参数资料
| 型号： | XRT75R06DIB-F |
| 厂商： | Exar Corporation |
| 文件页数： | 79/105页 |
| 文件大小： | 0K |
| 描述： | IC LIU E3/DS3/STS-1 6CH 217BGA |
| 标准包装： | 126 |
| 类型： | 线路接口装置（LIU） |
| 驱动器/接收器数： | 6/6 |
| 规程： | DS3，E3，STS-1 |
| 电源电压： | 3.135 V ~ 3.465 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 217-BBGA |
| 供应商设备封装： | 217-BGA（23x23） |
| 包装： | 托盘 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页当前第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页
á
XRT75R06D
SIX CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCHRONIZER
REV. 1.0.0
70
What does this mean at the Destination PTE?
In this case, this DS3 signal (which has now been mapped into an STS-1 data-stream) will be transported
across the SONET network. As this STS-1 signal arrives at the "Destination" PTE, this PTE will extract (or de-
map) this DS3 data from each incoming STS-1 SPE. Now, in this case, most (e.g., 177/178.8) of the incoming
STS-1 SPEs will contain 5592 DS3 data-bits. Therefore, the nominal data rate of the DS3 signal being de-
mapped from SONET will be 44.736Mbps. However, in approximately 1 out of every 178 incoming STS-1
SPEs, the SPE will carry only 5591 DS3 data bits. This means that (during these times) the data rate of the de-
mapped DS3 signal will have an instantaneous frequency that is less than 44.736Mbps. These "excursions" of
the de-mapped DS3 data-rate, from the nominal DS3 frequency can be viewed as occurrences of mapping/de-
mapping jitter with an amplitude of approximately 1UI-pp.
Since this occurrence of "de-mapping" jitter is periodic and occurs once every 22.35ms, we can state that this
jitter has a frequency of 44.7Hz.
We talked about De-Mapping Jitter, What about De-Mapping Wander?
The Telcordia and Bellcore specifications define "Wander" as "Jitter with a frequency of less than 10Hz".
Based upon this definition, the DS3 signal (that is being transported by SONET) will cease to contain jitter and
will now contain "Wander", whenever the frequency offset of the DS3 signal being mapped into SONET is less
than 0.2ppm.
8.3
Jitter/Wander due to Pointer Adjustments
In the previous section, we described how a DS3 signal is asynchronously-mapped into SONET, and we also
defined "Mapping/De-mapping" jitter. In this section, we will describe how occurrences within the SONET
network will induce jitter/wander within the DS3 signal that is being transported across the SONET network.
In order to accomplish this, we will discuss the following topics in detail.
The concept of an STS-1 SPE pointer
The concept of Pointer Adjustments
The causes of Pointer Adjustments
How Pointer Adjustments induce jitter/wander within a DS3 signal being transported by that SONET network.
8.3.1
The Concept of an STS-1 SPE Pointer
As mentioned earlier, the STS-1 SPE is not aligned to the STS-1 frame boundaries and is permitted to "float"
within the Envelope Capacity.
As a consequence, the STS-1 SPE will often times "straddle" across two
FIGURE 49. AN ILLUSTRATION OF THE STS-1 SPE TRAFFIC THAT WILL BE GENERATED BY THE SOURCE PTE, WHEN
MAPPING A
DS3 SIGNAL THAT HAS A BIT RATE OF 44.736MBPS - 1PPM, INTO AN STS-1 SIGNAL
Source
PTE
Source
PTE
44.736Mbps - 1ppm
5592
DS3 Data
Bits
5592
DS3 Data
Bits
5592
DS3 Data
Bits
5592
DS3 Data
Bits
SPE # N
SPE # N+1
5592
DS3 Data
Bits
5592
DS3 Data
Bits
SPE # N+177
5591
DS3 Data
Bits
5591
DS3 Data
Bits
5592
DS3 Data
Bits
5592
DS3 Data
Bits
SPE # N+178
SPE # N+179
DS3 Data
Bit Excluded Here
STS-1 SPE Data Stream
相关PDF资料 |
PDF描述 |
|---|---|
| XRT75R06IB-F | IC LIU E3/DS3/STS-1 6CH 217BGA |
| XRT75R12DIB-L | IC LIU E3/DS3/STS-1 12CH 420TBGA |
| XRT75R12IB-L | IC LIU E3/DS3/STS-1 12CH 420TBGA |
| XRT75VL00DIV | IC LIU E3/DS3/STS-1 1CH 52TQFP |
| XRT75VL00IV-F | IC LIU E3/DS3/STS-1 1CH 52TQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| XRT75R06ES | 功能描述:时钟合成器/抖动清除器 6CH T3/E3/STS1LIU+JA 3.3V W/REDUNDANCY RoHS:否 制造商:Skyworks Solutions, Inc. 输出端数量: 输出电平: 最大输出频率: 输入电平: 最大输入频率:6.1 GHz 电源电压-最大:3.3 V 电源电压-最小:2.7 V 封装 / 箱体:TSSOP-28 封装:Reel |
| XRT75R06IB | 功能描述:外围驱动器与原件 - PCI 6CH E3/DS3/STS1 LIU+Jitter Attenuato RoHS:否 制造商:PLX Technology 工作电源电压: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:FCBGA-1156 封装:Tray |
| XRT75R06IB208 | 制造商:Exar Corporation 功能描述:Line Interface Unit 51.84Mbps DS3/E3/STS-1 Parallel 217-Pin BGA |
| XRT75R06IB-F | 功能描述:外围驱动器与原件 - PCI 6 Channel 3.3V-5V temp -45 to 85C RoHS:否 制造商:PLX Technology 工作电源电压: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:FCBGA-1156 封装:Tray |
| XRT75R12 | 制造商:EXAR 制造商全称:EXAR 功能描述:TWELVE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER |
发布紧急采购，3分钟左右您将得到回复。