参数资料
| 型号： | XRT82D20IW-F |
| 厂商： | Exar Corporation |
| 文件页数： | 17/27页 |
| 文件大小： | 0K |
| 描述： | IC LIU E1 SGL 28SOJ |
| 标准包装： | 27 |
| 类型： | 线路接口装置（LIU） |
| 驱动器/接收器数： | 1/1 |
| 规程： | E1 |
| 电源电压： | 3.135 V ~ 3.465 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-BSOJ |
| 供应商设备封装： | 28-SOJ |
| 包装： | 管件 |
| 其它名称： | 1016-1359-5 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页当前第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页
XRT82D20
23
SINGLE CHANNEL E1 LINE INTERFACE UNIT
REV. 1.0.8
2.0
DIAGNOSTIC FEATURES
In order to support diagnostic operations, the XRT82D20 supports the following loop-back modes:
Local Loopback
Remote Loopback
Digital Loopback
Each of these loop-back modes will be discussed below.
2.1
The Local Loop-Back Mode
When the XRT82D20 is configured to operate in the Local Loop-Back Mode, the XRT82D20 will ignore any
signals that are input to the RTIP and RRing input pins. The Transmitting Terminal Equipment will transmit
data into the XRT82D20 via the TPOS, TNEG and TClk input pins. This data will be processed through the
Transmit Terminal Input Interface and the Pulse Shaping circuit. Finally, this data will be output to the line via
the TTIP and TRing output pins. Additionally, this data (which is being output via the TTIP and TRing output
pins) will be looped back into the Receiver block. As a consequence, this data will also be processed through
the entire Receive Section of the XRT82D20. After this post-loop-back data has been processed through the
Receive Section it will output, to the Near-End Receiving Terminal Equipment via the RPOS and RNEG output
pins.
Figure 18, illustrates the path that the data takes (within the XRT82D20), when the chip is configured to
operate in the Local Loop-Back Mode.
The user can configure the XRT82D20 to operate in the Local Loop-Back Mode, by pulling the LLoop input pin
(pin 9) to GND.
FIGURE 18. ILLUSTRATION OF THE ANALOG LOCAL LOOP-BACK WITHIN THE XRT82D20
HDB3
Encoder
Peak
Detector
Local
Loopback
LOS
Detect
Data
Slicer
Data &
Timing
Recovery
HDB3
Decoder
Tx Pulse
Shaper
MUX
Line
Driver
TClk
TPOS
TNEG
RClk
RPOS
RNEG
TTIP
TRing
RLOS
RTIP
RRing
MClk
Timing
Generator
Jitter Attenuator
相关PDF资料 |
PDF描述 |
|---|---|
| XRT82L24AIV-F | IC LIU E1 QAUD 100TQFP |
| XRT83D10IW | IC LIU T1/E1 SGL 28SOJ |
| XRT83L30IV-F | IC LIU LH/SH T1/E1 SGL 64TQFP |
| XRT83L314IB-L | IC LIU T1/E1/J1 14CH 304TBGA |
| XRT83L34IV-F | IC LIU T1/E1/J1 QUAD 128TQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| XRT82D20IW-F | 制造商:Exar Corporation 功能描述:T1/E1 LIU IC |
| XRT82D20IWTR | 功能描述:外围驱动器与原件 - PCI Single Ch E1 LIU RoHS:否 制造商:PLX Technology 工作电源电压: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:FCBGA-1156 封装:Tray |
| XRT82D20IWTR-F | 功能描述:外围驱动器与原件 - PCI Single Ch E1 LIU RoHS:否 制造商:PLX Technology 工作电源电压: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:FCBGA-1156 封装:Tray |
| XRT82L24 | 制造商:EXAR 制造商全称:EXAR 功能描述:QUAD E1 LINE TRANSCEIVER WITH CLOCK RECOVERY AND JITTER ATTENUATOR |
| XRT82L24A | 制造商:EXAR 制造商全称:EXAR 功能描述:QUAD E1 LINE TRANSCEIVER WITH CLOCK RECOVERY AND JITTER ATTENUATOR |
发布紧急采购，3分钟左右您将得到回复。