 | C/A 62.5/125 1.6MM LC 0.34M |
| XR19L200IL32-0A-EB | EVAL BOARD FOR XR19L200 32QFN |
| 6374611-1 | C/A 2.0MM SM LC-SC 1M1 |
| RBC15DCST-S288 | CONN EDGECARD 30POS .100 EXTEND |
相关代理商/技术参数 |
参数描述 |
|---|---|
| XR19L210IL40-0B-EB | 功能描述:界面开发工具 Supports L210 40 pin QFN, PCI Interface RoHS:否 制造商:Bourns 产品:Evaluation Boards 类型:RS-485 工具用于评估:ADM3485E 接口类型:RS-485 工作电源电压:3.3 V |
| XR19L210IL40-F | 功能描述:UART 接口集成电路 UART RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel |
| XR19L212 | 制造商:EXAR 制造商全称:EXAR 功能描述:TWO CHANNEL INTEGRATED UART AND RS-232 TRANSCEIVER |
| XR19L212IL48 | 制造商:EXAR 制造商全称:EXAR 功能描述:TWO CHANNEL INTEGRATED UART AND RS-232 TRANSCEIVER |
| XR19L212IL48-0B-EB | 功能描述:界面开发工具 Supports L212 48 pin QFN, PCI Interface RoHS:否 制造商:Bourns 产品:Evaluation Boards 类型:RS-485 工具用于评估:ADM3485E 接口类型:RS-485 工作电源电压:3.3 V |
发布紧急采购，3分钟左右您将得到回复。