参数资料
| 型号： | YS05S16-DG |
| 厂商： | Power-One |
| 文件页数： | 6/25页 |
| 文件大小： | 0K |
| 描述： | CONVERT DC/DC 58W SMD |
| 标准包装： | 310 |
| 系列： | * |
YS05S16 DC-DC Converter Data Sheet
3.0-5.5 VDC Input; 0.7525-3.63 VDC Programmable @ 16 A
The ON/OFF pin is internally pulled up to Vin for
positive logic version, and pulled down for a negative
logic version. A TTL or CMOS logic gate, open-
collector (open-drain) transistor can be used to drive
ON/OFF pin. This device must be capable of:
– sinking up to 1.2 mA at a low level voltage of
? 0.8 V
– sourcing up to 0.25 mA at a high logic level of
2.3 V - 5.5 V.
When using open-collector (open-drain) transistor
with a negative logic option, add a pull-up resistor
(R*) to Vin as shown in Fig. C:
– 20 K, if the minimum Vin is 4.5 V
– 10 K, if the minimum Vin is 3.0 V
– 5 K, if the undervoltage shutdown at 2.05 - 2.15 V
is required.
Remote Sense (Pin 2)
The remote sense feature of the converter
compensates for voltage drops occurring only
equal to the product of the nominal output voltage
and the allowable output current for the given
conditions.
When using remote sense, the output voltage at the
converter can be increased up to 0.5 V above the
nominal rating in order to maintain the required
voltage across the load. Therefore, the designer
must, if necessary, decrease the maximum current
(originally obtained from the derating curves) by the
same percentage to ensure the converter’s actual
output power remains at or below the maximum
allowable output power.
Output Voltage Programming (Pin 3)
The output voltage can be programmed from
0.7525 V to 3.63 V by connecting an external resistor
between TRIM pin (Pin 3) and GND pin (Pin 5); see
Fig. E. Note that when a trim resistor is not
connected, the output voltage of the converter is
0.7525 V.
between Vout pin (Pin 4) of the converter and the
load. The SENSE (Pin 2) pin should be connected at
Vin
Y-Series
Converter
SENSE
the load or at the point where regulation is required
(see Fig. D). There is no sense feature on the output
GND return pin, where the solid ground plane should
provide a low voltage drop.
Vin
ON/OFF
GND
(Top View)
Vout
TRIM
Rload
R TRIM
Vin
Y-Series
Converter
SENSE
Vin
ON/OFF
(Top View)
Vout
Rw
Rload
Fig. E: Configuration for programming output voltage.
A trim resistor, R TRIM , for a desired output voltage
can be calculated using the following equation:
GND
TRIM
Rw
R T RIM ?
21 . 07
(V O - REQ - 0.7525)
? 5 . 11
[k ? ]
Fig. D: Remote sense circuit configuration.
If remote sensing is not required, the SENSE pin
must be connected to the Vout pin (Pin 4) to ensure
the converter will regulate at the specified output
voltage. If these connections are not made, the
converter will deliver an output voltage that is slightly
higher than the specified value.
Because the sense lead carries minimal current,
large trace on the end-user board are not required.
However, sense trace should be located close to a
ground plane to minimize system noise and ensure
optimum performance.
When utilizing the remote sense feature, care must
be taken not to exceed the maximum allowable
output power capability of the converter, which is
where,
R TRIM ? Required value of trim resistor [k ? ]
V O ? REQ ? Desired (trimmed) output voltage [V]
Note that the tolerance of a trim resistor directly
affects the output voltage tolerance. It is
recommended to use standard 1% or 0.5% resistors;
for tighter tolerance, two resistors in parallel are
recommended rather than one standard value from
Table 1.
Ground pin of the trim resistor should be connected
directly to the converter GND pin (Pin 5) with no
voltage drop in between. Table 1 provides the trim
resistor values for popular output voltages.
MCD10205 Rev. 1.0, 24-Jun-10
Page 6 of 25
www.power-one.com
相关PDF资料 |
PDF描述 |
|---|---|
| 74VHCT08AMTC | IC GATE AND QUAD 2INPUT 14TSSOP |
| 74HCT4060N,652 | IC 14STAGE BINARY RIPPLE 16DIP |
| 74HCT193N,652 | IC COUNTER UP/DOWN SYNC 16-DIP |
| 74HCT160N,652 | IC SYNC BCD DECADE COUNT 16-DIP |
| 74HC4024D,653 | IC 7STAGE BINARY RIPPLE 14SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| YS-1 | 制造商:Taiyo Electric Ind. 功能描述: |
| YS10 | 制造商:Norma Products Midlands 功能描述:10MM ID HOSE Y CONNECTOR |
| YS-100 | 制造商:Taiyo Electric Ind. 功能描述: |
| YS10-01B-S | 制造商:Klixon 功能描述:THERMAL PROTECTOR |
| YS1005A | 制造商:Cosel Usa Inc 功能描述:Power Supply;AC-DC;5V@2A;85-132V In;Enclosed;Thru Hole;Switching;YS Series 制造商:Cosel Usa Inc 功能描述:AC/DC Power Supply Single-OUT 5V 2A 10W 5-Pin Bulk |
发布紧急采购，3分钟左右您将得到回复。