- 您现在的位置：买卖IC网 > Datasheet目录537 > ZALM-301-1C-B (CEL)RF TRANSCEIVER 100MW MMCX W/CONN Datasheet资料下载
参数资料
| 型号： | ZALM-301-1C-B |
| 厂商： | CEL |
| 文件页数： | 8/19页 |
| 文件大小： | 0K |
| 描述： | RF TRANSCEIVER 100MW MMCX W/CONN |
| 标准包装： | 32 |
| 系列： | Apex |
| 频率： | 2.4GHz |
| 数据传输率 - 最大： | 250kbps |
| 调制或协议： | 802.15.4 Zigbee |
| 应用： | AMR，ISM，ZigBee? |
| 功率 - 输出： | 100mW（20dBm） |
| 灵敏度： | -96dBm |
| 电源电压： | 2.1 V ~ 3.6 V |
| 电流 - 接收： | 37mA |
| 电流 - 传输： | 170mA |
| 数据接口： | * |
| 天线连接器： | * |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 模块 |
| 包装： | 托盘 |
ZALM-300 Series
POWER AMPLIFIER REGULATOR CONTROL LINE
The APEX LT module includes a separate 1.8V regulator for a power amplifier bias that enables consistent module out -
put performance over the wide 2.1 – 3. 6 V voltage range. To prevent excessive sleep currents, this regulator should be
disabled when the module is in sleep mode. An external pull up resistor option is provided on each module (R6) that allows
the regulator to be constantly enabled. This option increases the sleep current of the module to a point well above the
specified values.
SPECIFICATIONS — VPA_EN (APEX LT)
Parameter
Min
Typ
Max
Unit
Regulator enable voltage
Regulator disable voltage
Enable line current (VEN = 0)
Enable line current (VEN = V DD )
Turn on Time
0.95
0.4
0.1
10
250
V
V
μA
μA
μsec
On the APEX LT module the VPA_EN control must be provided by the host microprocessor. In normal operation, the VPA_
EN line must be set high. It must be set low when the module is put into sleep mode in conjunction with putting the EM260
into deep sleep. Upon module wake-up, a 250 μsec turn-on time must be provided prior to any transmission, allowing the
module’s regulator to settle. Note that this 250μsec requirement applies only to the external power amplifier, the wake-up
time for the EM260 is separate from this value.
If the application does not put the module to sleep or if sleep current is not an issue, the power amplifier regulator may
be permanently enabled by tying the control line high. In this setup, the sleep current will increase by 80 μA over the 5μA
Standby Current figure provided in Electrical Specifications.
SIF INTERFACE
The APEX LT module provide access to the SIF module programming and debug interface.
Consult the EM260 datasheet for further details on the following SIF features:
? Production Testing
? Firmware Download
? Product Control and Characterization
HOST PROTOCOL INTERFACE COMMANDS
For information on Host Protocol Interface Commands and for other software-related documents refer to Ember ’s website:
http://www.ember.com/products_documentation.html
相关PDF资料 |
PDF描述 |
|---|---|
| ZCH-101-J | LED LIGHT BAR STRIP WIRE HARNESS |
| ZCH-200-J | LED LIGHT BAR STRIP WIRE HARNESS |
| ZFSM-101-KIT-1 | KIT DEVELOPMENT FOR FREESTAR |
| ZIC2410USB-WNA-1 | MODULE 802.15.4 ZIGBEE |
| ZICM0900P2-1C | MESHCONNECT MODULE 1/4 WAVE WIRE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ZALVB1 | 制造商:Schneider Electric 功能描述:CONT. BOX LIGHT UNITE, ZALVB1 制造商:Schneider Electric 功能描述:White Light Block For Head 22 Integral LED 24V |
| ZALVB3 | 制造商:Schneider Electric 功能描述:LIGHT MODULE W/PROTECTED LED 24V GREEN 制造商:Schneider Electric 功能描述:Green LED pilot light,24Vdc 制造商:SCHNEIDER ELECTRIC 功能描述:Switch Access Light Block |
| ZALVB4 | 制造商:Schneider Electric 功能描述:LIGHT MODULE W/PROTECTED LED 24V RED 制造商:Schneider Electric 功能描述:Red LED pilot light,24Vdc 制造商:SCHNEIDER ELECTRIC 功能描述:RED LIGHT BLOCK |
| ZALVB5 | 制造商:Schneider Electric 功能描述:LIGHT MODULE W/PROTECTED LED 24V YELLOW 制造商:Schneider Electric 功能描述:Yellow LED pilot light,24Vdc 制造商:SCHNEIDER ELECTRIC 功能描述:ORANGE LIGHT BLOCK |
| ZALVB6 | 制造商:Schneider Electric 功能描述:LIGHT MODULE W/PROTECTED LED 24V BLUE 制造商:Schneider Electric 功能描述:24V LED CONT. BOX LIGHT U 制造商:SCHNEIDER ELECTRIC 功能描述:Switch Access Light Block 制造商:SCHNEIDER ELECTRIC 功能描述:Blue Light Block For Head 22 Integral LED 24V |
发布紧急采购，3分钟左右您将得到回复。