- 您现在的位置：买卖IC网 > PDF目录48099 > YEV09T06-0 (POWER-ONE INC) 1-OUTPUT DC-DC REG PWR SUPPLY MODULE PDF资料下载
参数资料
| 型号： | YEV09T06-0 |
| 厂商： | POWER-ONE INC |
| 元件分类： | 电源模块 |
| 英文描述： | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| 封装： | ROHS COMPLIANT, SIP-5 |
| 文件页数： | 12/12页 |
| 文件大小： | 300K |
| 代理商： | YEV09T06-0 |
YEV09T06 6A DC-DC POL Converter
4.5V to 13.8V Input 0.59V to 5.1V Output
Data Sheet
ZD-02094 Rev 1.1, 25-Mar-09
www.power-one.com
Page 9 of 12
6.4
Protections
6.4.1
Input Undervoltage Lockout
The POL converter will shut down when the input
voltage drops below a predetermined voltage. It will
start automatically when the input voltage exceeds
the specified threshold.
6.4.2
Output Overcurrent Protection
The POL converter is protected against overcurrent
and short circuit conditions.
Upon sensing an
overcurrent condition, the POL converter will enter
hiccup mode of operation. Once the overload or
short circuit condition is removed, the POL converter
will automatically restart and Vout will return to its
nominal value.
6.4.3
Output Overvoltage Protection
The POL converter is protected against overvoltage
on the output. If the output voltage is higher than
115% of its nominal value set by the RTRIM, the high
side MOSFET will be immediately turned off and the
low side MOSFET will be turned on.
The POL
converter will remain in the state until the output
voltage reduces below 115% of its nominal value. At
that point the POL converter will automatically
restart.
7.
Characterization
7.1
Ripple and Noise
The output voltage ripple and input reflected ripple
current waveforms are measured using the test
setup shown in Figure 16.
Figure 16. Test Setup For Measuring Input Reflected-Ripple
Current And Output Voltage Ripple
8.
Safety
The YEV09T06 POL converters do not provide
isolation from input to output. The input devices
powering YEV09T06 must provide relevant isolation
requirements according to all IEC60950 based
standards. Nevertheless, if the system using the
converter needs to receive safety agency approval,
certain rules must be followed in the design of the
system.
In particular, all of the creepage and
clearance requirements of the end-use safety
requirements
must
be
observed.
These
requirements are included in UL60950 - CSA60950-
00 and EN60950, although specific applications may
have other or additional requirements.
The YEV09T06 POL converters have no internal
fuse.
If required, the external fuse needs to be
provided to protect the converter from catastrophic
failure. Refer to the “Input Fuse Selection for DC/DC
converters” application note on www.power-one.com
for proper selection of the input fuse. Both input
traces and the chassis ground trace (if applicable)
must be capable of conducting a current of 1.5 times
the value of the fuse without opening.
To comply with safety agencies’ requirements, a
recognized fuse must be used in series with the input
line. The fuse must not be placed in the grounded
input line. Abnormal and component failure tests
were conducted with the POL input protected by a
fast-acting 20A fuse. If a fuse rated greater than 20A
is used, additional testing may be required.
The maximum DC voltage between any two pins is
Vin under all operating conditions. In order for the
output of the YEV09T06 POL converter to be
considered as SELV (Safety Extra Low Voltage),
according to all IEC60950 based standards, the input
to the POL needs to be supplied by an isolated
secondary source providing a SELV also.
Vout
V source
22
F
ceramic
capacitor
1H
DC/DC
Converter
100 F
tantalum
+2x10F
ceramic
CIN
YEV09T06
相关PDF资料 |
PDF描述 |
|---|---|
| YEV09T06-RG | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| YEV09T06-R | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| YEV09T10-01 | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| YEV09T10-01G | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| YEV09T10-R | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| YEV09T06-0G | 功能描述:DC/DC转换器 0.59-5.1Vout 6A 4.5-13.8VIn RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸: |
| YEV09T06-R | 制造商:POWER-ONE 制造商全称:Power-One 功能描述:6A DC-DC POL Converter 4.5V to 13.8V Input 0.59V to 5.1V Output |
| YEV09T06-RG | 制造商:Power-One 功能描述:- Bulk |
| YEV09T06-RGA | 制造商:Power-One 功能描述: |
| YEV09T10 | 制造商:POWER-ONE 制造商全称:Power-One 功能描述:10A DC-DC POL Converter 4.5V to 13.8V Input 0.59V to 5.1V Output |
发布紧急采购，3分钟左右您将得到回复。